Ahmed Mohammed Abd El sam e i ( Senior Structural Engineer )

( Steel & Concrete ) Mobile: +971-566641609 & +971-523066416

+971-527460300E-mail: ahmed_azab_680@hotmail.com

Dear Human resources manager,

I’d like to be a member in your firm. I’m a structural engineer graduated on May 2005; I have a very good experience of 11 years ( 4 years UAE ) concerning design (Concrete & Steel), shop drawing and supervision. So, I apply to gain experience from joining in your firm

My experience in computer skills and job related skills as (Ability to learn new tasks quickly and Ability to work effectively under pressure)

Where I worked as Structural designer for large-scale projects as mentioned in detailed c.v.

Thank you for your time and consideration.

Sincerely,

Signature: Ahmed Mohamed azab

AHMED MOHAMMED ABD EL SAMEI

PERMANENT ADDRESS: Al-Bateen Street, Abu Dhabi, United Arab Emirates, P.O Box 29556

MOBILE: +971-566641609 & +971-523066416 MAIL: ahmed_azab_680@hotmail.com NATIONALITY: Egyptian BIRTH DATE: 8 / 7 / 1983 MARITAL STATUS: Married. MILITARY SERVICE: Exemption. DRIVING LICENSE : Valid, UAE & Egypt.

OBJECTIVE: To obtain the position of Civil/Structural Engineer with a focus on Concrete, Steel design and utilize my knowledge, skills, and experience for the further development and progress of the organization.

EDUCATION: Bachelor of Science in Civil Engineering, )May 2005( Faculty of Engineering, Ain Shams University, Cairo.

Graduation Grade: Good )65.5 %( - Bachelor Degree: Good )75.6 %(. Graduation project: Reinforced concrete - Degree: Good Graduation project briefing: Analysis and design of two concrete units

)Residential building & a commercial market(. Member of Egyptian Syndicate of Engineers

WORK EXPERIENCE: CURRENT JOB: )from 6/2012 to present( work as Senior Design Engineer on

Steel construction in Engineering Consultants Group S.A. -Abu Dhabi -

1. Analysis and Design variable Steel & Concrete buildings using Different codes such as )AISC, UBC, IBC & ECP( and Preparing Tender Drawings for the following Projects: General Directorate of Military Works )GDMW( Riyadh Medical Complex New Natural Gas Liquid )NGL( - Qatar Petroleum Qatar Emiri Naval Forces Base Buildings Auditorium in Ras Laffan Industrial City - Qatar New Fire Station No.6 at Ras Laffan - Qatar Design Review of Al Salam Steel Pedestrian Bridge at Abu Dhabi Design Review of Warehouse Building at Ruwais Refinery - Abu Dhabi

2. Analysis and Design Post Tension Slabs by RAM Concept Program and Preparing Tender Drawings.

Civil / Structural Engineer Last Updated: 06/2016

3. Technical office )Civil Engineer – Supervision( on the site for project Aircraft maintenance, repair and overhaul facilities )AMMROC( in Al-Ain international Airport )1.40 Billion AED(.

)From 10/2009 to 5/2012( work as Senior Design Engineer on Steel construction in Roots Steel System Company - Egypt

)Saudi Bin Laden Group) -

1. Analysis and Design variable steel buildings in Egypt and other country, using Different codes such as )AISC, MBMA, UBC & ECP( and Preparing Tender Drawings for steel buildings )by MBS & Staad pro Program(.

2. Analysis and Design Mezzanine floor and Crane beam and take the effect of its loads on steel buildings.

3. Make Estimate for Many Projects and Preparing Raw Material List for Them

)From 1/2008 to 9/2009( work as Design Engineer on Steel construction in Zamil Steel Buildings Company - Egypt -

1. Analysis and Design variable steel buildings in Egypt and other country, using different codes such as )AISC, MBMA, UBC & ECP( and Preparing Tender Drawings for steel buildings.

2. Analysis and Design Mezzanine floor and Crane beam and take the effect of its loads on steel buildings.

)From 11/2005 to 12/2007( work as Design engineer on concrete construction in BADRAN (Associates-Consulting Engineers office) – Egypt

1. Revision of structural design of )ground tank about 2600 m2 area( in EL SANTA WWTP- El Gharbia Governorate.

2. Revision of many projects )residential buildings - villas( for E.C.L.I.P )Egyptian Construction Third Party Liability Insurance Pool(.

3. Design residential buildings )consist of basement, ground and ten typical floors( and take the effect of wind and seismic load on it.

4. Design the base system for G.S.M Microwave tower and Shelter for )Vodafone & Etisalat( either as Roof top and Green Field sites and check safety for buildings.

5. Make Workshop Drawing for Information Technology Institute Building )About 4000 m2( in Smart Village. Workshop Drawing

Civil / Structural Engineer Last Updated: 06/2016

including Concrete Dimension and RFT Details for Footing, Columns, Retaining wall, Slabs and other items.

6. Design Residential Building in Ain Sokhna consists of Ground floor and two typical floors.

7. Design Foundation of some steel building in Libya. The steel building Designed by Kirby and the Owner of this project is Hilbarton.

8. Design Studio for Qatar Radio & Television in Qatar consists of Ground floor and three typical floors for Administrative building and Steel Portal Frame for Studio Area. Design of project according to British Standard.

Using local and international standards such as:

ECP 201 - 2012 Egyptian Code for Assessment of Loads and Forces on Structures and Buildings.

ECP 203 - 2007 Egyptian Code for Design and Construction of Reinforced Concrete Structures.

ECP 205 - 2001 Egyptian Code of Practice for Steel Construction and Bridges )ASD(.

ASCE 7-10 American Society of Civil Engineers )Minimum Design Loads for Buildings and Other Structures(.

ACI 318 - 14 Building Code Requirements for Structural Concrete. AISC 360 - 05 American institute Specification for Structural Steel Buildings. BS 8110:1997 British Standard - Structural Use of Concrete practice for

Design and construction. BS 5950-1:2000 British Standard - Structural use of steelwork in building.

TRAINING: Ain Shams University Hospitals, Cairo )August 2004( Arab Contractors, Cairo )August 2004(

LANGUAGES: Arabic )Mother tongue(, English )Good(

COMPUTER SKILLS: AutoCAD, Sap2000, Etabs, Staad pro, Metal Building Software )MBS(, Tekla Structure, Prokon, RAM Concept PT, Photoshop CS6, MS windows office )Word - Excel(, Aconex )Online Project Management( and internet.

HOBBIES: Football, Swimming, Reading, and Horse riding.

Civil / Structural Engineer Last Updated: 06/2016