Department of Information Technology – Wireless & Cable
description
Transcript of Department of Information Technology – Wireless & Cable
![Page 1: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/1.jpg)
Department of Information Technology – Wireless & Cable
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment Tool
Future Network & Mobile Summit 2013July 5, 2013 [email protected]
ir. Margot DeruyckProf. dr. ir. Wout Joseph
Dr. ir. Emmeric TangheProf. dr. ir. Luc Martens
Ghent University/iMinds
![Page 2: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/2.jpg)
Context & objective Methodology Case Study Conclusion
Overview
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
![Page 3: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/3.jpg)
Context & objective (1)
Taking user capacity demands into account to reduce power consumption in wireless access networksMargot Deruyck – Department of Information Technology – Wireless & Cable
Extreme growth of mobile users the past few years From 20% in 2003 to 67% in 2009
Within ICT 9% is consumed by radio access networks
Within radio access network 90% consumed by base stations 10% consumed by user devices
→ Focus on base stations to reduce power consumption in wireless
access networks!!!
![Page 4: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/4.jpg)
Context & objective (2)
Objective Deployment tool for the design and optimisation of
future energy-efficient wireless access networks Key technique: sleep modes
– Network responds to the actual bit rate demands of users
Applied on a realistic case in Ghent, Belgium Investigating three main functionalities added to LTE-
Advanced– Carrier aggregation– Heterogeneous network– Extended support for MIMO
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
![Page 5: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/5.jpg)
Context & objective Methodology Case study Conclusion
Overview
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
![Page 6: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/6.jpg)
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
Power consumption model
Macrocel
Transceiver 100 W
Power amplifier 156.3 W
Digital signal proc. 100 W
Rectifier 100 W
Air conditioning 225 W
Backhaul 80 W
TOTAL 1673.9 W
Femtocel
Transceiver 1.7 W
Power amplifier 2.4 W
Microprocessor 3.2 W
FPGA 4.7 W
TOTAL 12 W
![Page 7: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/7.jpg)
Energy efficiency metric:
with A = the area covered by the network (in km2) Pi = the power consumption of base station i (in W) Bi = the bit rate offered by base station i (in Mbps)
The higher EE, the more energy-efficient
[Mbps/W]
Methodology
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
![Page 8: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/8.jpg)
Phase 1: generating trafficDeployment tool (2)
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
User distribution Poisson distribution with arrival rate λ(t)
λ(t) = sinusoidal curve scaled based on the population density
Integrated over the time interval
Duration distribution Lognormal distribution
μ = 1.69s s= 1.0041
Geometric distribution Users are uniformly distributed over the
considered area Bit rate distribution
20%: 2 Mbps (mobile PC) 5%: 1 Mbps (tablet) 50%: 250 kbps (smartphone) 25%: 0.64 kbps (voice only user)
![Page 9: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/9.jpg)
Deployment tool (5) Part II: traffic-based network design
dƌĂĨĨŝĐĨŝůĞƐ
dŝŵĞƐƚĂŵƉƚ ŝ
ŝсϭ ;ŝс Ŷϭ Ϳ
hƐĞƌƵ ŝũ
ũсϭ ;ũс ŵϭ Ϳ
K ƌĚĞƌĂĐƚŝǀ Ğ ƐďLJƉĂƚŚůŽƐƐ ƚŽ Ƶŝũ
ĂƐĞƐƚĂƚŝŽŶ^ ŝũŬ
Ŭсϭ ;Ŭс Ɖϭ Ϳ
ĂŶ ƵŝũďĞƐĞƌǀ ĞĚ ďLJ^ ŝũŬ
Yes
Ŭнϭ ч Ɖ No
Ŭнϭ
ĚĚƵ ŝũƚŽƵƐĞƌůŝƐƚ^ ŝũŬ Yes
ũнϭ ч ŵ
ũнϭ
Yes
ŝнϭ ч Ŷ
ŝнϭ
Yes
^dK W
No
No
K ƌĚĞƌŝŶĂĐƚŝǀ Ğ ƐďLJƉĂƚŚůŽƐƐ ƚŽƵ ŝũ
No
ĂƐĞƐƚĂƚŝŽŶ^ ŝũů
ůсϭ ;ůс Ƌϭ Ϳ
ĂŶ ƵŝũďĞƐĞƌǀ ĞĚ ďLJ^ ŝũů
Đƚŝǀ ĂƚĞ ŝũů Yes
ĚĚƵ ŝũƚŽƵƐĞƌůŝƐƚ^ ŝũů
ůнϭ ч Ƌ No
ůнϭ
Yes
E ŽƚƉŽƐƐŝďůĞƚŽƐĞƌǀ ĞƵŝũ
No
D Žǀ ĞĂůƌĞĂĚLJĐŽǀ ĞƌĞĚ ƵƐĞƌƐƚŽ
^ ŝũůŝĨƉŽƐƐŝďůĞ
Try to connect user with active BS Lowest path loss
And lower than maximum allowable path loss Can the required capacity be offered
Otherwise, activate a sleeping BS Same requirements as above When activated: can other already
connected users be transferred?
Otherwise, user can not be covered
![Page 10: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/10.jpg)
Context & objective Methodology Case study Conclusion
Overview
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
![Page 11: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/11.jpg)
Case study (1)
Reference scenario
Designing Advanced Enery-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
LTE-Advanced Suburban area
1.54 km2
Ghent, Belgium
139 macrocell base stations
SISO No carrier
aggregation
![Page 12: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/12.jpg)
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
Results (1) MIMO
For the considered case MIMO does not improve
EE Same coverage Power consumption
MIMO higher than SISO Lower no. BS but
not low enough
![Page 13: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/13.jpg)
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
Results (2) Carrier aggregation
Higher no. of aggregated carriers = higher EE
Higher bit rate available More users served by 1 BS Less BSs needed
Highest efficiency Aggregating 5 carriers Power consumption
reduced by 13.9% on average
![Page 14: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/14.jpg)
Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment Tool Margot Deruyck – Department of Information Technology – Wireless & Cable
Results (3) Heterogeneous deployments Lowest efficiency
Only macrocells Higher power consumption
Highest efficiency Femtocell with MIMO and CA
MIMO increases range CA increases bit rate Low power consumption
Power consumption reduced by 99.3% on average
Compared to only macrocells 88.0% reduction for femtocells
without MIMO and CA For this case
Further research necessary to confirm results!
![Page 15: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/15.jpg)
Conclusion A capacity-based deployment tool for energy-efficient
wireless access network is presented Minimal power consumption Responding to the actual bit rate demand of the user Key technique: introduction of sleep mode
Tool applied on a realistic case in Ghent, Belgium for LTE-Advanced
Average power consumption reduction of 13.9% obtained when aggregating 5 carriers compared to no carrier aggregation
Average power consumption reduction of 99.3% obtained when using femtocells with CA and 8x8 MIMO compared to network with only SISO macrocell base stations
Future networks should use LTE-Advanced Single use case: Further investigation is still needed to confirm
results!Designing Advanced Energy-Efficient Wireless Access Networks by a Capacity Based Deployment ToolMargot Deruyck – Department of Information Technology – Wireless & Cable
![Page 16: Department of Information Technology – Wireless & Cable](https://reader034.fdocuments.us/reader034/viewer/2022051421/56816376550346895dd45526/html5/thumbnails/16.jpg)
Questions?
Taking user capacity demands into account to reduce power consumption in wireless access networksMargot Deruyck – Department of Information Technology – Wireless & Cable