Create New Account

Create New Account

• Use of the Winland EnviroAlert EA800-ip requires an account for remote access to:– View real-time sensor data– Modify setting

configurations remotely– Download data logs

• No additional software is required.

Create New Account

• Go to www.ea800ip.com

• Click on “Create an Account”– Each account can host

up to 50,000 consoles.

Create New Account

• You will leave the Winland web site and be transferred to the BAYweb host site.

Create an Account

• Read the Terms of Service.

• Scroll to the bottom to accept the Terms.

Create an Account

• Check the box “I accept…”

• Click “Next” to continue.

• Click “Cancel” to return to the Winland web site.

Create an Account

• Be prepared to create a User ID (typically your email address).

• Password must be at least 5 and up to 20 characters.

• The email address entered here is for Account Contact purposes. Alarm notification is entered at a different point.

Create an Account

• User ID does not accept spaces.

• Security Question requires at least 8 characters.

• Response must be at least 3 characters.

• Check or uncheck the box to receive news and promotional information.

• If you click to visit the Privacy Policy page you will need to re-enter your information to create your account.

• Click “Finish” to save settings.

Create an Account

• Your account must now be validated.

• You will receive an email at the “Account Contact” address.

• Modify your email to accept mail from bayweb.com and check your Junk Mail.

Create an Account

• The Account Validation email will come from support@bayweb.com.

• The subject will be BAYweb Account Validation.

• Click on the link in the email and enter your User ID and Validation Code to complete the set up process.

Create an Account

• Account creation is now complete.

• Click on “Home Page” to register new equipment (common starting place).

• You can also use the links in the menu bar on the upper right side of the screen.

• Your account is now created. Here are some common next steps:– Register New Equipment– Connect Wired Sensors and

configure locally– Connect Wired Sensors and

configure remotely