SURE GRIP MARK 3 BELT CLAMP

VSP SITE, VISAKHAPATN

AM

SURE GRIP MARK 3 BELT CLAMP

2 Left Side Clamps

4 AluminumBeams, 2500mm

Long

2 Right Side

ClampsTorque

Wrench, Value - 50 N/M to

225 N/M

SURE GRIP MARK 3 BELT CLAMP

Jack Screw (Maximum Screw Tension 160 N/M)

Instructions for Use displayed on each

Clamp

SURE GRIP MARK 3 BELT CLAMP

Tightening Setting

loosening Setting

Torque Wrench

Torquing Value Setting

SURE GRIP MARK 3 BELT CLAMP

Left Side Clamp Right side Clamp

Aluminum Beams

Torque Wrench

Safe Working Load marked on each Aluminum Beams

SURE GRIP MARK 3 BELT CLAMP

Guidelines for using Clamps –

Clamp Ends should be pushed in as close to the belt as possible.

It is not necessary to over tighten the JACK SCREWS as 9 CN/M is approximately 4 tonne force on the screw.

WLL (Work Load Limit) limits apply for each lug when appropriate chains and slings are used on the pulling lugs provided.

When clamps are butted up against stops or structure the supports should be no more than 30mm from each edge of the belt.

The handle has a threaded screw nut for easy removal.