Electron Energy Loss Spectroscopy (EELS) Suggested Reading: Used electron spectrometer Used TEM...
-
Upload
corey-fletcher -
Category
Documents
-
view
229 -
download
1
Transcript of Electron Energy Loss Spectroscopy (EELS) Suggested Reading: Used electron spectrometer Used TEM...
Electron Energy Loss Spectroscopy (EELS)
Suggested Reading: Used electron spectrometer
Used TEM
Review of theory for elastic + inelastic scattering
Examples for graphite and gold
Problem:
How can we gain information on unoccupied electronic states of the system
IPES—good, but low count rates, few labs do this.
Auger spectroscopy—common, high count ratesXPS-- not bad either.
Can we use such instrumentation and excitation methods?
Yes! (Well, sort of…)
Electron Energy Loss—basic process
Losses in XPS spectra
Electron Energy Loss Spectroscopy—electron excitation*TEM+EELS analyzer*Electron energy analyzer
Near Edge X-ray Absorption Fine Structure (NEXAFS)—synchrotron based photon absorption measurement.
Core
hv
e-
Evac
E field
EFermi
CB
VBΔE
Transit of an electron through a solid (ionization of core electron shown) induces a strong, local electric field (E)
This electric field can induce excitations of higher lying electrons:(a)From ground to higher vibrational states (HREELS)(b)From filled to empty electronic states (EELS) –considered here.
EK = hv-EB- Φanal. - ΔE
Promotion of an electron from VB to CB
EELS effects observed in XPS, Auger, etc. as well as from reflected/transmitted electrons
C(1s)XPS from ~ 3ML graphene /Co3O4/Co (Zhou, et al., JPCM 24 (2012) 72201
Loss spectra from backscattered electrons, few layer graphene/SiCUsing high resolution electron spectrometer
Can also use TEM with electron energy loss analyzer for this purpose(Can get EELS spectra from VERY localized area)
EELS in TEM mode
United States Patent 7067805
From uspatentsonline.com
Double pass Cylindrical Mirror Analyzer (CMA) with co-axial gun (STAIB instruments)
--Coaxial gun, reflection geometry--Large angular acceptance.--Field free region between analyzer and sample
EELS can be used to monitor evolution of surface vs. bulk plasmons in deposited nanoparticles. (Plasmon collective excitation of electron gas in, e.g., metals) note, surface plasmon typically distinct in energy from bulk)
Used double pass CMA
EP
60
One can get some idea of energy band dispersion by collecting at well defined angles (CMA not good for this), but note effects on resolution of varying the primary energy:
ΔE/E = const. for electrons from excitation source.
Also better surface sensitivity
Langer, et al.
Energy and Emission Angle Effects
1.Surface excitations (surface plasmons) enhanced at higher emission angles.
2.Excitation cross section for specific loss energy EL increases as ΔE = Ep – EL increases.
Bulk plasmon
Surface Plasmon
Note: Surface plasmon intensity increases with emission angle of reflected electron
REELS of Si
Note relative intensities of surface and bulk plasmons at 500 vs 2000 eV primary energy—due to both cross section and imfp effects
Can get sampe phenomena during X-ray absorption
From Grant Bunker, NEXAFS overview
One can monitor photo yield, or electron yield
Absorption vs. wavelength
Ask to borrow your Mom and Dad’s synchrotron!
Near Edge and pre-edge region
Excitation of Core level to unoccupied bound state
EXAFS region, excitation into continuum
NEXAFS (XANES) Core unoccupied bound states, like EELS but different, it is a direct absorption measurement
O 1s (or N, or C
e-