Disassembling Keurig Mini B-31 ArmPREREQUISITE ONLY

Written By: Andrew Adriance

Disassembling Keurig Mini B-31 Arm

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5

TOOLS:Phillips #1 Screwdriver (1)

Disassembling Keurig Mini B-31 Arm

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5

Step 1 — Arm

With the needle removed, open thedevice by pulling up on the handle.

Step 2

Push in on one of the arms attached to the K-cup holder plastic housing to remove it from its rails.The arms are identical for both sides so once one side is free repeat the process for the secondside.

The plastic is flexible and will not snap with the force applied.

Once the arms are removed, the configuration should look like the picture. The K-cup holderhousing should be separated from the arms.

Disassembling Keurig Mini B-31 Arm

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5

To reassemble your device, follow these instructions in reverse order.

Step 3

Use a Phillips #1 screw driver toremove the four 12 mm screws thathold the arm assembly in place.

Step 4

Lift up the arm and pull up the handle assembly. It should easily come off.

This white tab falls off easily, remove it and set it aside to ensure it is not lost.

Disassembling Keurig Mini B-31 Arm

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5

This document was last generated on 2017-06-17 06:26:21 AM.

Disassembling Keurig Mini B-31 Arm

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5