Cubic Lithium Nitride to 200 GPayclept.physics.ucdavis.edu/Projects/Li3N_APS05.pdf · Cubic Lithium...
Transcript of Cubic Lithium Nitride to 200 GPayclept.physics.ucdavis.edu/Projects/Li3N_APS05.pdf · Cubic Lithium...
Cubic Lithium Nitrideto 200 GPaAmy Lazicki1,2
Choong-Shik Yoo1, Warren Pickett2, Richard Scalettar2
1Lawrence Livermore National Laboratory2University of California at Davis
This work was performed under the auspices of the U.S. Department of Energy by University of California, Lawrence Livermore National Laboratory under Contract W-7405-Eng-48, and funded by SSAAP and SEGRF
Acknowledgements• Members of High Pressure Group at LLNL: Hyunchae Cynn,
William Evans, Magnus Lipp, Bruce Baer, Valentin Iota,Jae-Hyun Klepeis, Ken Visbeck, Brian Maddox, Geun Woo Lee,Zsolt Jenei
• HPCAT (sector 16 of the APS) at which all experiments wereperformed; we thank Maddury Somayazulu and Micheal Hufor technical assistance and scientific input.
• Andy McMahan (LLNL), Deepa Kasinathan (UCD) and Jan Kunes (UCD) for help with theoretical aspects
OUTLINE
Background
Results from• X-Ray Diffraction• X-Ray Raman Scattering• Total energy DFT calculations
Conclusions
Li3N (previously known info) • Two low pressure phases had been observed:
• α phase is a superionic conductor via hopping of Li1+ ions within Li2N layers, in which N ions exist in 3- ionic state.
• β phase is metastable at 0 GPa, stable up to < 35 GPa.• high pressure cubic phase was predicted by theory.
~0.5 GPa
(α) P6/mmm (β) P63/mmc
Technological applications:• possible electrolyte material for lithium-based batteries• possible hydrogen storage materialThrust of this research:
Determine structure, equation of state, stability of any novel high pressure phase.
X-Ray Diffraction Results
• mixed phase at0 GPa
• transition to transparent cubicphase between35 and 45 GPa
• signal fromargon pressuremedium and rhenium gasketobscure thedetails
γ-Li3N – a new cubic phase
• pattern well understood as a combination of Cu and Li3N in cubic Fm3m phase
• peak broadening at 200 GPa very minimal even under non-hydrostatic conditions – very little internal stresses/strains
• cubic Li3N takes on simple rocksalt structure, with Li1+ ions tetrahedrallycoordinated with 4 nitrogen ions in alltetrahedral holes in lattice.
Rietveld-refined XRD structure data
Inelastic X-Ray (Raman)Scattering ~10 keV
Ei Ej
X-RayRaman
~400 eV
X-RayAbsorption
k-shell
energy loss: E = Ei - Ej
• Yields the same information as XAS, butexperiment can be done with hard x-rays—(becomes possible to examine k-edges oflow-Z materials in bulk)
Experimental set-up (16IDD, HPCAT, APS)
DAC
DETECTOR
ANALYZER – Si (660)
x-ray transparentBe gasket
incident beam energy scannedfrom 380 – 430 eV aboveelastic scattering energy (9.6870 eV) to probe nitrogen k-edge
X-Ray Raman ResultsNitrogen k-edge spectra of Li3N
• The x-ray raman spectra can be understood as transitions to low-lying conduction states with nitrogen p character – differences between the XRS and PDOS are indications of the presence of core-hole interactions (excitons) and non-dipole allowed transitions.
Projected Nitrogen p Density of States
α-L
i 3Nβ-
Li3N
γ-Li
3N(N core states at -373.239 eV)
Equation of State
• cubic phase of Li3N remainsvery compressible up to 200 GPa(maximum pressure achievedIn this experiment)
• B0, V0 from fit to non-hydrostatichigher-pressure data agree wellwith results from fit to lower-pressure hydrostatic data.
γ-Li3N is a good candidate for aninternal pressure indicator for ultra-high pressure applications
• simple cubic crystal structure• stable up to at least 200 GPa with
minimal peak broadening even under non-hydrostatic conditions
• compressibility compares well withother common pressure standards
• low-Z composition makes itparticularly suitable for low-Zapplications
Possible problem: reactivity, especially at high pressures, is unknown.
Bulk Modulus of γ-phase and comparisonto common pressure indicators*
Equation of state data was then fit to modified 3rd order Birch-Murnaghan equation*
*N. Sata, G. Shen, M. L. Rivers, S. R. Sutton, PRB 65, 104114 (2002)
DFT Calculation Results
Density of states
Equation of State • Total energy calculations yield V0, B0, B0’ consistent with experiment –Li3N is well described by theoretical model.
• widening of the band gap indi-cates insulating cubic phase,explains colorchange fromopaque to trans-parent acrosshexagonal-cubic phase transition.Comparison with
experimental results
charge densityat transition
nearmetallization
P = 40 GPa(transition tocubic phase)
P ~ 760 GPa43% of unit cell volume at transition
(maximum band gap)
P ~ 7.9 TPa16% of unit cellvolume at transition.
(metallization)
Elec
tron
ic b
and
stru
ctur
e (e
V)Predicted Metallization
(001)
Band gap pressure dependence
Conclusions
The high pressure cubic phase of Li3N identified in this study has several interesting properties including:
• Structural transition similar to graphite-diamond andhexagonal-cubic boron nitride
• Unusually high phase stability at megabar pressures
• High compressibility on the order of standard pressure indicators used in diamond anvil cell research
• Metallization at ultra-high gigabar pressures, on the orderof closed-shell wide-gap insulators Ne, MgO and NaClwhich metallize at 134 TPa, 20.7 TPa, & 0.455 TPa, respectively