Do's & Don'ts in QC Lab

16
SAFETY OBJECTIVES, DO’S AND DON’TS IN QUALITY CONTROL LAB Ayan Malik Senior Executive Quality Bangalore Unit RMX Whitefield 2 (NS37) [email protected] Mobile No : +919620003261 Strength Performance P novative Concrete Solutions, Proudly Delivered By People You Can Tru

Transcript of Do's & Don'ts in QC Lab

Page 1: Do's & Don'ts in QC Lab

SAFETY OBJECTIVES, DO’S AND DON’TS IN QUALITY CONTROL LAB

Ayan MalikSenior Executive Quality

Bangalore UnitRMX Whitefield 2 (NS37)

[email protected] No : +919620003261

Strength Performance Passion

Innovative Concrete Solutions, Proudly Delivered By People You Can Trust

Page 2: Do's & Don'ts in QC Lab

INTRODUCTION

Page 3: Do's & Don'ts in QC Lab

I CARE, I SHARE, I ACT…

Safety is our first priority. And it begins with me.

You are a step away from hazard, if you work without safety.

Work is pleasure,With safety measure…

Page 4: Do's & Don'ts in QC Lab

ELABORATION

Page 5: Do's & Don'ts in QC Lab

WHY IS LABORATORY SAFETY IMPORTANT?TO PREVENT

oAdverse health effects from exposure to chemicals.

oExposure to organisms, diseases, etc. in laboratories.

oLaboratory equipment hazards - if not maintained properly.

LABORATORY PROCEDURES MUST BE SITE SPECIFIC !

Based on lab needs, conditions, and equipments

Page 6: Do's & Don'ts in QC Lab

AREAS TO COVER…

1. General procedures or rules2. Glassware3. Material handling and care4. Equipment5. Safety equipment6. Electrical safety7. Disposal procedures8. Emergency response plans9. Inspections10. Awareness program

Page 7: Do's & Don'ts in QC Lab

NORMAL RULES…

1. No food or drink allowed inside the laboratory.2. Individuals are not allowed to work in the laboratory alone.3. Wear required personal protective equipments.4. No smoking No drinking in laboratory.5. Maintain good housekeeping habits.6. Make proper leveling for every chemical, for drinking water

also.

Page 8: Do's & Don'ts in QC Lab

DO’S & DON’TS

Page 9: Do's & Don'ts in QC Lab

DO’s & DON’Ts…

Do’s• Read instrument handling manuals• Read MSDS of every material• Use hand gloves while handling admixture

or any chemical• Keep clean your working area before and

after work done• Clean and place instruments in proper

area after finishing your work• Lift cubes using only cube lifter• Wear PPE and aware others

Don’ts• Stack cubes more than three as a column

form• Plug in any bare electrical wire in plugs• Put bare hand inside of cement,

cementitious material, concrete• Run CTM without proper locking of front

safety gate• Spit inside of plant and your surroundings • Make floor slippery• Work after consuming drug or alcohol

Page 10: Do's & Don'ts in QC Lab

WHITEFIELD QC LAB…

PROPER HOUSE KEEPING PROPER HOUSE KEEPING

Page 11: Do's & Don'ts in QC Lab

WHITEFIELD QC LAB…

CUBE STACK AFTER TESTING CUBE STACK BEFORE TESTING

Page 12: Do's & Don'ts in QC Lab

WHITEFIELD QC LAB…

CUBE LIFTER FOR SAFE LIFTINGSAFETY CHAIN FOR PAN MIXER

Page 13: Do's & Don'ts in QC Lab

WHITEFIELD QC LAB…

WARE GLOVES FOR OVEN RUBBER GLOVES FOR ACT

Page 14: Do's & Don'ts in QC Lab

WHITEFIELD QC LAB…

PROPER PLUG SOCKET DISPLAY OF INSTRUCTIONS

Page 15: Do's & Don'ts in QC Lab

WHITEFIELD QC LAB…

CLOSE CTM SAFETY DOOR SAFETY CHAIN FOR PAN MIXER

Page 16: Do's & Don'ts in QC Lab

Strength Performance Passion

Innovative Concrete Solutions, Proudly Delivered By People You

Can Trust