FIRST SLIDE BOOT AND HOUSING ONTO THE CABLE.

B

STEP 3

ASTEP 2

STRIP BACK OUTER COATING OF THE CABLE TO 7.0mm7.0

2 DETAIL A

SCALE 2 : 1

STEP 5

STEP 6

SLIDE HOUSING AND BOOT INTO PLACE SO PINS ARE IN THE CORRECT POSITION.WITH BOTH HOLES PARALLEL EACH OTHER.

COMPLETE WIRED CONNECTOR

CLIP IS ONLY FITTED TO THE590 AND 591 SERIES.FOR 592 SERIES COLLAR IS FITTED BEFORE THE SCREW.ALL OTHERS JUST THE SCREW IS FITTED.

DETAIL B SCALE 2 : 1

SLIDE PROTECTIVE SLEEVE OVEREXPOSED WIRES BEFORE SOLDERING IF REQUIRED.(SLEEVE NOT SUPPLIED) THEN SOLDER WIRES TO PINS AS SHOWN

CSTEP 4

REFER TO CONNECTOR SPECIFICATION FORWIRING TERMINATIONS.

DETAIL C SCALE 2 : 1

SLIDE PROTECTIVE SLEEVE OVER SOLDERED CONNECTION AND FIT BRACKET AS SHOWN.

HOLE FOR DRAIN WIRE

METAL PART OF THE PIN INSERT

STEP 1

Max Cable: 6mm DiameterMax Conductor: 1.0mm Diameter

IF NO DRAIN WIRE. FOLD OUTER CABLE SHIELD BACK& CLAMP TO METAL PIN INSERT. OR USE HALF OF THE SHIELD TIGHTLY TWISTED TO FORM A DRAIN WIRE & SOLDERTO THE SMALL HOLE IN THE PIN INSERT.

DIN CONNECTORWIRING

TITLE

DIN CONNECTORDRAWING NO.

Release05ISSUE

UNLESS OTHERWISE SPECIFIED:DIMENSIONS ARE IN MILLIMETRESLINEAR TOLERANCE:NO DECIMAL PLACES 0.5mm1 DECIMAL PLACE 0.25mm2 DECIMAL PLACES 0.125mmANGULAR TOLERANCE: 1

DRAWN BY

APPROVED BYSPB

THIRD ANGLE PROJECTION

SCALE 1:1

A3

SHEET 1 OF 1

.

.

MATERIAL

FINISH DEBURR AND BREAK SHARP

EDGES

IF IN DOUBT ASKDO NOT SCALE DRAWING

PROPRIETARY AND CONFIDENTIALTHE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OFALPHA 3 MANUFACTURING. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF ALPHA 3 MANUFACTURING IS PROHIBITED.

DEM Manufacturing, Deltron Emcon HouseHargreaves Way, Sawcliffe Ind. Park,Scunthorpe, North Lincolnshire, DN15 8RF, UK

.

A

D

E

C

B

1 4 62 5 73

B

C

D

E

A

. INSTRUCTIONSWC

Tel No.+44(0)1724273200 Website www.dem-uk.com