Edirol R09 MP3/WAVE Recorder

Table of Contents

Before you begin.............................................................................................................................................2

Switching on ....................................................................................................................................................3

Recording ......................................................................................................................................................... 6

Playback Your Recordings ......................................................................................................................... 8

Transfer Your Recordings ......................................................................................................................... 9

Before you begin

Make sure you have the following: 1. Edirol R09 MP3/WAVE Recorder

2. Power cable and power adapter

3. SD memory card (this should be inserted at bottom of record under panel)

4. 2 x AA batteries (if not using mains power)

5. USB cable

Check the settings on the back look like this:

Switching on Recommend: Using mains power at all times where possible to prevent recording to fail due to battery power loss

If using mains power:

A. Connect power cable to power adapter B. Connect plug to power source C. Connect power to side of recorder

If using batteries:

A. Open bottom panel by sliding it away from recorder until it stops.

Press, hold and slide battery release button to left and then slide bottom panel away from recorder again

B. Insert batteries C. Close bottom panel

1. Press and hold power button at side of recorder for more than 2 seconds

Recording

1. Set record mode by pressing and holding down 'Finder/Menu' button for more than 2

seconds

2. Press 'Rec/Enter' button

3. Change sample rate and record mode using the navigation/control buttons and 'Rec/Enter' button

Recommend sample rate; 48KHZ and record mode; MP3-128KHZ (for mp3 recordings) or WAV-16bit (for wave recordings)

4. Press 'Finder/Menu' button repeatedly until back at main screen

5. Press 'Rec'

Note: This is not recording but in 'Standby mode'. In this mode you can check your levels before recording

6. Press 'Rec' again

To stop recording press 'Stop' using control/navigation buttons

Playback Your Recordings

Note: This recorder does not have speakers. To listen back you will need to plug in headphones at the side of the recorder. Use the Volume buttons to adjust volume

Use the control/ navigation buttons to play, pause and stop playback. • Press the scan buttons to switch between tracks • Press and hold the scan buttons to fast-forward/rewind

Transfer Your Recordings

1. Turn on recorder (see 'Switching on') 2. Connect USB cable at bottom of recorder (under panel)

3. Connect USB cable to computer

The recorder will appear as a 'Removable device' 4. Open to view files

5. Select recorded files (e.g. R09_0001, R09_0002) 6. Copy and paste to computer

7. Confirm transfer and delete files from recorder 8. Close 'Removable Disk' window and eject recorder from computer