Release Notes

EtherNet/IP TapCatalog Number 1783-ETAP, 1783-ETAP1F, 1783-ETAP2F

About This PublicationThese release notes provide software compatibility requirements, enhancements, and other usage considerations for the 1783-ETAP, 1783-ETAP1F, and 1783-ETAP2F EtherNet/IP taps, firmware revision 2.002.

Before You BeginThis update is recommended for all 1783-ETAP1F and 1783-ETAP2F taps. This update is optional for 1783-ETAP taps.

Topic Page

About This Publication 1

Before You Begin 1

Enhancements 2

Known Anomalies 3

Install the Firmware Revision 3

Additional Resources 4

IMPORTANT If you are upgrading a 1783-ETAP tap from firmware revision 1.001 and haven't already done so, you will need to update RSLogix and RSLinx Classic software to the versions listed in the following table to access your tap from those applications after the firmware update.

2 EtherNet/IP Tap

EnhancementsThis firmware revision contains these enhancements.

Software Compatible Version

RSLogix 5000 17.01 or later; Add-on Profile (AOP) version 2.4.1 or later

RSLinx Classic 2.56 or later

ControlFlash 6.0 or later

Revision Adds support for

2.002 1783-ETAP1F and 1783-ETAP2F: Modules continue operating if one core of the fiber link is lostLgx00112824

2.001 1783-ETAP Web serverLgx00096435

Ring supervisor is enabled with DIP switch 3Lgx00096437

Turning off the LNK 2 status indicator if a Partial Fault condition is detected

The tap prevents last active port from being disabledLgx00105779

1783-ETAP1F and 1783-ETAP2F: Initial release

1.001 1783-ETAP: Initial release. Compatible with: RSLogix 5000 software, version 17.01, AOP version 1.x RSLinx Classic software, version 2.55

Rockwell Automation Publication 1783-RN001B-EN-P - September 2010

EtherNet/IP Tap 3

Known AnomaliesThis firmware revision contains these known anomalies.

Install the Firmware RevisionLocate the appropriate firmware and copy all of the files to a temporary subdirectory on your hard disk drive.

Firmware files are available on the RSLogix 5000 software CD.

Use the ControlFlash utility that ships with RSLogix 5000 programming software.

You can also download the firmware files from http://www.rockwellautomation.com/support.

Revision Anomaly

2.002 No support for use of two 1783-ETAP modules for redundant gateways between ring topology and networkLgx111170

MSG instruction supports a maximum of 49 ring nodesLgx00103809

Rockwell Automation Publication 1783-RN001B-EN-P - September 2010

http://www.rockwellautomation.com/supporthttp://www.rockwellautomation.com/support

Additional ResourcesThese documents contain additional information concerning related Rockwell Automation products.

You can view or download publications at http://www.rockwellautomation.com/literature. To order paper copies of technical documentation, contact your local Rockwell Automation distributor or sales representative.

Resource Description

EtherNet/IP Tap Installation Instructions, publication 1783-IN007

Provides general guidelines for installing an EtherNet/IP tap.

EtherNet/IP Industrial Protocol White Paper, publication ENET-WP001

Describes how to implement services and data objects on a TCP/UDP/IP based Ethernet network.

Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1

Provides general guidelines for installing a Rockwell Automation industrial system.

Product Certifications website, http://www.ab.com

Provides declarations of conformity, certificates, and other certification details.

EtherNet/IP Embedded Switch Technology Application Guide, publication ENET-AP005

Provides information about using products with embedded switch technology to construct networks with linear and ring topologies.

Publication 1783-RN001B-EN-P - September 2010 PN-89243Supersedes Publication 1783-RN001A-EN-P - December 2009 Copyright 2010 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.

Allen-Bradley, Rockwell Software, Rockwell Automation, and TechConnect are trademarks of Rockwell Automation, Inc.

Trademarks not belonging to Rockwell Automation are property of their respective companies.

Rockwell Otomasyon Ticaret A.., Kar Plaza Merkezi E Blok Kat:6 34752 erenky, stanbul, Tel: +90 (216) 5698400

