Cisco Packet Tracer Lab7-2
description
Transcript of Cisco Packet Tracer Lab7-2
1 - .. )CLI ( Command Line Interface
:[ Continue with configuration dialog? [yes/no
( no ) : !Press RETURN to get started
.. Enter .. >Router
1
.. : Router> enable Router# configure Configuring from terminal, memory, or network [terminal]? Enter configuration commands, one per line. End with CNTL/Z. Router(config)# enable secret 12345
.. ) ( Router(config)# hostname UN
2
enable ( ) ..
: : UN(config)# exit UN# exit .Press RETURN to get started >UN enable UN> enable ..
3
: 54321 ( Enter ).
2 - Console .. Terminal Desktop
.. ok
..4
.. .. Enter no
Router > .. Router> enable Router# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)# line console 0 Router(config-line)# password 12345 Router(config-line)# login
Exit Router> End .. Router(config)> Router(config-line)# exit Router(config)# hostname GF
5
- :
> Router : Exit GF(config)# exit %SYS-5-CONFIG_I: Configured from console by console GF# exit GF con0 is now available .Press RETURN to get started User Access Verification :Password
: Password ..
6
( : ) GF
GF ..
: GF ( 0/0.. ) S2/0 & F
1- 0/2 :S 61/1.0.71.271 ( clock rate 00046 ) no shutdown .
: GF> enable GF# configure ?]Configuring from terminal, memory, or network [terminal .Enter configuration commands, one per line. End with CNTL/Z7
GF(config)# interface S2/0 GF(config-if)# ip address 172.17.0.1 255.255.0.0 GF(config-if)# clock rate 64000 GF(config-if)# no shutdown %LINK-5-CHANGED: Interface Serial2/0, changed state to down GF(config-if)# exit GF(config)# ..
: 1.0.61.271 F0/0 2- .. no shutdown
GF(config)# interface f0/0 GF(config-if)# ip address 172.16.0.1 255.255.0.0 GF(config-if)# no shutdown
8
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up ,0/0%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet changed state to up GF(config-if)# exit #)GF(config
0/0 F ..
( : ) GF RIP
: GF(config)# router rip ( Direct .. 0.0.61.271 ( ) 0.0.71.271 ..9
0.0.61.271 GF(config-router)# network 0.0.71.271 GF(config-router)# network GF(config-router)# exit RIP
.. RIP ..
( : ) UN
: UN ( 0/0.. ) S2/0 & F 1- 0/2:S 0/2UN(config)# interface s 0.0.552.552 2.0.71.271 UN(config-if)# ip address11
[ 2.0.71.271 ] 00046 UN(config-if)# clock rate UN(config-if)# no shutdown UN(config-if)# exit #)UN(config
2- 0/0:F 0/0UN(config)# interface f 0.0.552.552 1.0.81.271 UN(config-if)# ip address UN(config-if)# no shutdown ... ...
11
( : ) UN RIP
: UN(config)# router rip #)UN(Config-router .. ] 0.0.71.271 [ ] 172.18.0.0 ] FastEthernet
0.0.71.271 UN(Config-router)# network 0.0.81.271 UN(Config-router)# network
..
21
..
: .. Gateway 1 : UN Config 0/0 Fast Ethernet ip address Gateway ...
31
Config Gateway ...
Fast Ethernet 1 2 ...
41
ip address Fast Ethernet 1 3 4 ..
51
2 : GF .
:
: Show Run GF# Show run
terminal # GF Exit Show run ... Enter Router rip
61
( Routing Table ):
.. GF# Show Ip route
... ...71
.. Successful
successful ...
... 1 - 0 PC ( ) ping 2.0.81.271 ...
81
2 - 3.0.61.271 3.0.81.271 ...
3 - ( )ping 2.0.81.271 4.0.61.271...
91
.. ping ... Show ip route .. Show ip route
direct 1717617271 0/2... s ( ) [ ]
: Ipconfig /all
12
simulation .
[ Packet Tracer .. ]
/ .12
/