Copyright © 2009 Pearson Education, Inc. Chapter 15 Wave Motion.
-
Upload
oswin-ross -
Category
Documents
-
view
216 -
download
1
Transcript of Copyright © 2009 Pearson Education, Inc. Chapter 15 Wave Motion.
Copyright © 2009 Pearson Education, Inc.
Chapter 15
Wave Motion
Copyright © 2009 Pearson Education, Inc.
15-2 Types of Waves: Transverse and Longitudinal
The velocity of a longitudinal wave depends on the elastic restoring force of the medium and on the mass density.
or
Copyright © 2009 Pearson Education, Inc.
15-2 Types of Waves: Transverse and Longitudinal
Example 15-3: Echolocation.Echolocation is a form of sensory perception used by animals such as bats, toothed whales, and dolphins. The animal emits a pulse of sound (a longitudinal wave) which, after reflection from objects, returns and is detected by the animal. Echolocation waves can have frequencies of about 100,000 Hz.(a)Estimate the wavelength of a sea animal’s echolocation wave.(b)If an obstacle is 100 m from the animal, how long after the animal emits a wave is its reflection detected?
Copyright © 2009 Pearson Education, Inc.
Earthquakes produce both longitudinal and transverse waves. Both types can travel through solid material, but only longitudinal waves can propagate through — a fluid has no restoring force fluid in the transverse direction.
Surface waves are waves that travel along the boundary between two media.
15-2 Types of Waves: Transverse and Longitudinal
ConcepTest 15.4ConcepTest 15.4 Out to SeaOut to Sea
t
t + t
1) 1 second
2) 2 seconds
3) 4 seconds
4) 8 seconds
5) 16 seconds
A boat is moored in a fixed location, and
waves make it move up and down. If the
spacing between wave crests is 20 m
and the speed of the waves is 5 m/s, how
long does it take the boat to go from the
top of a crest to the bottom of a trough ?
ConcepTest 15.4ConcepTest 15.4 Out to SeaOut to Sea
t
t + t
1) 1 second
2) 2 seconds
3) 4 seconds
4) 8 seconds
5) 16 seconds
A boat is moored in a fixed location, and
waves make it move up and down. If the
spacing between wave crests is 20 m
and the speed of the waves is 5 m/s, how
long does it take the boat to go from the
top of a crest to the bottom of a trough ?
We know that v = f v = f = = / T, / T, hence T = T = / v / v. If = = 20 m20 mand v = v = 5 m/s5 m/s, then T = T = 4 secs4 secs.
The time to go from a crest to a trough is only T/T/22 (half ahalf a periodperiod),
so it takes 2 secs2 secs !!
A wave pulse is sent down a rope of
a certain thickness and a certain
tension. A second rope made of the
same material is twice as thick, but
is held at the same tension. How will
the wave speed in the second rope
compare to that of the first?
1) speed increases
2) speed does not change
3) speed decreases
ConcepTest 15.6ConcepTest 15.6 Wave Speed IIWave Speed II
A wave pulse is sent down a rope of
a certain thickness and a certain
tension. A second rope made of the
same material is twice as thick, but
is held at the same tension. How will
the wave speed in the second rope
compare to that of the first?
1) speed increases
2) speed does not change
3) speed decreases
The wave speed goes inversely as the square root of the mass per unit length, which is a measure of the inertia of the rope. So in a thicker (more massive) rope at the same tension, the wave speed will decrease.
ConcepTest 15.6ConcepTest 15.6 Wave Speed IIWave Speed II
Copyright © 2009 Pearson Education, Inc.
By looking at the energy of a particle of matter in the medium of a wave, we find:
Then, assuming the entire medium has the same density, we find:
Therefore, the intensity is proportional to the square of the frequency and to the square of the amplitude.
15-3 Energy Transported by Waves
Copyright © 2009 Pearson Education, Inc.
If a wave is able to spread out three-dimensionally from its source, and the medium is uniform, the wave is spherical.
Just from geometrical considerations, as long as the power output is constant, we see:
15-3 Energy Transported by Waves
Copyright © 2009 Pearson Education, Inc.
15-3 Energy Transported by Waves.
Example 15-4: Earthquake intensity.
The intensity of an earthquake P wave traveling through the Earth and detected 100 km from the source is 1.0 x 106 W/m2. What is the intensity of that wave if detected 400 km from the source?
Copyright © 2009 Pearson Education, Inc.
15-4 Mathematical Representation of a Traveling Wave
Suppose the shape of a wave is given by:
Copyright © 2009 Pearson Education, Inc.
