LED Luminaires

Installation Manual

Performance:

The diffuser is made of Polycarbonate (PC) with a high lighting transmittance.

External housing is made of opaque PC withoutdoor mechanical performance.

This product is in compliance with EN60598-1and EN 60598-2-1

This Product is an IP 65 Waterproof Luminaireand is suitable for outdoor use where dust and moisture ingress may be an issue.

Safety Instruction:Electrical installation should be done by Licensed electrician only;

Never touch the lamp while the luminaries are switched on;

In case of failure, please switch off the powersupply;

The light source contained in this luminaireshall only be replaced by the manufacturer orhis service agent or a similar qualified person

Note:Do not make extra holes on the housing, usethe existing holes to avoid any warranty orwater ingress.

Product Data:

For Product information:

www.s-tech.com.au

Class I

D IP65

IEC60598

Model Voltage Power CCT CRI Lumen

WP-4FT-2-40-2C

WPE-4FT-2-40-2C

220-240V50/60Hz

220-240V50/60Hz

220-240V50/60Hz

220-240V50/60Hz

40W

40W

20W

10W

5000K

≥80Ra

≥80Ra

≥80Ra

≥80Ra

4000lm

4000lm

2000lm

1000lm

Parameter Tolerance:±10%

WP-4FT-1-20-2C5000K

WP-2FT-1-10-2C5000K

WARNING- Damage could result1. Only touch the metal plate, DO NOT touch any of the LED's or LED boards.2. Never remove the tray using internal wires, use an appropriate tool or tab to lift the tray.3. Do not stack internal panels or allow any solid objects to hit the LED's, terminals or drivers.

4000K

4000K

4000K

4000K

5000K

Product Size:

Exploded View:

Note: Please use a licensed electrician for all installations.1) Put the power cable through the cableentry into the housing,and then screw down

.

2) A:Regular Light Cable Connection Put the Brown power wire into L and the Blue power wire into N,the Yellow andGreen wire into Earth terminal.

N

L

W

H

1263

1263

1263

653

130 78 838 10

Model L(mm)

clipquantity

W(mm)

H(mm)

LF(mm)

L

LF

HookClip

Body

Driver

Diffuser

LED Module

Ø7-9mm

5) Open the clips

Double ModuleRotate the bracket by 90 degree by hand to disassemble the reflector.

Rotate the bracket by hand

WPE-4FT-2-40-2C

WP-4FT-1-20-2C

WP-2FT-1-10-2C

WP-4FT-2-40-2C

10

10

6

838

838

416

78

78

78

130

85

85

Reflector

Connecting the power cable

B:Emergency Light Cable Connection Put the Brown power wire into L and the Blue power wire into N,the Yellow andGreen wire into Earth terminal.

N

LL

INSW

INL:LIVE(non-switched)SWL:LIVE(switched)

Single Module

4)Mounting Types: There are two ways of mounting the lighting fixture :chain mount or ceiling mount.

A.chain mount B.ceiling mount

6) Disassemble the reflector.

3) LED color temperature options

5000K

4000K