Collapsible Beam for 6 m Steve Kavanagh VE3SMA OVHFA “Do”, Sept. 2009.
-
Upload
neal-mckinney -
Category
Documents
-
view
218 -
download
4
Transcript of Collapsible Beam for 6 m Steve Kavanagh VE3SMA OVHFA “Do”, Sept. 2009.
Collapsible Beam for 6 m
Steve Kavanagh VE3SMA
OVHFA “Do”, Sept. 2009
Idea for Foldable 6 m Beam
Foldable dipole for 6 m used in my VHF contest rover operations for a few years
– takes just a few seconds to unfold or fold up again for transport/storage
Could use similar construction to make a folding framework to support a wire beam
Similar antennas used by others, with bent parasitic elements made from wire
– Penn. State 40 m beam [1]– DJ4SA Spiderbeam (multiband HF antenna) [2]
Spiderbeam
Geometry of 4NEC2 Model
Predicted VSWR (@ 25 )
Predicted Gain
Predicted F/B,F/R Ratios
Modeling Observations
Could optimize element lengths for different combinations of gain and bandwidth
More gain = less bandwidth = lower input impedance
As expected from regular Yagi behaviour
End Loop Compensation
With wire elements held with string, you need loops at ends to tie string to
These loops add capacitance to the element ends To maintain correct resonant frequency need to
shorten elements to compensate I made some 4NEC2 models to predict the required
shortening – not quite sure if correct but included in the actual antenna
Feeding the Antenna
Spiderbeam has 50 ohm input impedance I chose a higher gain design with lower input
impedance as only a narrow slice of 6m needs to be covered
How to feed a balanced antenna with ~25 ohm impedance using 50 ohm unbalanced cable ?
Feed Network
Balun– Two large ferrite beads are slipped over the coax to make a
“choke” or “W2DU-type” balun Matching network
– can be thought of as two quarter-wave transformers in series
Feed Network, cont’d
BUT…you can’t get 70.7 ohm cable ! By adjusting lengths of the two transformer
sections, – can perfectly match a range of impedances – and can use standard 75 ohm cable
Here it is !
On-the-Air Results
My 1st double hop Es QSO to the west from home – DM09 – With about 10 Watts– Using antenna tuner to match before building matching network
1st QSO on Field Day was NP4A on 6m – With 5 Watts– Much better at 12’ than vertical on car on VE3UBL beacon and on
a VE9 on sporadic E– Good F/B ratio observed
Used for CW WW VHF Contest from FN05 (Multi-Op)– Satisfactory results – 41 grids worked with 100 Watts– Balun withstood this power– Significantly better than dipole (much better than vertical on car)
on VE3UBL beacon
References
[1] Nathan A. Miller, NW3Z, and James L. Breakall, WA3FET, “A 40m V-Yagi”, in International Antenna Collection, RSGB/ARRL, 2003, (and in QST,May 1988)
[2] http://www.spiderbeam.com