15-4 Mathematical Representation of a Traveling Wave
After a time t, the wave crest has traveled a distance vt, so we write:
Or:
with ,
Copyright © 2009 Pearson Education, Inc.
15-4 Mathematical Representation of a Traveling Wave
Example 15-5: A traveling wave.
The left-hand end of a long horizontal stretched cord oscillates transversely in SHM with frequency f = 250 Hz and amplitude 2.6 cm. The cord is under a tension of 140 N and has a linear density μ = 0.12 kg/m. At t = 0, the end of the cord has an upward displacement of 1.6 cm and is falling. Determine (a) the wavelength of waves produced and (b) the equation for the traveling wave.
Copyright © 2009 Pearson Education, Inc.
15-5 The Wave Equation
Look at a segment of string under tension:
Newton’s second law gives:
Copyright © 2009 Pearson Education, Inc.
15-5 The Wave Equation
Assuming small angles, and taking the limit Δx → 0, gives (after some manipulation):
This is the one-dimensional wave equation; it is a linear second-order partial differential equation in x and t. Its solutions are sinusoidal waves.
Copyright © 2009 Pearson Education, Inc.
15-6 The Principle of Superposition
Superposition: The displacement at any point is the vector sum of the displacements of all waves passing through that point at that instant.
Fourier’s theorem: Any complex periodic wave can be written as the sum of sinusoidal waves of different amplitudes, frequencies, and phases.
Copyright © 2009 Pearson Education, Inc.
15-6 The Principle of SuperpositionConceptual Example 15-7: Making a square wave.
At t = 0, three waves are given by D1 = A cos kx, D2 = -1/3A cos 3kx, and D3 = 1/5A cos 5kx, where A = 1.0 m and k = 10 m-1. Plot the sum of the three waves from x = -0.4 m to +0.4 m. (These three waves are the first three Fourier components of a “square wave.”)
Copyright © 2009 Pearson Education, Inc.
A wave reaching the end of its medium, but where the medium is still free to move, will be reflected (b), and its reflection will be upright.
A wave hitting an obstacle will be reflected (a), and its reflection will be inverted.
15-7 Reflection and Transmission
Copyright © 2009 Pearson Education, Inc.
A wave encountering a denser medium will be partly reflected and partly transmitted; if the wave speed is less in the denser medium, the wavelength will be shorter.
15-7 Reflection and Transmission
Copyright © 2009 Pearson Education, Inc.
Two- or three-dimensional waves can be represented by wave fronts, which are curves of surfaces where all the waves have the same phase.
Lines perpendicular to the wave fronts are called rays; they point in the direction of propagation of the wave.
15-7 Reflection and Transmission
Copyright © 2009 Pearson Education, Inc.
The law of reflection: the angle of incidence equals the angle of reflection.
15-7 Reflection and Transmission
Copyright © 2009 Pearson Education, Inc.
The superposition principle says that when two waves pass through the same point, the displacement is the arithmetic sum of the individual displacements.
In the figure below, (a) exhibits destructive interference and (b) exhibits constructive interference.
15-8 Interference
Copyright © 2009 Pearson Education, Inc.
These graphs show the sum of two waves. In (a) they add constructively; in (b) they add destructively; and in (c) they add partially destructively.
15-8 Interference
Copyright © 2009 Pearson Education, Inc.
Standing waves occur when both ends of a string are fixed. In that case, only waves which are motionless at the ends of the string can persist. There are nodes, where the amplitude is always zero, and antinodes, where the amplitude varies from zero to the maximum value.
15-9 Standing Waves; Resonance
Copyright © 2009 Pearson Education, Inc.
15-9 Standing Waves; Resonance
The frequencies of the standing waves on a particular string are called resonant frequencies.
They are also referred to as the fundamental and harmonics.
Copyright © 2009 Pearson Education, Inc.
The wavelengths and frequencies of standing waves are:
15-9 Standing Waves; Resonance
and
Copyright © 2009 Pearson Education, Inc.
15-9 Standing Waves; Resonance
Example 15-8: Piano string.A piano string is 1.10 m long and has a mass of 9.00 g. (a)How much tension must the string be under if it is to vibrate at a fundamental frequency of 131 Hz?(b) What are the frequencies of the first four harmonics?
Copyright © 2009 Pearson Education, Inc.
