DP-XMC-5010 Quad Serial FPDP / Aurora XMC / PMC Module€¦ · The PCI 9656 IO accelerator present...
Transcript of DP-XMC-5010 Quad Serial FPDP / Aurora XMC / PMC Module€¦ · The PCI 9656 IO accelerator present...
KEY FEATURES AND BENEFITS
PPLICATIONS
iSFPDP Iink upto 2.5 Gbps
• Aurora Iink upto 3.6 Gbps
• Single and Multi Mode Optical Iink
• x4 PCIe XMC Interface
• 64bit / 66MHz PCI bus interface
• Virtex5 Xilinx FPGA for generation and reception of SFPDP / Aurora
• Upto 256MB DDR2 SDRAM used as FIFO
• A ir cooled and conduction cooled option.
• Standard XMC / PMC form factor
• ow power consumption
• H/W & S/W Configuration Management
•VxWorks, Linux Windows
•
•
•
•
•
L
and
Built In Self Test
A
iDigital signal processing
Radar and sonar
Medical Imaging
Range and telemetry systems
Video production
DP-XMC-5010 Quad Serial FPDP / Aurora XMC / PMC Module
22
DESCRIPTION
AURORA
SERIAL FRONT PANEL DATA PORT (SFPDP)
SOFTWARE SUPPORT
DP-XMC-5010 is a High speed data acquisition Module .It supports High speed Serial FPDP (Front Panel Data Port) / Aurora Protocol. Board available in PMC/XMC form factors.The data were transmitted in the form of optical signals through 4 optical transceiver. The data transmission was achieved by using GTP/GTX Rocket I/O of Virtex-5 FPGA.
Smooth data flow is ensured using a 256MB of DDR2 SDRAM to provide each data-stream with 64MB of FIFO buffering. The PCI 9656 IO accelerator present in the module for PMC PCI interface. XMC interface supports x4 PCI express. Supports Single/Multi Mode optical interface on front panel or Copper interface on Rear XMC IO.
Aurora is a scalable, link-layer protocol used to move data across point-to-point serial links. It provides a transparent interface to the physical serial links, allowing upper layers of proprietary or industry-standard protocols to easily use these high-speed serial links. This module supports 3.6 Gbps link speed. Supports point to point interface. • Built-in Flow control • High bandwidth transmission limited only by SERDES data rate capability
Serial FPDP extends the maximum distance of FPDP connections by serializing the FPDP data stream and transmitting it over extended distance using copper or fiber optic cable.
• Four independent point-to-point data streams to the host• Link speed is field configurable• All Serial FPDP (sFPDP) operational topologies are supported including point-to-point data
streams, copy and copy/loop modes.
The module is supported with complete device drivers in Windows, Linux and Vxworks.
Virtex5 FPGA
MEMORYSDRAM INTERFACE
IO INTERFACE
PMC INTERFACE
XMC INTERFACE
FIBRE OPTIC LINK
CONNECTORS
LX30T• Distributed RAM 320• DSP Slices 32• Total Block RAM 1296• Rocket IO™ GTP Low-Power Transceivers 8
• Distributed RAM 380• DSP Slices 64• Total Block RAM 2448• Rocket IO™ GTX High-Power Transceivers 8
• Up to 256 MB••
• e with options
•
••
•• 50/125 µm MMF Cable
•
• Field (J6)
FX30T
Used as FIFO Operates at clock speed 200MHz
Four Optical transceiver on the front pan l - 2.5 Gbps Multi and Single Mode @ 247MB/sec Bandwidth
- 3.6 Gbps Multi and Single Mode @ 350 MB/Sec BandwidthRear Option for XMC Interface
• 64 bit 66MHz on PCI bus• 32-bit, 66 MHz on Local Bus• Sustained Bandwidth of 186 MB/sec
x4 PCIe Interface @ 2.5GHzProvide optional copper connect interface
Supports LC to LC Link
Board Interface XMC connector (J5)PMC connector ( J1,J2,J3)
Interface XMC connectorOptical Transceivers
SPECIFICATIONS
POWER
DIMENSIONS
ENVIRONMENT
ORDERING INFORMATION
5V, +3.3V(PMC) VPWR 12V or 5V, 3.3V (XMC)10 W (With out PMC)
•
• Module Air cooled version
Board Dimensions XMC standard boardDimension (L x B) - 74 x 149(mm)
Conduction cooled version available(In Conduction cooled Rear IO will have Copper Interface only)
Commercial and Rugged versions
NOTE:
* For conduction cooled and Air cooled Rear I/O option, only 9 should be selected
# Not applicable for PMC interface
3 – Air cooled Front IO6 – Conduction cooled
9 – Air cooled Rear IO #
3 – XMC Interface6 – PMC Interface
9 – XMC and PMC Interface
0 – None3 – 128 MB DDR2
6 – 256 MB DDR2
0 - Reserved
0 - 33 - 2
6 - 1
BLANK - 4
9 - 0
0 – 4Gbs TX/RX – Multi Mode
3 – 2.5Gbs TX/RX – Single Mode
6 – 4Gbs TX/RX – Single Mode
BLANK – 2.5Gbs TX/RX – Multi Mode
9 – 0
DP XMC 5010 X X X X X X X(*) X(*)
3 – Commercial Temperature Range
6 – Rugged Wide Temperature Range
OPTICAL SPEED AND MODE
OPTICAL CHANNELS
DDR2 SDRAM
INTERFACE
3 – Non-Intelligent/SFPDP
9 – Non-Intelligent/Aurora
PROTOCOL
BOARD TYPE
TEMPERATURE
DP-XMC-5010
23
B
DP-XMC-5010
24
BLOCK DIAGRAM OF DP-XMC-5010