dry scrubber catalogue final - HUMIDIN · Building Management System (BMS) ... THE ENTIRE DRY...
Transcript of dry scrubber catalogue final - HUMIDIN · Building Management System (BMS) ... THE ENTIRE DRY...
DRY SCRUBBER REFRESHING ENVIRONMENT
REFRESHING YOU
HUMIDIN designs, manufacture and offers an highly efcient,
engineered solution for reduction in Smoke, Grease, Odor from the
extract of Kitchens and Restaurants through a Scrubber which operates
on the principle of electrostatic precipitation. It pulls the air through the
kitchen hoods and duct into a Dry Scrubber where the fumes are
treated before they are exhausted or released into the atmosphere.
DRY SCRUBBER
HOW IT WORKS?• The technology is based on the principle of two stage electrostatic air ltration.
• Fine sub-micron suspended particles are electrostatically charged
using high-voltage electric eld.
• These charged particles get attracted and precipitated on opposite
charged electrode plates.
DIRTY AIR
Pre FilterIonizing
Electrode
After lterCollectionPlates
CLEAN AIR
02
HEALTH CARE• Healthcare Facilities Hospitals - OTS / ICUS
• Pharmaceutical Manufacturing
• Medical Devices Manufacturing Biotech Laboratories
• Food Products Processing
APPLICATION AREASOTHERS• Kitchen Exhaust
• Aerospace Engineering
• Photographic Processing
• o POs TOfces f Consultants, B , I Industries
• CUrbo- harged Diesel Engines, Gensets, Turbines
• a VTransmission Rooms t T Centers
• VCompressors, H. . Alternators
• Process Industries (textile, Spinning, Ceramics,
eCement, Steel, tc.)
• Power Plants
• Nuclear Fuel Processing
FEATURES
TECHNOLOGICAL ADVANTAGE • Filtration Efciency: Ability of trapping the particles down to 0.01 micron. Equivalent to and better than EU9 grade lters.
• Very Low Pressure Drop: 0.5” of W.C. pressure drop across ESP
• Permanent Filter: ESP never requires any replacement over the lifetime (15-20 years). It only requires periodic cleaning.
• Makes this ideal choice of ne pollutants like oil mist and fumes.
MICRO ELECTRONICS • Semiconductor Manufacturing
• Disk Drive Manufacturing
• Hybrid Circuits / IC Manufacturing
• Hybrid TV Picture Tube Manufacturing
Stackable customized modules easy for installation
Coupled with VFD enabled HUMIDIN make highly efcient Aerofoil Plug Fan having options of four side discharge
Upto 98% efcient to ensure clean air
Modular construction for easy maintenance
Advanced two stage electrostatic precipitation
Odor Neutralizer available as an option compatible with Building Management System (BMS)
03
SI No. Model Air Flow Power(W) Dimension
CMH CFM ESP UV Lamps W/O UV Lamps with UV Lamps
1. M-03/3K 3000 1800 30 80 600MM(L)x600MM 600MM(L)x900MM(W) x780MM+75MM x780MM+75MM Legs(H) Legs(H)
2 M-03/4K 4000 2400 30 120 750MM(L)x600MM(W) 750MM(L)x600MM(W) x780MM+75MM x 780MMx75MM Legs(H) Legs(H) 3 M-03/6K 6000 3600 125 160 1150MM(L)x600MM(W) 1150MM(L)x600MM(W) x780MM+75MM x780MM+75MM Legs(H) Legs(H) 4 M-03/7K 7000 4200 125 200 1300MM(L)x600MM(W) 1300MM(L)x900MM(W) x780MM+75MM x780MM+75MM Legs(H) Legs(H) 5 M-03/8K 8000 4000 125 240 1450MM(L)x600MM(W) 1450MM(L)x900MM(W) x780MM+75MM x780MM+75MM Legs(H) Legs(H) 6 M-03/12K 12000 7200 125 320 1150MM(L)x600MM(W) 1 150MM(L)x600MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
7 M-03/14K 14000 8400 125 400 1300MM(L)x600MM(W) 1300MM(L)x600MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
8 M-03/16K 16000 9600 125 400 1450MM(L)x600MM(W) 1450MM(L)x900MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
9 M-03/18K 18000 10800 250 480 1700MM(L)x600MM(W) 1700MM(L)x900MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
10 M-03/20K 2000 12000 250 480 1850MM(L)x600MM(W) 1850MM(L)x600MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
11 M-03/22K 22000 13200 250 560 2000MM(L)x600MM(W) 2000MM(L)x600MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
04
DIMENSION TABLE
12 M-03/24K 24000 14400 250 640 2150MM(L)x600MM(W) 2150MM(L)x900MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
13 M-03/26K 26000 15600 250 640 2400MM(L)x600MM(W) 2400MM(L)x600MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
14 M-03/28K 28000 16800 250 720 2550MM(L)x600MM(W) 2550MM(L)x900MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
15 M-03/30K 30000 18000 250 720 2700MM(L)x600MM(W) 2700MM(L)x900MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
16 M-03/32K 32000 19200 250 800 2850MM(L)x600MM(W) 2850MM(L)x900MM(W) x1560MM+75MM x1560MM+75MM Legs(H) Legs(H)
05
Customized easy installation
Coupled with VFD enabled Humidin make Aerofoil Plug
Fan Having options of Four side discharge
Easy maintenance
Advanced two stage electrostatic precipitation
Odor neutralizer available as an option
Compatible with Building Management
System (BMS)
No water hassles
DRY SCRUBBER SPECIFICATION
SPECIFICATION REMARK
HE 95%+/-2% as per ASHRAE Test Modules 1800-
2400 CFM
standard construction 16G CRCA powder coated
sheetsSingle door access with safety interlocksBottom
sheet with slope of 1/4" per foot for easy drainage3 "
drain nipple
C Channel for easy monting with lifting lugs
standard is powder coating in case of CRCA sheets
Normal practice is to offer standby Humidin make
modules instead of auto-washing system and the later is
not found very effective after 2-3 cycles
Two stage - dual voltage plate type. HE 93-97% as per
ASHRAE test for dry particulates. Single pass
arrangement
One piece construction 13.58" deep. All support
framing, end plates & ionizer ground electrodes in 16G
th Al. Repelling & Collector plates 22G th Al & 9.5" deep
in direction of air ow. Spacing between plates 0.23".
