1MATERIAL SAFETY DATA SHEETDATE: March 2013

PRODUCT NAME: PVA ADHESIVEPRODUCT CODE: 8711, 8712

SECTION I - SUPPLIER IDENTIFICATIONSUPPLIERS NAME : CAMPBELLS WHOLESALE PTY LTDADDRESS : 21 BALLANTYNE RD KEWDALE WA 6105

Tel.: (08) 9353 3354 Fax: (08) 9353 6994www.campbellswholesale.com.au

EMERGENCY PHONE NO. (24 HOURS AUSTRALIA)13 11 26 POISONS INFORMATION CENTRE

SECTION II - HAZARDOUS INGREDIENTS/SARA III INFORMATIONHazardous Statement: Not classified as hazardous according to criteria of Worksafe Australia

UN No N/A D G Class N/A CAS No N/AHazchem N/A Sub Risk N/A SUSDP N/AG.T.EPG N/A Spec.EPG N/A IMDG N/APack Group N/A

Ingredients: Chemical Entity CAS Number Proportion

Synthetic Resin Emulsion 60-100%Phthallate Plasticiser 0-3%Surfactant System 0-0.2%Vinyl Acetate Monomer 108-05-4 0-0.3%Water To 100%

Physical Description/Properties: Appearance White coloured, free flowing liquid, slight

odour.Melting Point Approximately 0 Deg C (water)Boiling Range Approximately 100 Deg C (water)Vapour Pressure Not establishedSpecific Gravity Approximately 1.07Flash Point Not applicableFlamm. Limit LEL Not applicable

Other Data: Volatile Component WaterpH Value 4 - 6Form LiquidSolubility in Water Completely dispensable

2Product Use: PVA Glue is a waterborne, synthetic resin based adhesivedesigned for use in the wood working and furniture industryfor timber assembly work.

Health Hazard Information:Acute EffectsSwallowed May cause gastric irritation.Eye A moderate eye irritant.Skin Repeated or prolonged skin contact may

lead to irritation.Inhaled Not normally an inhalation risk due to low

vapour pressure ambient temperatures.Chronic Effects

Knowledge is based on that of theconstituents. Repeated or prolonged skincontact can cause irritation.

First Aid:Swallowed Rinse mouth thoroughly with water

immediately. Give water to drink.Do not induce vomiting. Seek medical assistance.

Eye Immediately irrigate with copious amounts ofwater for at least 15 minutes. Eyelids to beheld open. In all cases of eye contamination,it is a sensible precaution to seek medical advice.

Skin Wash with plenty of soap and water.Remove contaminated clothing and washbefore re-use. If irritation occurs, seekmedical advice.

Inhaled Remove victim to fresh air. Allow patient toassume most comfortable position and keepwarm. Recovery should be rapid after removalfrom exposure. Keep at rest until fully recovered. Seekmedical advice if effects persist.

First Aid Facilities Ensure that safety shower and eye wash baths arereadily accessible.

Advice to Doctor Treat symptomatically.Toxicity Data no data available for the compounded product.

Precautions for Use:Exposure Standards

No data is available for the compounded material.The following data relates to the ingredients ofPVA Wood Glue:Vinyl Acetate MonomerTLV-TWA 10 ppm, 35 mg/m3TLV-STEL 20 ppm, 70 mg/m3

[NOHSC:1003(1991)]

TWA is the time weighted average concentration ofthe work atmosphere over a normal 8 hour work day

3and a 40 hour work week. Nearly all workers mayrepeatedly be exposed to this level, day after daywithout adverse effect.

Engineering ControlsUse in well ventilated area. General factoryventilation is normally sufficient. In confined orpoorly ventilated areas the use of mechanicalventilation may be required.

Personal ProtectionAvoid repeated and prolonged skin contact. Alwayswash hands before smoking, eating drinking or usingthe toilet. Wash contaminated clothing and protectiveequipment before storing/re-using. The followingpersonal protective equipment is recommended:Safety Glasses, Goggles or face shield. Plastic orrubber gloves. Overalls or similar protective apparel

FlammabilityNon flammable.

EnvironmentAvoid contaminating waterways.

Other PrecautionsAlways observe adequate standards of industrialhygiene.

Safe Handling Information:

Storage and TransportStore in cool area, away from direct sunlight tomaximise storage life. Keep containers closed whennot in use. Do not allow to freeze. Not defined as adangerous Good by the Australian Code for theTransport of Dangerous Goods by Road and Rail.

Packing and LabelingNo special requirements

Spills and DisposalWear appropriate protective equipment. Containspillage using absorbent (soil or sand, sawdust,vermiculite, inert) material. Prevent anycontamination of drains or waterways. Scrape upand seal in properly labelled drums for disposal.Remove residue from contaminated areas withspecific clean-up solution or use water anddetergent. Observe local regulations whendisposing of waste material.

Fire/Explosion HazardNo unusual fire of explosion hazards. In case of firein the surroundings: all extinguishing agentsallowed. Fire fighters to wear self-containedbreathing apparatus if risk of exposure to vapour orproducts of combustion.Hazardous decomposition of products ofcombustion: Carbon Dioxide, Carbon MonoxideSoot and smoke, Oxidative products of polymeric

4materials.Reactivity Data

Hazardous polymerization will not occur.Campbells Wholesale Pty Ltd makes no representation as to the completeness and accuracy of the data contained in this datasheet. It is the users obligation to evaluate and use this product safely and to comply with all the Local, State and Federalregulations and laws. Campbells Wholesale shall not be responsible for loss, damage or injury resulting from reliance upon orfailure to adhere to any recommendations or information contained herein, from abnormal use of the material or from anyhazard inherent in the nature of the material.