DSL605EW KB Wireless Configuration

8/13/2019 DSL605EW KB Wireless Configuration

1/4

R O D U C T E N G I N E E R I N G A N D S U P P O R Ti n g a p o r e

A Z T E C H T E C H N O L O G I ES P T E L T D

AZTECH DSL605EW

4-PORT ADSL2/2+ WIRELESS-G MODEM ROUTER

RECONFIGURING THE WIRELESS ACCESS POINT

A. CONFIGURING THE DSL605EWS WIRELESS ACCESS POINT

1. Connect your computer to any of the Ethernet Ports 1-3 of the DSL605EW

2. Open your Internet browser

3. On the address box, type http://192.168.1.1

4. On the main page, click on Wireless

5. On the left panel menu, click on Setup, this will open the Wireless Setup page

Note:

If theres a prompt for login, try the following

Username: adminPassword: admin

orUsername: adminPassword: (no password)


2/4

F r e q u e n t l y A s k e d Q u e s t i o n Page 2 of 4


A Z T E C H T E C H N O L O G I E S P T E L T D

6. On the Wireless Setup page, you can change the Primary SSID, Primary SSID will be the wirelessnetwork name which you will see when you scan for wireless networks from your computer

7. Ensure that there is a check for Enable AP then click on Apply followed by Restart Access Point

8. On the left panel menu, click on Security, this will open the Wireless Security page


3/4

F r e q u e n t l y A s k e d Q u e s t i o n Page 3 of 4


A Z T E C H T E C H N O L O G I E S P T E L T D

9. Click to select WEP from the security options

10. Ensure that you have a check mark on the Enable WEP Wireless Security

11. On the Authentication Type, ensure that Open is selected

12. There will be 4 boxes, fill the 1stbox with 10 digits (combination of numbers from 0-9 andletters A-F only), cipher for the first box should be set to 64 bits

13. Click on Apply followed by Restart Access Point to temporarily save the settings

14. To save the settings to the device click on Save Settings


4/4

DSL605EW KB Wireless Configuration

Documents

Transcript of DSL605EW KB Wireless Configuration