CodeSmart’s Floorboard for GT-10 and GR-55 Floorboard.pdfCodeSmart’s Floorboard for GT-10 and...
Transcript of CodeSmart’s Floorboard for GT-10 and GR-55 Floorboard.pdfCodeSmart’s Floorboard for GT-10 and...
CodeSmart’s Floorboard for GT-10 and GR-55
Material: Plywood, small wooden screws + black paint. No glue used. Can be dismounted (however the
paint acts as a glue).
The final rectangular dimension of the floorboard is 50.0 x 61.5 cm. The front fence and the back plane
are screwed onto the bottom plate from above wich measn that the bottom plate is 61.5 – 2x plywood
witdh. The sides are screwed onto the bottom plate from the side.
The height of the GT-10 front fence is 3 cm. The height of the back plane is 18 cm.
The interior of the box contains wooden guides for the top tier as it is slided in.
The top tier:
Height : 27.5cm, Length:60cm,
Depth of four cutouts 4.5cm. The two fences for holding the Gr-55 in place are 2.5 cm high.
The support is placed so it does not interfere with cables going out from the GT-10