A PROJECT REPORT

ON

“2D FINITE ELEMENT METHOD BASED D-AXIS AND Q-AXIS REACTANCE ESTIMATION OF A SAMPLE HIGH VOLTAGE GENERATOR”

Submitted in Partial Fulfilment of the Requirement for the Award of the Degree of

BACHELOR OF TECHNOLOGY

IN

ELECTRICAL AND ELECTRONICS ENGINEERING

SUBMITTED BY

K RAJENDRA KUMAR 11841A0251

G N R SAI CHANDRAMOULI 10841A0248

UNDER THE GUIDANCE OF

MR.M.UPENDER REDDY

Sr. Assistant Professor

DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING

AURORA’S TECHNOLOGICAL AND RESEARCH IINSTITUTE

(Approved by AICTE, New Delhi and Affiliated to JNTU,Hyderabad)

Parvatapur, Uppal ,Hyderabad, Telangana-500098

(2011-2015)

CERTIFICATE

This is to Certify that the Main Project report entitled “2D FINITE ELEMENT METHOD BASED D-AXIS AND Q-AXIS REACTANCE ESTIMATION OF A SAMPLE HIGH VOLTAGE GENERATOR” submitted by K RAJENDRA KUMAR (11841A0251) and G N R SAI CHANDRAMOULI (10841A0248) in partial fulfillment of the requirements for the award of Bachelor of Technology Degree in Electrical and Electronics Engineering at Aurora’s Technological and Research Institute, Parvathapur, Uppal, Hyderabad is an authentic work carried out by them under my supervision.To the best of my knowledge the matter embodied in the project has not been submitted to any other University/Institute for the award of any degree or diploma.

INTERNAL GUIDE EXTERNAL EXAMINER

Mr.A.Madhusudan roa ,M.Tech (Ph.D)

Associate Professor and Head

Dept. of Electrical and Electronics Engineering

Aurora’s Technological and Research Institute

Approved by AICTE, New Delhi & Affiliated to JNTU, Hyd.

Parvathapur, Uppal, Hyderabad - 500 098

ACKNOWLEDGEMENT

Before we get into the thick of the things we would like to add a few heartfelt words for the people who were the part of this project in numerous ways . People who gave unending support right from the stage the project the project idea was conceived .Our primary thanks to Mr. A. MADHUSUDHAN ROA, Head of Department , Electrical and Electronics Engineering ,ATRI , Uppal for providing all the facilities carrying out the project

We are pleased to acknowledge the assistance of our internal guide MR.M.UPENDER REDDY , SR Assistant professor, Department of EEE for his advice and assistance to department of this project.

Our internal guide has taken careful attention and given infinite number of helpful suggestions . he has checked all our measurement , found several that did not perform correctly in certain circumstances . We trust all these problems are fixed , if not fault is entirely ours .We are very thankful with respect to our internal guide for helping us in all aspects and being with us every time for carrying out the project

Above all , to the esteemed staff of our college we owe more than what we can mention .Mostly for teaching us to see the silver lining in every dark cloud