Ionizing electrodes 16G Stainless steel spiked type.
Support insulators Teon. High voltage connection
between cells to be automatically made when cells are
installed.
100% solid state. 200-240V AC 50 Hz, 1 phase input.
Output - (+)12 to 13 KV DC for ionizer and (+) 6 to
6.5KV DC for collector. Out put of 5 mA/20mA to be
ensured for optimum performance. Electrical safety
interlock to prevent access to high voltage components.
can operate from -32Deg to 140 Deg, self-protecting,
LED indicator for performance status. Bleed resistance
to remove stored charge. Module capacity above 3000
CFM to be equipped with CVT to maintain constant
charge even in case of uctuations in input supply. Power
consumption 50W per cell (max). High volatge power
cabb les to be cont inuous w/o any sp l i c ing
Equipment Description
Unit Housing
Base Construction
Surface Finish
Cell Wash Module
Electrostatic
Precipitator Module
Ionizing-collecting Cells
Power Supplies
16G zinc coated sheet can be offered on
demand
epoxy painting with 3 mil min. thickness
can be offered on demand
Auto-wash system having the chamber
with metal mesh prelters, wash
manifolds and header can be offered on
demand
06
THE ENTIRE DRY SCRUBBER HAS TO BE PACKAGED TYPE SCRUBBER WHERE AN ESP MODULE, HIGH VOLTAGE
POWER PACK, FILTER HAS TO BE SOURCED FROM A SINGLE VENDOR. THE ENTIRE PACKAGED TYPE SCRUBBER
FACTORY FITTED HAS TO BE SUPPLIED AT SITE WELL ASSEMBLED FOR ITS BEST ALIGNMENT.
NOTE
System Controls
Automatic Timer clock
Water wash/ Detergent
System
Static Pressure Drops
Adsorber module
Fan
In case of standby cell type arrangement, these controls
are not needed. Only replacing standby clean cells with
saturated once and then cleaning those outside.
In case of auto-wash system only, it is provided.
Detergent wash & Rinse through manifolds located on
air entering as well as air leaving side of cells (Optional or
as specied in BOQ). Humidin make Spray nozzles with
cone shape pattern. Pre-package of detergent reservoir,
motor, pump with adjustable detergent volume setting.
Pump 0.75KW, self priming, positive dispalcement, min
6GPM @ min 50 PSIG output pressure. Main line
strainer & solenoid valves are included. 30 Gallon
detergent tank for remote mounting. Consumption per
cell - 2GPM and avg. 3.5 min wash cycle.
Total drop 10 mm WG maximum including pre & after
lters in clean condition
UV light/Carbon Filter system for odor absorption as
extra accessory
The fan has to be highly efcient able to perform at high
pressures, non-overloading type Aerofoil Plug
connected with a VFD or Centrifugal Backward Aerofoil
DIDW/SISW type attached to the Scrubber Module
Auto-washing system - Consist of
Sequential t imer to take care of
detergent wash, rinse, dry & back to
normal operation. Manual/timer control
provided for the cycle. Remote Reset to
resume normal operation provided.
Offered on demand as optional system
07
Delhi, Mumbai, Bangalore, Kolkata and have wide dealer network across the country.WE ARE ALSO IN :
A.C. HUMIDIN AIR SYSTEMS
B-6, Sector A3, Tronica City, Loni, UP – 201102Ph.: 9654452921, 9650375541 Tel.: 0120-2696683/84Email: [email protected], [email protected]
The intention of this brochure is to introduce you to, and acquaint you with the capabilities of the HUMIDIN organization in
the offered product areas. It will not answer all your immediate questions, and indeed, it will no doubt raise others. We
welcome your interest in our products and shall be very pleased to provide further information.
GUARANTEEHUMIDIN guarantees its products to be free of defects in materials and workmanship for a period of one year from the date
of delivery from the factory, provided motors are properly installed with overload protector. HUMIDIN agrees to repair or
replace defective parts or part to be returned to the factory, all transportation charges prepaid. HUMIDIN does not
guarantee against abrasion, corrosion or erosion. HUMIDIN shall not be held responsible for any charges in connection with
the removal or replacement of alleged defective equipment not for incidental consequential damages.
In accordance with our policy of continual improvement in design, we reserve the right to depart from the details given in this
brochure.