Dm800 Tuner Fix Revised
description
Transcript of Dm800 Tuner Fix Revised
-
DM800 tuner modyfication rev j and rev k
whats needed
1x capacitor 1000uF/16V
1x capacitor 22uf/25V 5%
1x FDN359AN transitor to be fitted at Q3 place on tuner ( if you have transittor 00A93 skip this step)2x si2301 bds to be fitted at Q1,Q2 on tuner ( if finded Q3 00A93 skip this step)
remove this capacitor
remove C111 and fit 22uf/25V
transistors Q1,Q2
Q3 replace if diffrent then 00A93, it says on top of it
leave this resistor or fit 0,2Ohm 0.25W resistor
1000uF/16V
1000uF/10V
Simple way if Q3 is 00A93 just remove C1 and add 1000uf/10V in this way
You dont need to fit this capa this is only the option
why in this way?? smd capa 1000uf usually has around 1000uf or = 1000ufthis kind of capacitor usually has a little more capacitancy around 1100uf instead of smd one.
.
If you are using flux, clean it after the job is done!!
.
This is demo version of pdf editor, dont complain quality ! and water marks
FDN359AN will give boost to snr about 4%, agc 2% and it should sort out
problems with cheap dish motors which had si2302ads
Changed with the DEMO VERSION of CAD-KAS PDF-Editor (http://www.cadkas.com).
Changed with the DEMO VERSION of CAD-KAS PDF-Editor (http://www.cadkas.com).
Changed with the DEMO VERSION of CAD-KAS PDF-Editor (http://www.cadkas.com).