EF-010 ENEFLOW Scale Control - proenecon.com · with ENEFLOW Fluid Dynamic Power Cells to insure...
1
A major refinery in Western Pennsylvania has seen outstanding results from a variety of ENEFLOW Power Cell installations since 1991... A 3 inch -- over 300 feet long -- would clog up 2 or 3 times a year, requiring extensive cleaning in order to remove the built-up mineral scale and sludge. This was an expensive and time consuming procedure. After the engineers installed two pairs of ENEFLOW Power Cells in 1991 on one of the units, there waste water sludge line The plant engineers report that since installing two pair of ENEFLOW Fluid Dynamic Power Cells they have had no clogs in the line! Oil coolers (heat exchangers) were clogging up with mineral scale every 6 months. have been no further problems. The difference was especially evident since a second oil cooler was not protected with the ENEFLOW system for control purposes. This identical (unprotected) heat exchanger continued to scale up every 6 months! In addition, a variety of have also been successfully protected with ENEFLOW Fluid Dynamic Power Cells to insure that these remain free of mineral scale and scale induced corrosion -- all without the need for environmentally hazardous chemicals or expensive equipment to maintain. Most of the ENEFLOW installations are out doors and are covered with insulation. ENEFLOW Power Cells are completely maintenance free. cooling water lines ENEFLOW Fluid Dynamic Power Cells Continue to Provide “ ” Scale Control Performance After Years at Major Refinery. Outstanding Many Copyright © 2002 by ENECON ® Corporation EF-010_ENEFLOW_Scale_Control_at_PA_Refinery.pdf Three hundred foot waste water sludge line has been scale free for Two years. ENEFLOW units are maintenance free & can be covered with insulation Heat exchangers have had no further mineral scale build-up problems after ENEFLOW Power Cells were installed. EF-010 ENECON Ibérica · C/ St. Gervasi de Cassoles, 96-98 entlo. 3ª · 08022 Barcelona ·Telf: 93 211.15.30 · Fax: 93.253.11.31 Website: www.proenecon.com · Email: [email protected]
Transcript of EF-010 ENEFLOW Scale Control - proenecon.com · with ENEFLOW Fluid Dynamic Power Cells to insure...
A major refinery inWesternPennsylvania hasseen outstandingresults from a varietyof ENEFLOW PowerCell installationssince 1991...
A 3 inch-- over
300 feet long --would clog up 2 or 3times a year,requiring extensivecleaning in order toremove the built-upmineral scale andsludge. This was anexpensive and timeconsumingprocedure.
After theengineers installedtwo pairs ofENEFLOW PowerCells in 1991 on oneof the units, there
waste watersludge line
Theplant engineersreport that sinceinstalling two pairof ENEFLOW FluidDynamic PowerCells they have hadno clogs in the line!
Oil coolers (heatexchangers) wereclogging up withmineral scale every6 months.
have been no furtherproblems. Thedifference wasespecially evidentsince a second oilcooler was notprotected with theENEFLOW system forcontrol purposes. Thisidentical (unprotected)heat exchangercontinued to scale upevery 6 months!
In addition, a variety of
have also beensuccessfully protectedwith ENEFLOW FluidDynamic Power Cellsto insure that theseremain free of mineralscale and scaleinduced corrosion -- allwithout the need forenvironmentallyhazardous chemicalsor expensiveequipment to maintain.
Most of theENEFLOWinstallations are outdoors and are coveredwith insulation.ENEFLOW PowerCells are completelymaintenance free.
cooling water lines
ENEFLOW Fluid Dynamic Power CellsContinue to Provide “ ” Scale ControlPerformance After Years at Major Refinery.
OutstandingMany
Copyright © 2002 by ENECON®Corporation EF-010_ENEFLOW_Scale_Control_at_PA_Refinery.pdf
Three hundred foot
waste water sludge
line has been scale free
for Two years.
ENEFLOW units are
maintenance free &
can be covered
with insulation
Heat exchangers have
had no further mineral
scale build-up problems
after ENEFLOW Power
Cells were installed.
EF-010
ENECON Ibérica · C/ St. Gervasi de Cassoles, 96-98 entlo. 3ª · 08022 Barcelona·Telf: 93 211.15.30 · Fax: 93.253.11.31
Website: www.proenecon.com · Email: [email protected]
