Data Comm. & Networks
description
Transcript of Data Comm. & Networks
![Page 1: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/1.jpg)
Data Comm. & Networks
Instructor: Ibrahim TariqLecture 3
![Page 2: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/2.jpg)
8.2
Figure 8.1 Switched network
![Page 3: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/3.jpg)
3
Communication NetworkCommunication networks
Broadcast networksEnd nodes share a common channel (TV,
radio…)
Switched networks End nodes send to one (or more) end nodes
Packet switchingData sent in discrete portions
(the Internet)
Circuit switchingDedicated circuit per call
(telephone, ISDN)(physical)
![Page 4: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/4.jpg)
8.4
CIRCUIT-SWITCHED NETWORKS
A circuit-switched network consists of a set of switches connected by physical links. A connection between two stations is a dedicated path made of one or more links. However, each connection uses only one dedicated channel on each link. Each link is normally divided into n channels by using FDM or TDM.
Three PhasesCircuit-Switched Technology in Telephone Networks
Topics discussed in this section:
![Page 5: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/5.jpg)
8.5
A circuit-switched network is made of a set of switches connected by physical
links, in which each link is divided into n channels.
Note
![Page 6: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/6.jpg)
6
Circuit switching
• A dedicated communication path (sequence of links-circuit) is established between the two end nodes through the nodes of the network
• Bandwidth: A circuit occupies a fixed capacity of each link for the entire lifetime of the connection. Capacity unused by the circuit cannot be used by other circuits.
• Latency: Data is not delayed at switches
![Page 7: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/7.jpg)
7
Circuit switching (cnt’d)
Three phases involved in the communication process:1. Establish the circuit
2. Transmit data
3. Terminate the circuit
If circuit not available: busy signal (congestion)
![Page 8: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/8.jpg)
8.8
Figure 8.3 A trivial circuit-switched network
![Page 9: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/9.jpg)
8.9
In circuit switching, the resources need to be reserved during the setup phase;
the resources remain dedicated for the entire duration of data transfer until the
teardown phase.
Note
![Page 10: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/10.jpg)
8.10
Figure 8.6 Delay in a circuit-switched network
![Page 11: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/11.jpg)
8.11
Switching at the physical layer in the traditional telephone network uses
the circuit-switching approach.
Note
![Page 12: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/12.jpg)
12
Circuit Switching: FDM and TDM
FDM
frequency
timeTDM
frequency
time
4 users
Example:
![Page 13: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/13.jpg)
6.13
Bandwidth utilization is the wise use of available bandwidth to achieve
specific goals.
Efficiency can be achieved by multiplexing;
Note
![Page 14: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/14.jpg)
6.14
6-1 MULTIPLEXING
Whenever the bandwidth of a medium linking two devices is greater than the bandwidth needs of the devices, the link can be shared. Multiplexing is the set of techniques that allows the simultaneous transmission of multiple signals across a single data link. As data and telecommunications use increases, so does traffic.
Frequency-Division MultiplexingWavelength-Division MultiplexingSynchronous Time-Division MultiplexingStatistical Time-Division Multiplexing
Topics discussed in this section:
![Page 15: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/15.jpg)
6.15
Figure 6.1 Dividing a link into channels
![Page 16: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/16.jpg)
6.16
Figure 6.2 Categories of multiplexing
![Page 17: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/17.jpg)
6.17
Figure 6.3 Frequency-division multiplexing
![Page 18: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/18.jpg)
6.18
FDM is an analog multiplexing technique that combines analog signals.
Note
![Page 19: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/19.jpg)
6.19
Figure 6.4 FDM process
![Page 20: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/20.jpg)
6.20
Figure 6.5 FDM demultiplexing example
![Page 21: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/21.jpg)
6.21
Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels into a link with a bandwidth of 12 kHz, from 20 to 32 kHz. Show the configuration, using the frequency domain. Assume there are no guard bands.
SolutionWe shift (modulate) each of the three voice channels to a different bandwidth, as shown in Figure 6.6. We use the 20- to 24-kHz bandwidth for the first channel, the 24- to 28-kHz bandwidth for the second channel, and the 28- to 32-kHz bandwidth for the third one. Then we combine them as shown in Figure 6.6.
Example 6.1
![Page 22: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/22.jpg)
6.22
Figure 6.6 Example 6.1
![Page 23: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/23.jpg)
6.23
Figure 6.9 Analog hierarchy
![Page 24: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/24.jpg)
6.24
Wavelength-division multiplexing
![Page 25: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/25.jpg)
6.25
WDM is an analog multiplexing technique to combine optical signals.
Note
![Page 26: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/26.jpg)
6.26
Prisms in wavelength-division multiplexing and demultiplexing
![Page 27: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/27.jpg)
6.27
TDM
![Page 28: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/28.jpg)
6.28
TDM is a digital multiplexing technique for combining several low-rate channels into one high-rate one.
Note
![Page 29: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/29.jpg)
6.29
Figure 6.13 Synchronous time-division multiplexing
![Page 30: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/30.jpg)
6.30
In synchronous TDM, the data rate of the link is n times faster, and the unit duration is n times shorter.
Note
![Page 31: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/31.jpg)
6.31
Figure 6.16 Example 6.8
![Page 32: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/32.jpg)
6.32
Figure 6.18 Empty slots
![Page 33: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/33.jpg)
6.33
Figure 6.26 TDM slot comparison
![Page 34: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/34.jpg)
6.34
6-1 SPREAD SPECTRUM
In spread spectrum (SS), we combine signals from different sources to fit into a larger bandwidth, but our goals are to prevent eavesdropping and jamming. To achieve these goals, spread spectrum techniques add redundancy.
Frequency Hopping Spread Spectrum (FHSS)Direct Sequence Spread Spectrum Synchronous (DSSS)
Topics discussed in this section:
![Page 35: Data Comm. & Networks](https://reader035.fdocuments.us/reader035/viewer/2022062812/56816379550346895dd455b7/html5/thumbnails/35.jpg)
6.35
Figure 6.27 Spread spectrum