FLOE CANOPY BIRD DETERRENCE KIT

ASSEMBLY INSTRUCTIONSKIT P/N 511-00800-00

TOOLS REQUIRED- TORQUE WRENCH

- 3/4 SOCKET OR WRENCH

SHEET 1 OF 4

Floe International, Inc.

48473 State Hwy. 65

McGregor, MN 55760

All rights reserved

c

INSTRUCTION P/N 611-00800-00

ISSUED: 3/22/17

DETAIL B

SCALE 1 / 10

B

DESCRIPTIONPART NUMBERQTYITEM

HHCS, 1/2-13 SS001-70207-0041

NUT, NYLOCK 1/2-13 ALUM.001-76072-0042

LINE, BIRD DETERRENCE011-00001-0013

ASS'Y, MAST BIRD DETERRENCE111-00124-0044

FLOE CANOPY BIRD DETERRENCE KIT

EXPLODED VIEW AND BOMKIT P/N 511-00800-00

SHEET 2 OF 4

4

3

1

2

STEP 1- PEEL BACK THE BOTTOM OF THE VINYL CANOPY RAIL

CAP FAR ENOUGH TO INSERT A 1/2 X 1 1/4" BOLT INTO

THE NUT TRACK OF THE CANOPY RAIL.

- PLACE THE MAST ASSEMBLY OVER THE BOLT AS SHOWN IN

FIGURE 1 KEEPING THE ANGLE ON THE WELDMENT

APPROXIMATELY 2" FROM THE END OF THE CANOPY

RAIL. NOTE THERE SHOULD BE 2 - 3" OF OPEN AREA

BETWEEN THE MAST UPRIGHT AND THE CANOPY HOOP. THIS

INSURES ROOM FOR THE CANOPY FABRIC. THREAD ON THE

1/2" ALUMINUM NYLOCK NUT AND TORQUE TO 25 FT/LBS.

REPEAT THREE MORE TIMES.

SHEET 3 OF 4

FIG. 1

1/2" ALUMINUMNYLOCK NUT

1/2 X 1 1/4" STAINLESS STEELHEX HEAD BOLT

VINYL CANOPYRAIL CAP

MAST ASSEMBLY

SHEET 4 OF 4

STARTHERE

(1)

(2)(3)

(4)

(5)

(6) (7)

TIE SECURELY(8)

STEP 2- STARTING AT POSITION 1, THREAD THE LOOSE END OF THE LINE THROUGH THE EYEBOLT WORKING THROUGH THE NUMBERED SEQUENCE

INDICATED BELOW. ONCE LACED THROUGH ALL THE EYEBOLTS TIE THE LINE TO THE EYE BOLT AT POSITION # 8. NOTE: THE LINE WILL BE STRUNG

TWICE FROM POSTION #2 TO #3 AND FROM POSTION #6 TO #7. WORKING BACKWARDS FROM EYE BOLT TO EYE BOLT BACK TO THE SPOOL,

SNUG THE LINE. TIE OFF THE LINE SECURELY AT POSTION #1.