Directions for how to use clearbore to remove iron oxide in your waterbore

Directions onHow to RemoveIron BacteriaFromYour Bore

FrequentlyAsked Questions

Bore Casing & Screens Pipes & Components Environmental Drilling Water Treatment Safety Products Sand Spears Pumps

Directions for usingClearbore

1300 133 000 0457 819 610 www.deps.com.au



1300 133 000 0457 819 610 www.deps.com.au

Before After



1300 133 000 0457 819 610 www.deps.com.au

After treating a fully blocked pump with Clearbore I was completelysurprised, as the pump went from being 100% blocked back to it'soriginal flow, as it was when new.

Off all of the farmers who haveused Clearbore treatment on their blocked bore's, not one have complainedthat it didn't workthat's a 100 % success rate

Michael

Agmek - Ballarat



For smallerStock and Domestic

or Irrigation bores

1300 133 000 0457 819 610 www.deps.com.au

Part 1



For largerHigher Flow

Irrigation bores

1300 133 000 0457 819 610 www.deps.com.au

See Part 2 for



hat sort of locations are good candidates for sand spear use?

1300 133 000 0457 819 610 www.deps.com.au

Part 1Smaller

Stock and Domestic or

Irrigation bores



Questi11on 1 -

hat sort of locations are good candidates 1- approx 200 Lt. plastic drum

2- ball valve

3- 2 lengths of clear hose

1300 133 000 0457 819 610 www.deps.com.au

Equipment needed



Questi11on 1 -

hat sort of locations are good candidates 4- snap on hose fittings or hose barbs

5- paddle or stirrer

1300 133 000 0457 819 610 www.deps.com.au

Equipment needed




1300 133 000 0457 819 610 www.deps.com.au

Step 1 Fit ball valve to drum on the bottom

discharge.

Connect one of the lengths of tube




1300 133 000 0457 819 610 www.deps.com.au

Step 2

Disconnect outlet pipe at the top of

the bore




1300 133 000 0457 819 610 www.deps.com.au

Step 3

Connect one of the hoses to the

outlet of the well head




1300 133 000 0457 819 610 www.deps.com.au

Step 4

Put the hose coming from the

bottom of the tank into the bore.

Allowing the water to return.



1300 133 000 0457 819 610 www.deps.com.au

Step 5

Elevate the plastic

drum, so the water will

flow down the bore



1300 133 000 0457 819 610 www.deps.com.au

Step 6

Close valve on tap

Fill drum with water to

within 300mm from top


1300 133 000 0457 819 610 www.deps.com.au

Step 7

Mixture Ratio for

Clearbore to water is

approx –

1kg per 10Litres of

water



1300 133 000 0457 819 610 www.deps.com.au

Step 8

Pour amount of Clearbore

needed, into drum and stir

continuously.

For amount of Clearbore

needed, go to

www.deps.com.au and

click onto formulae's

http://www.deps.com.au/



1300 133 000 0457 819 610 www.deps.com.au

Step 9 Once Mixed –

Turn on the bore pump

Open the valve on the tank

Keep stirring

Allow mixture to enter the

bore



1300 133 000 0457 819 610 www.deps.com.au

Step 10

Allow the circulation

process to go for 6 hrs.

Control the flow into the

tank by the valve on the

well head


1300 133 000 0457 819 610 www.deps.com.au

Step 11

If more than one tank of mixture

is needed

Please follow steps 7 - 10


1300 133 000 0457 819 610 www.deps.com.au

Step 12

When the treatment time is

over- allow the treated

water to run over the

ground or remove by a

waste system


1300 133 000 0457 819 610 www.deps.com.au

Step 13

If you have a piping

reticulation system the

mixture can run through

this.


1300 133 000 0457 819 610 www.deps.com.au

Note

Do not put treated water

through a sprinkler system.


1300 133 000 0457 819 610 www.deps.com.au

Step 15

After the treatment

Test the water if used for

Stock and domestic.


1300 133 000 0457 819 610 www.deps.com.au

Larger Flow Bores

Part 2


1300 133 000 0457 819 610 www.deps.com.au

Diesel Bore Pumps


1300 133 000 0457 819 610 www.deps.com.au

1- Determine the Amount

of Clearbore.

2 - Pour Solution into the

Bore

3 – Turn on the pump

immediately


1300 133 000 0457 819 610 www.deps.com.au

4 – Surge the Water in the

bore

5 – By using engine throttle

speed up and down

6 – surge as much as

possible over 12 hrs


1300 133 000 0457 819 610 www.deps.com.au

7 – No water is to leave the

bore during process

8 – Finish process

9 – Pump treated water to

waste



Question 1 -


1300 133 000 0457 819 610 www.deps.com.au

Electric Bore

Pumps


1300 133 000 0457 819 610 www.deps.com.au


of Clearbore.


Bore

3 – Turn on the pump

immediately


1300 133 000 0457 819 610 www.deps.com.au

4 – Surge the Water in the bore

5 – By turning the motor off and on

(Check number of starts per hr allowed

Go here http://www.franklin-electric.com/aim-manual/page-3.aspx

6 – surge as much as possible over 12 hrs

http://www.franklin-electric.com/aim-manual/page-3.aspx


1300 133 000 0457 819 610 www.deps.com.au


bore during process



waste


1300 133 000 0457 819 610 www.deps.com.au

No Pump in the Bore


1300 133 000 0457 819 610 www.deps.com.au


of Clearbore.


Bore

3 – Surge Bore


1300 133 000 0457 819 610 www.deps.com.au

Surge, by using a drilling rig

connected to a Surge Block

or Brush

For 6 hrs


1300 133 000 0457 819 610 www.deps.com.au


bore during process



waste



Question 1 -


1300 133 000 0457 819 610 www.deps.com.au

Thank you for taking the time to look at the information we have created for you,We hope this will be of assistance to solving your piping, drainage , cleaning and drilling challenges.

If you have any more questionsPlease feel free to contact myself or one of our team



Question 1 -


1300 133 000 0457 819 610 www.deps.com.au

• For more Information

• go to www.deps.com.au

• 0r contact us on

• 1300 133 000

• 0457 819 610

• [email protected]



Question 1 -


1300 133 000 0457 819 610 www.deps.com.au

Deps Products

& Capabilities



Question 1 -


1300 133 000 0457 819 610 www.deps.com.au

Solving your Piping, Drilling, Water and Drainage

Challenges

with Trust and Integrity

Directions for how to use clearbore to remove iron oxide in your waterbore

Business

Transcript of Directions for how to use clearbore to remove iron oxide in your waterbore