Signal Light - PWX LED 8 GPS

25114601 The PWX LED signal light is a high intensity signal light for marine applications, especially for installations where several signal lights need to be synchronized. The light pattern can be reprogrammed, but default light pattern is Morse U-code. With the wide opening of the vertical light sector, the PWX LED is especially suited for installation on buoys where the movements of the buoys occur due to waves or there may be a permanent tilt due to buoy orientation or movement.

Technical info

ELECTRICAL Input voltage: 12-32V Power consumption Standby Power: 200mW (no light) Peak Power: 15W (light ON) Average Power: 2 W (Morse U-code) Daylight switch Electrical interface: Pin 1 +V (in) Pin 2 Tx (RS232) Pin 3 0V Pin 4 Rx (RS232) Pin 5 1PPS (out) OPTICAL DATA Flash pattern: Morse U-code Light Source: White Light Emitting Diode (LED) Light Intensity: 50 Candela (minimum value around 360 degree) Visibility range: 10km (visibility Tc=0,85) Vertical sector: +/- 20 degrees Temperature protection: Reduced light output at temperatures above 60 ˚C GPS RECEIVER Accuracy: Position 1,8m (CEP95) Accuracy: Velocity 0,1m/s Accuracy: Time 50ns (rms) SBAS support: Yes WAAS / EGNOS / MSAS supported. Can be enabled/disabled Factory default= disabled COMPASS SENSOR Precision (typical): 3 degrees MECHANICAL DATA Diameter: 115mm Fastening hole distance: 100mm Height: 65mm

Light Intensity Vertical Visibility range (within Light sector)

Achilles ID 29196

Rev.01.2012 This information is provided for general guidance purposes only and Powex AS provides no guarantees or warranties in respect of this information and has no responsibility or liability for any use by any third party of this information.

Powex AS, S o f u s J ø r g e n s e n s v 5 , 6 4 1 5 M o l d e, Norway, T +47 71 24 78 00, Web: www.powex.no E. mail: office@powex.no

Creates values