ELMEK ENGINEERING PTE LTD - Kejuruteraan Elmek Sdn...
Transcript of ELMEK ENGINEERING PTE LTD - Kejuruteraan Elmek Sdn...
-
2017 KEJURUTERAAN ELMEK SDN BHD All rights reserved. No part of this document may be reproduced, stored in a retrieval system or transmitted in any form or by any means (electronic, mechanical, photocopying, recording or otherwise) without the permission of the copyright owner.
ELMEK ENGINEERING PTE LTD (KEJURUTERAAN ELMEK SDN BHD)
WATER CONTROL GATE
FLAP GATE
We have a range of HDPE (High Density Polyethylene), Aluminum and the “trendy” Composite Flap Gates. This range comprises of lightweight, corrosion resistant flap gates which act as Non-Return Gates and check gates for the prevention of reverse flows.
Flap gates are designed for use at the
discharge point of water control
systems. They prevent back flow or
intrusion of tidal waters or storm waters
back through the discharge structure.
Flap Gates may be installed on all size
discharge openings.
Typical applications include discharges
to tidal waters, manholes, culverts,
reservoirs, ponds basins and
standpipes. Flap Gates permit the
outflow of water while preventing back
flow.
ADVANTAGES
Lightweight
Custom built to client’s requirements
Low crack formation and propagation
Easy and quick installation Robust and rigid construction
UV stable
Corrosion resistant
No maintenance required (maintenance only on seals)
-
2017 KEJURUTERAAN ELMEK SDN BHD All rights reserved. No part of this document may be reproduced, stored in a retrieval system or transmitted in any form or by any means (electronic, mechanical, photocopying, recording or otherwise) without the permission of the copyright owner.
COMPOSITE SCREWDOWN GATE
Screw down gates are commonly selected for water levels and flow rates controls in rivers and waterways. They are also used in raw water treatment plant, wastewater treatment plants and primarily for use of flow control of weir, irrigation, and flood control with minimal leakage.
ALUMINIUM ROLLER GATE
Roller gates are designed to control water
flow through large waterway / canal
openings where cost-effective and ease of
operation are important. A roller or fixed
wheel gate consists of a fabricated steel
slide with cast iron rollers and rubber seals.
It varies in width and height as required by
the size of the opening in the structure and
varies in thickness depending on the depth
of water. Recesses at the sides of the gate
opening are provided with rails and with
contact faces for side seal.
Contact:
Elmek Engineering Pte Ltd
(Kejuruteraan Elmek Sdn Bhd)
No 23, Jalan Kilang Satu, Kawasan Perindustrian Jelapang,
Taman Pertama, 30100 Ipoh, Perak, MALAYSIA
[email protected] [email protected] www.kjelmek.com
Tel: +605-5263515 Fax: +605-5265028
mailto:[email protected]:[email protected]://www.kjelmek.com/