Step by Step procedures on how configure the Encore ENHWI-G2 Router on a Bayan Tel PPPoE Connection.

Open an internet browser it could be your windows default (Internet Explorer), Mozilla Firefox, Opera, Netscape Navigator, Maxton, or Safari for windows. On the browser’s URL or Address bar, type the default IP address of the router which is 192.168.1.1, and then press the “enter key”. A login dialog box

will appear asking for a Username and Password. The default Username is “admin” and the default

Password is admin.

*Click Wireless then click Basic Settings.

*Click “Apply Changes” button and wait again for 15 seconds for the router to restart and initialize.

Click Security.

(Note: you can choose whatever type of Encryption you want to use. In this sample WPA was used. You can fill any word (letters and Numbers) that you want with this field, Just Remember the word you filled in this field, because this will serve as the password for your wireless connection)

On the Right Panel of the page, click on the TCP/IP Settings and click on the LAN Interface. Place a check on the “Enable UPnP” field then Click the “Apply Changes” button and wait again for 15 seconds for the router to restart and initialize.

Next click on the WAN Interface, type-in your Physical address/MAC Address and make sure to check all the check boxes and then click “Apply Changes” button and wait again for 15 seconds for the router to restart and initialize. Shown below:

To get the physical address, go to command prompt and type ipconfig/all. Copy the physical address and paste it to the clone MAC Address, remove all dashes.

Now click on the Management and click on “Status”, to check if your WAN Configuration has an IP address and that you are already connected to the internet. Shown below:

^^19^^

Shown Below is the sample picture of the modem used in this router: