Fiat bogie

20
PRESENTATION ON FIAT BOGIE

description

Presentation on fabrication and function of Fiat bogies used in worldwide Locomotive...:):)

Transcript of Fiat bogie

Page 1: Fiat bogie

PRESENTATION ON

FIAT BOGIE

Page 2: Fiat bogie

BOGIE GENERAL ARRANGEMENT

Page 3: Fiat bogie
Page 4: Fiat bogie

DESIGN FEATURES:

Page 5: Fiat bogie

Principles of force transmission

Vertical forces: from the body to the

bogie frame through the secondary suspension springs; from the bogie frame to the axles through the primary suspension springs and frame - axle bearing control arm.

Page 6: Fiat bogie

Lateral forces:from the body to

the bogie frame through the secondary suspension springs; from the bogie frame to the axles through the elastic elements of the frame - axle bearing control arm.

Page 7: Fiat bogie

Longitudinal traction efforts and braking powers:from the body to

bogie frame through the traction centre rods and the traction lever; from the bogie frame to the axles through the frame - axle bearing control arm.

Page 8: Fiat bogie

Curve negotiation:An articulated control arm is connecting

axle bearing and side frame through elastic connection, which will provide flexibility between axle and side frame.

Page 9: Fiat bogie

Wheel diameterNew wheel dia 915mmworn wheel dia 845mm

Page 10: Fiat bogie

Suspension elements:

Primary suspension consists of nested inner and outer springs, dampers, top rubber pad

secondary suspension consists of nested flexi-coils springs (inner and outer springs),rubber spring, vertical dampers, lateral dampers, anti-roll bars, anchor links.

Secondary rubber pad is inserted below and above secondary springs provides flexible ends of springs.

Page 11: Fiat bogie

Speed limitUpto 160KMPH without any modificationupto 200KMPH with minor modification

Page 12: Fiat bogie

FIAT BOGIE

SUB-SYSTEMS

Page 13: Fiat bogie

On the bogie each axle is fitted with two brake disks (4), diameter 640 mm and width 110 mm.

In built slack adjusting facilities in brake cylinder fitted.

Two wheel disc of tread dia 915 (New), 845 (worn).

Wheel and Axles

Page 14: Fiat bogie

A taper roller cartridge type bearing is used.

It is a pre-assembled unit not required any further intervention, such as clearance adjustments.

The axle bearings on the bogie are fitted with sensors for detecting speed

Axle bearings

Page 15: Fiat bogie

BOGIE FRAME The bogie frame is a solid welded frame made by

steel sheets and forged or cast parts.The frame is made up of two longitudinal components connected by two cross-beams (2) which also support the brake units.The various supports which connect the different bogie components are welded to theframe.

The bogie frame rests on the primary suspension spring units and supports the vehicle body by means of a bolster beam. The bolster beam is connected to the bogie frame by secondary suspension.

Page 16: Fiat bogie

BOGIE FRAME

Page 17: Fiat bogie

Primary suspensionConsisting of two coil springs, one vertical

damper, An articulated control arm fitted with twin-layer elastic joints connecting the axle bearing to the bogie frame

for curve negotiation.

Page 18: Fiat bogie

SECONDARY SUSPENSION

CONSISTSNEST OF FLEXI-COIL SPRINGS INNER AND

OUTER, RUBBER SPRINGVERTICAL DAMPERSLATERAL DAMPERSYAW DAMPERSANTI-ROLL BARANCHOR LINKS

Page 19: Fiat bogie

SECONDARY SUSPENSION

Page 20: Fiat bogie

DISC BRAKE SYSTEM

AXLE MOUNTED DISC BRAKE

TWO DISCS PER AXLE OF DIA640

INBUILT SLACK ADJUSTER IN BRAKE CYLINDERS

35mm BRAKE PADS