Dehumidifi ers - calor · Dehumidifi ers Take control of humidity and condensation with the...
Transcript of Dehumidifi ers - calor · Dehumidifi ers Take control of humidity and condensation with the...
Dehumidifi ersTake control of humidity and condensation with the Calorex industry leading range of dehumidifi ers
ff ll f d h idifi f i d t i l dd i l li tiffull range of dehumidifi ers for industrial andd ccommercial applications
h t d h ti ti
ffull range of dehumidifiers for industrial andd commercial applications
heat recovery and space heating options
% i d b ii i
heat recovery and space heating options
save up to 75% on running costs and carbon emissssionssave up to 75% on running costs and carbon emiisssions
Corrosion Speedof Steel
With an RH of over 60% the rate of corrosion on steel rises rapidly.At an RH of approximately 50%,
virtually no corrosion occurs.
20 40 60 80 100
3
0
6
9
12
Rus
t inc
reas
e in
55
days
, gra
mm
es p
er s
quar
e m
etre
Relative humidity in %
Atmospheric air contains moisture which is a problem to materials and manufacturing processes
Protect your environmentEven when you cannot see it, moisture in the
form of water vapour is all around us, held in
suspension in the air. The relative humidity of
the air in many cases determines the extent
of corrosion of certain materials, the speed
at which moulds develop and the rate of
increase of bacteria that cause decay.
Most materials and goods are best stored
under cool dry conditions.
A false economyTraditionally the problem was disguised by
the use of heat or ventilation. This process is
exceptionally energy ineffi cient and reliant
on introducing outside air that is generally
not suitable unless expensively heated.
Drying by traditional heating involves
continuously warming a stream of outside
air on a constant ‘in and out’ cycle.
Relative HumidityRelative humidity (RH) is the expression used
to defi ne how much water vapour can be
held in the air at a given temperature as a
percentage of what it could contain at
saturation (100% RH). That is when the
relative humidity reaches the level at
which air can hold no more moisture. The
maximum amount can vary according to
its temperature - warmer air is capable of
holding more moisture than colder air.
THE CHALLENGE
Heating and ventilation is extremely energy ineffi cient and expensive, luckily a solution does exist to make the air drier without heating – Calorex dehumidifi cation
Leaders in our fi eld: Cold stores
Utility buildings
Computer rooms
Switching & power stations
Electronics production
Pharmaceutical production
Manufacturing areas
Process drying
Bottling & food plants
Archives, museums & libraries
Sports halls
Wet clothes drying rooms
Ice rinks
Boiler rooms
Ship building & offshore
Underground rooms
The challenges of excess moisture:
Corrosion
Product deterioration
Condensation
Damp
Mould and mildew
Prolonged drying
Manufacturing delays
Discomfort
How a Calorex Dehumidifier Works
Principles of operation – air to air dehumidifier
Humid Air Dry, WarmAir
Expansion
Evaporator Condenser Compressor
Condensateto waste
20˚C28˚C
80%40%
The Calorex answer to this problem is its wide range of dehumidifi ers suitable for every environment from warehouses and sub-stations to museums and garages
THE SOLUTION!
A better wayDehumidifi cation is much more sophisticated
than heating. It recirculates the same air and
physically removes moisture from it. This
alleviates the need to continuously reheat
incoming air. Not only that, a dehumidifi er
will cleverly convert energy taken out of the
room as moisture (latent energy), to create
‘sensible energy’ that can be used to heat the
room, accelerating the drying process.
Problem solved Our wide range of units and operating
temperatures ensure there is a system to fi t
The process of dehumidifi cation involves moisture-laden air being drawn into a dehumidifi er where the air passes across a refrigerated coil. The air is rapidly cooled below its dew point, condensing the water vapour and recovering its latent heat energy for re-use. The cooled air is then passed across the condenser where it is reheated and returned to the served area at the required lower relative humidity.
every need. From high tech problems
requiring sophisticated ‘total loss’ or ‘keep
dry recirculation’ systems to a simple off
the shelf mobile dehumidifi er to plug in
and go - Calorex are unique problem
solvers in their fi eld.
Drying fl ooded areas or
new buildings
Preservation of buildings,
plant, ships, drilling platforms
& turbines
Applying industrial coatings
Maintaining bridges & locks
Storage of:
- vehicles
- metals
- chemical/technical materials
- electronic & electrical components
- hygroscopic substances
- sugar, salt, coffee, cocoa, herbs,
tea etc.
- timber
- furniture
- ceramics & textiles
- paper & cardboard boxes
- beers, wines & spirits
- fl owers & plants
- livestock & zoo animals
- military plant & equipment
Calorex is the world’s leading designer and manufacturer of industrial and commercial dehumidifi ers
Key benefi ts of a Calorex dehumidifi er:
Energy effi cient
Low temperature operation
Heat recovery to air
Automatic operation
Quality construction
Optional features
Simple installation
Minimal maintenance
Long service life
Comprehensive service network
Environmentally friendly R407C refrigerant
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓Especially for use in:
- Public buildings
- Changing rooms
- Store rooms and stairwells
- Cellars and basements
✓Self contained with fully automatic operation
✓ Integral humidistat
✓Tamper proof controls
✓Epoxy polyester painted zintec steel cabinet
✓Hot gas defrost for low temperature operation
✓Air fi lter
www.calorex.com A wall mounted compact dehumidifi er designed to fi t above a standard doorway
WALLMOUNTEDOTW 15
35˚C
30˚C
25˚C
20˚C
15˚C
10˚C
Litres/24 hours0 5 10 15 20 25 30
40% 50% 60% 70%
80%
1.0
0.9
0.8
0.7
0.6
0.5
0.60
0.55
0.50
0.45
0.40
0.35
*AT 60% RH
SENSIBLE HEATOUTPUT kW* TO AIR
ELECTRICALINPUT kW*
Performance DataOTW 15
• Through the wall version
SPECIFICATIONS units OTW15AX
Technical data
Operating temperature range °C 0 - 35
Dehumidifi cation @ 30°C/60%RH kg/24h 15
Heat recovered to air @ 30°C/60%RH kW 0.9
Airfl ow m³/h 225
External static pressure Pa 0
Sound pressure level @ 3m dB(A) 53
Refrigerant R407C
Electrical data
Supply V/ph/Hz 230/1N/50
Nominal power consumption kW 0.43
FLA amps 3.8
Maximum supply fuse amps 10
LRA (compressor start) amps 18
Dimensions
Width mm 825
Depth mm 363
Height mm 320
Weight kg 33
Condensate drain size mm ID 10
(fl exible plastic hose)
Options
CALOREX OTW 15
The OTW15 is tamper proof – ideal for use in public buildings
Free advice from staff qualifi ed by years of experience and strong technical knowledge