Configure Cisco 2960
-
Upload
brendancal -
Category
Documents
-
view
212 -
download
0
Transcript of Configure Cisco 2960
-
8/16/2019 Configure Cisco 2960
1/2
Process for configuring the DEECD supplied 24 or 48 port Cisco 2960 Switches.
Connect the switch to hyperterm or putty with rollover cable to console port, port 9600 baud, no flow control.
(Blue rollover cable was also supplied previously with Cisco WLC)
boot switch, then wait.....
press 'n' to bypass initial setup
switch>enable
switch#config t
Switch(config)#hostname ZZZZ (as per DEECD guidelines or your own)
XXXX(config)#int vlan1
XXXX(config-if)#ip address 10.148.82.64 255.255.254.0 (DEECD ip address range fo
r switches starts at .64)
XXXX(config-if)# no shut
XXXX(config-if)# exit
XXXX(config)# ip default-gateway 10.148.82.1 (DEECD router)
XXXX(config)#no ip domain-lookup
XXXX(config)#line console 0
XXXX(config-line)#logging synchronous
XXXX(config-line)#password cisco (or your own)
XXXX(config-line)#login
XXXX(config)#line vty 0 15
XXXX(config-line)#password cisco (or your own)
XXXX(config-line)#login
XXXX(config-line)#exit
XXXX(config)#enable secret Gazza09! (your choice; perhaps known DEECD local admin password)
-
8/16/2019 Configure Cisco 2960
2/2
XXXX(config)#int range gig 1/0/1 - 22 (or 1/0/1 - 46 for larger switch)
XXXX(config-if-range)#switchport mode access
XXXX(config-if-range)#spanning-tree portfast (ignore the warning message)
XXXX(config-if-range)#exit
XXXX(config)#int range gig 1/0/23 - 24 (or 1/0/45 - 46 for larger switch)
XXXX(config-if-range)#switchport mode trunk
XXXX(config-if-range)#end
XXXX#copy run start
press enter at the prompt
XXXX# sh run