DAFTAR PUSTAKA

Anonim, 1997, Principles of Operation, EDM Technology Transfer, ATMI, Surakarta.

Anonim, 1997, Operation Instruction Versi A CHAMER EDM, Taiwan. Brink, D., EDM: Principles of Operation, EDM Technology Transfer.

http://www.edmtt.com. Klocke, F., EDM: Principles of Operation, EDM Manufacturing Technology I.

http://www.edmtt.com. Dauw, D. F., Charmilles, 1989, Technologies: Facing the Future, in: Paper

Presented During the Inauguration of CT-Japan, Yokohama, Japan. Geoge, V., Venkatesh, V. C., 1980, Investigasi on Optimum Machining

Condition for Electro-Discharge Machining of 5 Cr Die Steel, in:proseduring of the Ninth AIMTDR Conferece, IIT, Kanpur, 23 pp.

Kalpakjian, S, Schmid, Steven R., 2003, Manufacturing Processes for

Engineering Materials, Fourth Edition, Pearson Education, Inc. Soni, J. S., Chakraverti, G., 1985, Effect Of Electrode Material Properties on

Surface Roughness and Dimensional Accuracy in Electro-Discharge Machining of High Carbon High Chromium Die Steel, J. Inst. Eng. (India)–PR 76, 46–51.

Soni, J. S., Chakraverti, G., 1990, Physico-Mechanical Effect on

Electrodischarge Machined Surface of High Carbon High Chromium Die Steel, J. Inst. Eng. (India) 71 (PR-1) 19.

Soni, J. S., Chakraverti, G., 1991, Investigative Study on Metal Removal Rate

and Wear Ratio in EDM of High Carbon High Chromium Die Steel, J.Inst. Eng. (India) 71 (Pt AS2) 32.

Van Vlack, Lawrence, 2001, Elemen-Elemen Ilmu Dan Rekayasa Material, alih

bahasa : Sriati Djaprie, Edisi 6, Jakarta.