Extrusion Simulation Services
2
Click here to load reader
-
Upload
olivier-rey -
Category
Engineering
-
view
292 -
download
0
Transcript of Extrusion Simulation Services
Simulation Services imulator
MTD SA, Route de Muraz 16, CH 3960 Sierre, Switzerland
Phone : +41 79 658 16 22 mail : [email protected] www.m-td.com
Who we are
M-TD is a Swiss company, which provides top-of-the range solutions for the extruders, expert advice, full
conceptions, and fabricated dies as well as services in numerical simulation of manufacturing processes.
Our expertise and activity: Productivity improvements and cost reduction: technology expertise and continuous improvement for
extrusion process, die conception and fabrication
Die conception and optimization
Training: die design, extrusion process & correction, numerical simulation
Software development: Extrusion simulation, bearings calculation, profile heating & cooling optimization
What you need
You meet problems with a die?
You meet problems with profile quality?
You want to improve extrusion performance?
We use our expertise in dies design and extrusion, and our simulation software to help you to find
the good solution.
What we do
From your die design, extrusion parameter and other information, we realize a 3D extrusion simulation:
Flow speed of alloy material
Pressure of alloy material
Temperature of alloy material and die
Stress and deformation of die
We analyze the results and give to you a report concerning:
Flow balance into the die
Profile speed on exit (control of bearing length and pocket)
quality of seams weld in welding chamber
die stresses (to predict or confirm risk of breakage)
die deflection (to predict or adjust cold profile)
On demand we can give:
Advices on modification to apply
Design for you an optimized die design
Our offers
We offer different packages depending on your possibilities and your needs:
As we make a 3D simulation we need a 3D model of the die. If you haven’t it we design it for you
You just need the analysis of your project or you want an optimized version (in this case we make a new simulation for validation of modifications)
Simulation Services
MTD SA, Route de Muraz 16, CH 3960 Sierre, Switzerland
Phone : +41 79 658 16 22 mail : [email protected] www.m-td.com
Package 1: simple simulation based on 3D die’s model
You send to us:
3D model (STEP format)
Press parameters
Additional information
We do:
3D model preparation for simulation
Extrusion simulation
Analysis of results
You receive:
Analysis report Advices on modification to apply
Package 2: simple simulation based on 2D drawing of the die
You send to us:
2D drawing (DXF, DWG or IGES format)
Press parameters
Additional information
We do:
3D model of the die
3D model preparation for simulation
Extrusion simulation
Analysis of results
You receive:
3D model of the die
Analysis report
Advices on modification to apply
Package 3: simulation and die optimization based on 3D die’s model
You send to us:
3D model (STEP format)
Press parameters
Additional information
We do:
3D model preparation for simulation
Extrusion simulation
Analysis of results
Apply modifications on 3D model
Extrusion simulation for validation
You receive:
Analysis report
Report of modification applied
3D model, ready to be manufactured
Package 4: simulation and die optimization based on2D drawing of the die
You send to us:
2D drawing (DXF, DWG or IGES format)
Press parameters
Additional information
We do:
3D model of the die
3D model preparation for simulation
Extrusion simulation
Analysis of results
Apply modifications on 3D model
Extrusion simulation for validation
You receive:
Analysis report
Report of modification applied
3D model, ready to be manufactured