http://literature.rockwellautomation.com/idc/groups/literature/documents/in/1783-in007_-en-p.pdfhttp://literature.rockwellautomation.com/idc/groups/literature/documents/in/1783-in007_-en-p.pdfhttp://literature.rockwellautomation.com/idc/groups/literature/documents/wp/enet-wp001_-en-p.pdfhttp://www.literature.rockwellautomation.com/idc/groups/literature/documents/in/1770-in041_-en-p.pdfhttp://ab.comhttp://literature.rockwellautomation.com/idc/groups/literature/documents/ap/enet-ap005_-en-p.pdfhttp://www.rockwellautomation.com/literature1783-RN001C-EN-P, EtherNet/IP Tap Release NotesAbout This PublicationBefore You BeginEnhancementsKnown AnomaliesInstall the Firmware RevisionAdditional ResourcesBack CoverPrint Spec SheetJIT Printing SpecificationsRA-QR005F-EN-P - 8/07/2009Printing SpecificationYOUR DATA HEREInstructionsNO(required) Category:JIT / PODSelect Print Category A,B,C or D from category list, on "Introduction_Catagory Types" tab11 x 17LOOSE -Loose LeafYESPre-sale / MarketingTOP(required) Finished Trim Size Width:4.75 x 7 (slightly smaller half-size)8.5 x 11PERFECT - Perfect BoundA1LEFT(required) Publication Number :1783-RN001A-EN-PSample: 2030-SP001B-EN-P3 x 5SADDLE - Saddle StitchA2RIGHTCORNERUse Legacy NumberNOYES or NO18 x 24 PosterPLASTCOIL - Plastic Coil (Coil Bound)A4BOTTOMSIDELegacy Number if applicable:Sample Legacy Number: 0160-5.3324 x 36 PosterSTAPLED1 -1 positionA3Publication Title:EtherNet/IP Copper Tap Release NotesSample: ElectroGuard Selling Brief36 x 24 PosterSTAPLED1B - bottom 1 positionA5(required) Business Group:Marketing CommercialAs entered in DocMan4 x 6STAPLED2 - 2 positionsA6(required) Cost Center:19021As entered in DocMan - enter number only, no description. Example - 19021CMKMKE CM Integrated Arch - 19021CMKMKE Market Access Program - 191054.75 x 7 (slightly smaller half-size)THERMAL - Thermal bound (Tape bound)A7Binding/Stitching:SADDLE - Saddle StitchReview key on right...Saddle-Stitch Items All page quantities must be divisible by 4.80 pgs max. on 20# (text and cover)76 pgs max. on 20# (text) and 24# (cover)72 pgs max. on 24# (text and cover)Perfect Bound Items940 pgs max. w/cover (90# index unless indicated otherwise)Coil Bound Items580 pgs max. of 20# (if adding cover deduct equivalent number of pages to equal cover thickness) (90# index unless indicated otherwise)Tape Bound Items250 pgs max. on 20# no cover240 pgs max. w/cover (90# index unless indicated otherwise)Double Wire Bound Items80 pgs max. on 20# (if adding cover deduct equivalent number of pages to equal cover thickness) (90# index unless indicated otherwise)4.75 x 7.75THERMALO - Thermal Bound (Tape bound - offline)A8(required) Page Count of Publication:4Total page count including cover5.5 x 8.5 (half-size)Wire O - Double Wire Bound (offline)A9Paper Stock Color:White is assumed. For color options contact your vendor.6 x 4Post Sale / Technical CommunicationNumber of Tabs Needed:5 tab in stock at RR Donnelley7.385 x 9 (RSI Std)B1Stitching Location:SIDEBlank, Corner or Side8.25 x 10.875B2Drill Hole YES/NONOAll drilled publications use the 5-hole standard, 5/16 inch-size hole and a minimum of inch from the inner page border.8.25 x 11 (RA product profile std)B3NoneGlue Location on Pad:Glue location on pads8.375 x 10.875B4HalfNumber of Pages per Pad:Average sheets of paper.. 25, 50 75,100 Max9 x 12 (Folder)B5CInk ColorOne color assumes BLACK / 4 color assume CMYK / Indicate PMS number hereA4 (8 x 11 ) (210 x 297 mm)CatalogsDbleParllUsed in Manufacturing:YESA5 (5.83 x 8.26) (148 x 210 mm)C1Offset ZFold:NoneSampleComments:C2ShortPart Number:PN-89243JIT / PODVD1ZD2MicrofoldD3D4D5D6D7D8D9

/ColorImageDict > /JPEG2000ColorACSImageDict > /JPEG2000ColorImageDict > /AntiAliasGrayImages false /CropGrayImages true /GrayImageMinResolution 300 /GrayImageMinResolutionPolicy /OK /DownsampleGrayImages true /GrayImageDownsampleType /Average /GrayImageResolution 300 /GrayImageDepth 8 /GrayImageMinDownsampleDepth 2 /GrayImageDownsampleThreshold 2.00000 /EncodeGrayImages true /GrayImageFilter /FlateEncode /AutoFilterGrayImages false /GrayImageAutoFilterStrategy /JPEG /GrayACSImageDict > /GrayImageDict > /JPEG2000GrayACSImageDict > /JPEG2000GrayImageDict > /AntiAliasMonoImages false /CropMonoImages true /MonoImageMinResolution 1200 /MonoImageMinResolutionPolicy /OK /DownsampleMonoImages true /MonoImageDownsampleType /Average /MonoImageResolution 1200 /MonoImageDepth -1 /MonoImageDownsampleThreshold 1.50000 /EncodeMonoImages true /MonoImageFilter /CCITTFaxEncode /MonoImageDict > /AllowPSXObjects false /CheckCompliance [ /None ] /PDFX1aCheck false /PDFX3Check false /PDFXCompliantPDFOnly false /PDFXNoTrimBoxError true /PDFXTrimBoxToMediaBoxOffset [ 0.00000 0.00000 0.00000 0.00000 ] /PDFXSetBleedBoxToMediaBox true /PDFXBleedBoxToTrimBoxOffset [ 0.00000 0.00000 0.00000 0.00000 ] /PDFXOutputIntentProfile (None) /PDFXOutputConditionIdentifier () /PDFXOutputCondition () /PDFXRegistryName () /PDFXTrapped /False /Description > /Namespace [ (Adobe) (Common) (1.0) ] /OtherNamespaces [ > /FormElements false /GenerateStructure true /IncludeBookmarks false /IncludeHyperlinks false /IncludeInteractive false /IncludeLayers false /IncludeProfiles true /MultimediaHandling /UseObjectSettings /Namespace [ (Adobe) (CreativeSuite) (2.0) ] /PDFXOutputIntentProfileSelector /NA /PreserveEditing true /UntaggedCMYKHandling /LeaveUntagged /UntaggedRGBHandling /LeaveUntagged /UseDocumentBleed false >> ]>> setdistillerparams> setpagedevice