8/12/2019 Estimate Shantiniketan Branch ELECTRICAL

1/3

Section B : ELECTRICAL WORKSl. No. Description of Item Qty Unit Rate (Rs.) Amount (Rs.)

A.1 Supplying, Fabricating, assembling, inter-connecting, testing and connecting

with incoming and outgoing power cables and lines as required to comlete the job of CUBICAL TYPE ELECTRICAL PANEL made from 14 SWG CRC M.Ssheet with proper earthing terminal(Nut-bolt and washer)-02 nos. outsidepanel, same nut-bolt to tighten with internal earth bus-bar of panelsituated

inside loose wire box (on top portion of the panel). On top side of the panel,cable entry arrangement is to be done for incoming and outgoing of lines. One6" x 4" enamel type 440 Volts danger board to be fixed on the main panelbusbar cover. All switches are front handle operated and all MCB knobshould be visible. All componenets are to be provided in separatecompartment and only DBs in one compartment. The main componenets are

1.00 set

a. 100 AMPs MCCB, 35 KVA as main 1.00 Nob.150 AMPs 4 Pole Cu. Busbar 1.00 setc. 63 AMPs 4pole change over switch 1.00 Nod. 63 AMPs 4 Pole MCB as DG 2.00 Noe. 40 A D.P MCB (For 5 KVA Ups) 2.00 Nof. 6-WAY TPN MCB DB with 63 TP & N MCB as main (Power DB)25 ASPMCB-10 Nos.,20 AMPs SP MCB-06 Nos.,16 A SPMCB-02 Nos.,NeutralBar-01 set

1.00 set

g. 4-WAY TP& N MCB DB with 40 TP& N MCB as main (Lighting DB)16 AMPs SP MCB-03 Nos., 10 AMPs SP MCB-09 Nos., Neutral Bar- 1 set

1.00 set

h. 32 AMPs DP MCB as glow sign board main 1.00 seti. AMPs meter 0-100 AMPs with 3 Nos. CT & selector switch 96 x 96 mm-01set (A.E make) (CT ratio 100/5) A.E. make

1.00 set

j. Voltmeter-0-500 Volt A.C. 50 Hertz 96 x96 mm with selector switch (A.Emake)-01 set

1.00 set

k. 22 mm dia LED indicator Lamp 6.00 Nol. 02 AMPs sliding fuse 6.00 Nom. 150 x 100 mm enamel danger board 440 Volt(to set on bus bar cover) 1.00 No

2Supply and fixing of 100 AMPs TPN HRC type at WSEB for main incoming onMS angle frame and 02 nos. cable end box including connection

1.00 No

3

Supplying, installation and Termination of UPS out-going power distributionsystem with 12 way SPN DB comprising of 10 x 10 AMPs SP MCB and 32 AMPs DP RCBO 300 MA as main (MDS make) IP-42 protection with doubledoor. Power is to be taken from existing DB.

1.00 No

4 Supply, installation and termination of 40 Amp DP MCB in ATM 1.00 No5 Supply, laying of circuit line 2x2.5 sqmm+1x1.5 sqmm PVC insulated copper

wire from panel to ATM counter.30.00 MT.

6 Supply & fixing 250V grade 5 to 10 amp range single phase KWH meter in ATM.

1.00 No

0.00

MAIN LT PANEL AND DISTRIBUTION BOARDS :

Total For Panel And Distribution Board

ELECTRICAL WORKWORK FOR DENA BANK, SHANTINIKETAN BRANCH .

8/12/2019 Estimate Shantiniketan Branch ELECTRICAL

2/3

B.

1Supply & Fixing 3.5 C X 35 Sqmm Al. Ar. Cable From Meter room to Panel 8.00 Mt

2 Supply & Fixing 3.5 C X 35 Sqmm Al. Ar. Cable From DG to Panel 30.00 Mt

3Supply & Fixing 3.5 C X 25 Sqmm Al. Ar. Cable From panel to power DB 30.00 Mt

4Supply & Fixing 4.0 C X 10Sqmm Al. Ar. Cable From Panal to Lighting 20.00 Mt

5Supply & Fixing 3.0 C X 6 Sqmm Cu. PVC Insulated wire in PVC Conduit(from panel to UPS)

30.00 Mt

6Supply & Fixing3.0 C X 6 Sqmm Cu. PVC Insulated wire in PVC Conduit (fromUPS to UPS DB)

30.00 Mt

7 Supply & Fixing Cable End Terminationa. 3.5 C X 35 Sqmm Al. Ar. 10.00 setb. 3.5 C X 25 Sqmm Al. Ar. 10.00 setc. 4.0 C X 10 Sqmm Al Ar. 10.00 setd. 3.0 C X 6 Sqmm Cu. 10.00 set

C.

