Disassembling Motorola V180 Connectorribbon/inside screen cover

Written By: Tyler Knisley

Disassembling Motorola V180 Connector ribbon/inside screen cover Draft: 2017-11-24Guide ID: 2888 -

This document was generated on 2019-11-19 07:48:40 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5

INTRODUCTION

Disassembling top half to get to connector ribbon, inside screen, and speaker.

TOOLS:Soldering Iron (1)T6 Torx Screwdriver (1)Spudger (1)

Disassembling Motorola V180 Connector ribbon/inside screen cover Draft: 2017-11-24Guide ID: 2888 -

This document was generated on 2019-11-19 07:48:40 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5

Step 1 — Connector ribbon/inside screen cover

Pull at top of faceplate, and it willpop off.

Step 2

Unscrew four screws on front cover.

Disassembling Motorola V180 Connector ribbon/inside screen cover Draft: 2017-11-24Guide ID: 2888 -

This document was generated on 2019-11-19 07:48:40 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5

Step 3

Slide out metallic silver cover.

This piece is wedged in tight. Try toslide out one hook at a time, insteadof both simultaneously.

Step 4

Use a tool to wedge in between thesilver and black parts on the cover.

Silver part should now snap off.

Disassembling Motorola V180 Connector ribbon/inside screen cover Draft: 2017-11-24Guide ID: 2888 -

This document was generated on 2019-11-19 07:48:40 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5

To reassemble your device, follow these instructions in reverse order.

Step 5

Black rubber part may now be easilyremoved.

Step 6

Use a soldering iron to disconnectthe connector ribbon from thephone.

Disassembling Motorola V180 Connector ribbon/inside screen cover Draft: 2017-11-24Guide ID: 2888 -

This document was generated on 2019-11-19 07:48:40 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5