DoorKing Part Number METAL OUTDOOR ENCLOSURE FOR RF …
1
METAL OUTDOOR ENCLOSURE FOR RF RECEIVER 8057-066-A-3-16 DoorKing Part Number 8057-110 Copyright 2016 DoorKing, Inc. All rights reserved. Metal outdoor enclosure that is lockable to secure and help protect RF receiver from the elements. Includes (4) four screws to mount RF receiver inside box and (2) two 90° “F” connectors. The RF receiver, antenna kit, all conduit and coax cable are NOT included. 3/4” Conduit and watertight conduit fittings (Not included) 90° “F” Connector Antenna (Not included) 18” Coax Cable (Not included) “F” Connector (Not included) 90° “F” Connector Knockout Knockout 4 Receiver Mounting Screws Mount box to wall using the 4 existing holes with appropriate hardware (not included). DO NOT drill any extra holes in the box. This will help protect the receiver from the weather. Note: Make sure antenna is NOT surrounded by metal and is in free air as high as possible above the ground. Remove protective cover with rubber washer and discard when mounting antenna directly on top of metal box. Note: The protective cover can remain in place when mounting the antenna away from the box (15 ft coax cable antenna kit P/N 1514-073) to help keep the box sealed up from the weather by running the coax cable through the conduit if desired. Input Wiring Output Wiring 120 S. Glasgow Avenue Inglewood, California 90301 U.S.A.
Transcript of DoorKing Part Number METAL OUTDOOR ENCLOSURE FOR RF …
METAL OUTDOOR ENCLOSURE FOR RF RECEIVER
8057-066-A-3-16
DoorKing Part Number
8057-110
Copyright 2016 DoorKing, Inc. All rights reserved.
Metal outdoor enclosure that is lockable to secure and help protect RF receiver from the elements. Includes (4) four screws to mount RF receiver inside box and (2) two 90° “F” connectors. The RF receiver, antenna kit, all conduit and coax cable are NOT included.
3/4” Conduit and watertightconduit fittings (Not included)
90° “F”Connector
Antenna (Not included)
18” Coax Cable (Not included)
“F” Connector(Not included)
90° “F”Connector
Knockout
Knockout
4 ReceiverMountingScrews
Mount box to wall using the 4 existing holes with appropriate hardware (not included). DO NOT drill any extra holes in the box. This will help protect the receiver from the weather.Note: Make sure antenna is NOT surrounded by metal and is in free air as high as possible above the ground.
Remove protective cover with rubber washer and discard when mounting antenna directly on top of metal box.Note: The protective cover can remain in place when mounting the antenna away from the box (15 ft coax cable antenna kit P/N 1514-073) to help keep the box sealed up from the weather by running the coax cable through the conduit if desired.
Inpu
t Wiri
ng
Outp
ut W
iring
120 S. Glasgow AvenueInglewood, California 90301 U.S.A.