1Wiring for Light Point with 20 mm PVC pipe with 2x1.5 Sqmm wire and 1x1.5Sqmm green earth wire for light Points as reqd. complete with modularswitch with front plate

a. One light controlled by 6A switch 57.00 Nob. Two light controlled by 6A switch 6.00 Noc. Exhaust fan point with 6 A sw complete with modular switch plate & M.Sconceal box & 3 pin ceiling rose

4.00 No

d. Fan point complete with modular switch plate & M.S conceal box & 3 pinceiling rose

10.00 No

e. Call bell point with push type switch, modular plate & M.S. conceal box withbuzzer or ding dong type bell

2.00 No

2RAW POINT WIRING - The wiring shall pass through PVC pipe of 20 mm diawith ISI mark to conceal on wall below false ceiling mending good all thedamage

a. Supply, laying of circuit line 2x2.5 sq.mm +1 x 1.5 Sq.mm PVC insulatedcopper wire from MCB type lighting DB to 6 amp plug points (3 nos. 6 Ampsplugs to be connected from one circuit line)

200.00 Mt

b. Modular type 6 A switch with 6A 5 pin socket .Mounted on suitable frontplate

14.00 No

c. Wiring for Power Point 6/16 A Switch & Socket with 25mm PVC pipe with2x2.5 Sqmm wire and 1x1.5 Sqmm green earth wire for Power Points asreqd. This line has to be drawn from the power DB. (02 nos. plugs to beconnected with one circuit)

60.00 Mt

d. Modular type 6/16 A switch. with 16A 5 pin socket . Mounted on suitablefront plate

10.00 No

CABLE AND CABLE END TERMINATION :

Total For Cable And Cable End TerminationWIRING:(concealed type wiring including cutting groove in wall & fiiling up)

8/12/2019 Estimate Shantiniketan Branch ELECTRICAL

3/3

3a. Wiring for Power Point 6/16 A Switch & Socket w ith 25mm PVC pipe with2x2.5 Sqmm wire and 1x1.5 Sqmm green earth wire through PVC casing 20mm dia 16 SWG with ISI mark to lay from UPS MCB DB to plug point board & ATM counter.

220.00 Mt

b. Supply and fixing of 2 x 6 Amps 5 pin socket + 1 x 16 amps 6 pin socket insingle board (under table) + 1 x 16 A switch (Modular switch + socket) inanother board above table as per direction

12.00 set

c. Do- but 3 x 6/16 , 6 pin socket with three control switch to provide nearHUB Rack and line printer to be connected from UPS power

2.00 set

d. Supplying, installation of UPS incoming 32 Amps industrial socket with 32 Amps SPMCB (2 nos. for out going and 2 nos. for incoming)

2.00 set

D.1 Supplying, laying and connection of telephone points with 2 pair .51 sq.mm

tinned Cu conductor through PVC casing ISI mark from telephone point toKrone DB complete with RJ 11 telephone socket modular type in PVCconcealed box.

10.00 No

2 Do- 10 pair 0.51 sq.mm copper conductor telephone cable in 20 mm dia PVCpipe

45.00 Mt

3 Supply, fixing and connection of 20 pair KRONE connector DB complete withPVC moulded Telephone DB box with locking system

1.00 Set

E.1 Supply and Fixing (36x 1) W class LED light of reputed make.Architect's

approval required before installation.22.00 No

2 Supply and Fixing of 1x36/40 Watts 2' length Slim Tube Light for Coffer Lights. Architect's approval requir ed before installation.

15.00 No

3 Supply and Fixing of surface mounted luminaries with 1 x 18 W complete withdown rod and accessories. Architect's approval required before installation.

2.00 No

4 Supply and Fixing 18 W Recess Mounted LED Modular Downlighter of reputedmake. Architect's approval required before installation.

18.00 No

5 225mm heavy duty exhaust fan with louvre in toilet / pantry inclusive of holecutting in the wall and finished with plastering complete

4.00 No

6 Wall Hung fan complete with all fitting and mending good all damages 8.00 No

7 Ceiling Hung fan complete with all fitting and mending good all damages 2.00 No

8 Supply and fixing 250 volt grade superior type calling bell on wooden boardon wall.

2.00 No

F. PROVIDING CHANGE OVER SWITCH FOR GENERATOR RUNNING: Job 1G. A / C SYSTEM:1 Suppy & fixing of starter with 3 pin plug in recessed MS box suitable for 1.5TR

AC/2 TR AC6.00 No

2 Supply and Fixing in 25mm PVC Pipe with 3x 6 Sqmm Cu. Cable For Singlephase A/C Point Complete & reqd

200.00 Mt

H. GLOW SIGN BOARD:1 Supplying, laying of main line with 2 x 2.5 sq. mm + 1 x 1.5 sq. mm through

M.S conduit from main panel to glow sign board55.00 Mt

2 Supplying , fixing of 16 Amps DP MCB at main entrance with Glow sign boardtimer (24 hours in original housing)

1.00 No

I. EARTHING:1 Supply & Fixing 25 mm PVC Pipe with 8 SWG 2no, Coppe r wire for Earthing.30.00 Mt

2 Supply & Fixing 25x 3 mm GI Earth Strip 2no,Meter Room to Panal 10.00 Mt3 Supply & Fixing 20mm PVC Pipe with 4C x 1.5 Sqmm Cu. Flexible. Cable for

PIR Control ( From Control panal to Each PIR Control Only Cabling)2.00 L.S

4 Providing and making earthing station complete with 300x300x3 MM Cu PlateComplete with salt coal and watering pipe Complete with chamber as reqd.

2.00 No

UPS WIRING - (concealed type wiring including cutting groove in wall & fiiling up)

Total For Glow Sign Board

Total For Earthing

TOTAL FOR ELECTRICAL WORK

Total For WiringDATA/ TELEPHONE-LOW VOLTAGE SYSTEM:

Total For Data/Telephone-Low Voltage System FIXTURE :

Total For Fixture

Total For A/C System