edge.rit.eduedge.rit.edu/content/P15661/public/Test Plans/Word Do… · Web viewP15661 –...
3
P15661 – Friction Tester: Reciprocating Base T19 - System Size Date Completed: ____4/9/2015________________________ _ Performed By: ____Chris Karamanos ______________________ Objective: The objective of this test is to show that our friction tester meets the size requirements from the PRP. Engineering Requirement: S1 S1- System not to large Materials Complete Friction tester Tape measure Procedure: 1) Measure the length and width of the system 2) Check measurements against engineering requirement Data Sheet: Length: 12.5” Width: 24” Height: 12.6” Sketch:
Transcript of edge.rit.eduedge.rit.edu/content/P15661/public/Test Plans/Word Do… · Web viewP15661 –...
P15661 – Friction Tester: Reciprocating Base
T19 - System Size
Date Completed: ____4/9/2015________________________ _
Performed By: ____Chris Karamanos______________________
Objective:
The objective of this test is to show that our friction tester meets the size requirements from the PRP.
Engineering Requirement: S1
S1- System not to large
Materials
Complete Friction tester Tape measure
Procedure:
1) Measure the length and width of the system2) Check measurements against engineering requirement
Data Sheet:
Length: 12.5”
Width: 24”
Height: 12.6”
Sketch:
P15661 – Friction Tester: Reciprocating Base
Height
Length
P15661 – Friction Tester: Reciprocating Base
Width