ENERGY

CONSERVATI

ON

ByEnergetic Dr.Bala

www.visionunlimited.in

Fan at home

• Use light weight/high power fans.

• Use electronic regulators for less cost

• Avoid rewinding motors

• Clean fan blades often

• Apply oil in the fan bearings then and there

Grinder at home

• Use high power motors in the grinders

• See that your grinders have nylon belts

• Use the grinder to the full power and energy

• Clean the grinder often and apply oil in relevant parts.

AC at home• Select an appropriate size of

the AC unit according to the room size.

• Close the doors of the rooms with AC

• Clean the filters of the AC frequently

• See that there is no air going out of the room

• Keep the AC always in 25 deg C.

• When you replace your old AC always look for AC with Star mark for better power and energy…

Iron box at home

• Never iron the clothes one by one….. Try and plan for more clothes at a time.

• Switch off the Iron Box then and there.

Refrigerator at home• Always keep the Fridge little

away from the wall and let there by some ventilation.

• Avoid opening and closing of doors of the fridge.

• Avoid keeping hot/warm products in the fridge… wait for the products to come to room temperature…

• Defrost often to avoid ice formation…

• Buy “Star” marked fridges for power save

• Adjust the thermostat instrument of the fridge according to the room or outside temperature

Motor pumps at home

• Use high power motor pumps for efficiency

• Use PVC pipes/avoid GI pipes

• Avoid water leakages in the pipes

• Add capacitors in the water pump motor

• Avoid water tank over flowing… use relevant instruments to indicate the same….

Water heaters at home

• Avoid water leakages in the water pipes

• Try solar heaters if possible

• Try to put on safety cover on to hot water pipes…

Computers at home• When not in use switch

off computers.• If a PC runs for 24 hrs, it

consumes more electricity than the AC

• Put on monitor of the PC when not required or not in use

• Sleep mode computers/monitors save 40% power

• Switching on/off of the PC according to requirement saves power and provides extension of life to PCs as well.

THANK

YOU