15-9 Standing Waves; ResonanceExample 15-9: Wave forms.Two waves traveling in opposite directions on a string fixed at x = 0 are described by the functionsD1 = (0.20 m)sin(2.0x – 4.0t) and D2 = (0.20m)sin(2.0x + 4.0t)(where x is in m, t is in s), and they produce a standing wave pattern. Determine (a) the function for the standing wave, (b) the maximum amplitude at x = 0.45 m, (c) where the other end is fixed (x > 0), (d) the maximum amplitude, and where it occurs.
ConcepTest 15.7aConcepTest 15.7a Standing Waves IStanding Waves IA string is clamped at both ends and plucked so it vibrates in a standing mode between two extreme positions a and b. Let upward motion correspond to positive velocities. When the string is in position b, the instantaneous velocity of points on the string:
a
b
1) is zero everywhere
2) is positive everywhere
3) is negative everywhere
4) depends on the position
along the string
Observe two points:
Just before b
Just after b
Both points change direction before and after b, so at b all points must have zero velocity.
ConcepTest 15.7aConcepTest 15.7a Standing Waves IStanding Waves IA string is clamped at both ends and plucked so it vibrates in a standing mode between two extreme positions a and b. Let upward motion correspond to positive velocities. When the string is in position b, the instantaneous velocity of points on the string:
1) is zero everywhere
2) is positive everywhere
3) is negative everywhere
4) depends on the position
along the string
a
b
c
ConcepTest 15.7bConcepTest 15.7b Standing Waves IIStanding Waves IIA string is clamped at both ends and plucked so it vibrates in a standing mode between two extreme positions a and b. Let upward motion correspond to positive velocities. When the string is in position c, the instantaneous velocity of points on the string:
1) is zero everywhere
2) is positive everywhere
3) is negative everywhere
4) depends on the position
along the string
When the string is flat, all points are moving through the equilibrium position and are therefore at their maximum velocity. However, the
direction depends on the locationdirection depends on the location of the point. Some points are moving upward rapidly, and some points are moving downward rapidly.
a
b
c
ConcepTest 15.7bConcepTest 15.7b Standing Waves IIStanding Waves IIA string is clamped at both ends and plucked so it vibrates in a standing mode between two extreme positions a and b. Let upward motion correspond to positive velocities. When the string is in position c, the instantaneous velocity of points on the string:
1) is zero everywhere
2) is positive everywhere
3) is negative everywhere
4) depends on the position
along the string
Copyright © 2009 Pearson Education, Inc.
If the wave enters a medium where the wave speed is different, it will be refracted—its wave fronts and rays will change direction.
We can calculate the angle of refraction, which depends on both wave speeds:
15-10 Refraction
Copyright © 2009 Pearson Education, Inc.
The law of refraction works both ways—a wave going from a slower medium to a faster one would follow the red line in the other direction.
15-10 Refraction
Copyright © 2009 Pearson Education, Inc.
15-10 Refraction
Example 15-10: Refraction of an earthquake wave.
An earthquake P wave passes across a boundary in rock where its velocity increases from 6.5 km/s to 8.0 km/s. If it strikes this boundary at 30°, what is the angle of refraction?
Copyright © 2009 Pearson Education, Inc.
When waves encounter an obstacle, they bend around it, leaving a “shadow region.” This is called diffraction.
15-11 Diffraction
Copyright © 2009 Pearson Education, Inc.
The amount of diffraction depends on the size of the obstacle compared to the wavelength. If the obstacle is much smaller than the wavelength, the wave is barely affected (a). If the object is comparable to, or larger than, the wavelength, diffraction is much more significant (b, c, d).
15-11 Diffraction
Copyright © 2009 Pearson Education, Inc.
• Vibrating objects are sources of waves, which may be either pulses or continuous.
• Wavelength: distance between successive crests
• Frequency: number of crests that pass a given point per unit time
• Amplitude: maximum height of crest
• Wave velocity:
Summary of Chapter 15
Copyright © 2009 Pearson Education, Inc.
• Transverse wave: oscillations perpendicular to direction of wave motion
• Longitudinal wave: oscillations parallel to direction of wave motion
• Intensity: energy per unit time crossing unit area (W/m2):
• Angle of reflection is equal to angle of incidence
Summary of Chapter 15
Copyright © 2009 Pearson Education, Inc.
• When two waves pass through the same region of space, they interfere. Interference may be either constructive or destructive.
• Standing waves can be produced on a string with both ends fixed. The waves that persist are at the resonant frequencies.
• Nodes occur where there is no motion; antinodes where the amplitude is maximum.
• Waves refract when entering a medium of different wave speed, and diffract around obstacles.
Summary of Chapter 15