Code of Practice Five (COP5- 1MW) remote metering box ... · Dec 2016 WAGO Limited, Triton Park,...
Transcript of Code of Practice Five (COP5- 1MW) remote metering box ... · Dec 2016 WAGO Limited, Triton Park,...
Code of Practice Five (COP5- 1MW) remote metering box assembly for one Meter
The COP5 box assembly by WAGO LTD comprises:-
3 pairs of CT terminals (282-870) suitably configured to ensure the CT’s cannot be left open circuit when the meter is disconnected. This is achieved by means of a sliding lever built into the terminals. The CT terminal levers are clipped together so both operate simultaneously, lockouts are fitted to stop accidental moving of the levers. Additional wiring and links have been added so that only 4 wires are required from the CT’s (1 per CT and 1 commoned return) and 4 wires going to the meter.
• 4 x isolation terminals with test points for the incoming VT wiring.• 3 x 4A fused terminals and 1 disconnect terminal for the VT connections to the meter.• 1 x 2A fused terminal and 1 disconnect terminal for auxiliary devices.• 1 x 2 conductor 2.5mm2 earth terminal .
The unit is supplied in an ABS hinged lid box 380 x 280 x 180mm suitable for mounting 1 meter on the lid, the 2 corner fixing screw points are drilled to allow locking wire seals to be used.
The terminals and wiring are marked with terminal and wire markers in accordance with REC requirements, the CT wires are 3m long and meter wires 500mm long.
All boxes are supplied tested with a certificate of testing and conformity.
WAGO part number 50078315.
Description and Handling:-Disconnect link in notched position “I”
In position “I”, the measuring instrument is connected to the transformer.
B = shorting jumper P = test socket
By moving the interlocked disconnect links from “I” to “TEST” the shorting path is activated without disconnection of the measuring instrument yet.
The measuring instrument is electrically disconnected from the transformer. In this position, if necessary, external voltage can be applied via sockets, or the 2nd CAGE CLAMP® connection for relay testing in transformer protection circuits.
Disconnect link in transition from “I” -> “TEST” (terminal blocks 1 + 2)
Disconnect link in notched position “TEST” (terminal blocks 1 + 2)
L1
L2
L3
N
DISCONNECTTERMINALS
CT TERMINALARRANGEMENTWITH LINKS
FUSETERMINALS
2A 4A 4A 4ALINK LINK
D12
D32 D52
D70
E70
E52
E32
E12
E10
E30
E50
E70
D11
D31
D51
D70
COP5CONNECTIONS TO METER
AND CT'S
AUXEQUIPMENT
COP5 Connections to Meter and CT’s:-
COP5 Enclosure Dimensions
380mm
280mm
180mm
Dec 2016
WAGO Limited, Triton Park, Swift Valley Industrial Estate, Rugby, Warwickshire, CV21 1SG Tel: 01788 568 008 - Fax: 01788 568 050 - [email protected] - www.wago.com WAGO is a registered trademark of WAGO Verwaltungsgesellschaft mbH.
WAGO also produce a COP3 main and check meter box arrangement and a COP2 meter box, see separate data sheets.
Other variations of metering boxes are available upon request, or our Engineering Department can design a solution for your requirements.