CHEMISTRY - TRO 4E CH.14 - CHEMICAL...
Transcript of CHEMISTRY - TRO 4E CH.14 - CHEMICAL...
! www.clutchprep.com
!
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
CONCEPT: RATES OF CHEMICAL REACTIONS
____________________________ is the study of reaction rates, and tells us the change in concentrations of reactants or
products over a period of time.
Although a chemical equation can help us calculate the theoretical yield from reactants, it can’t tell us how fast it goes.
• Looking at a chemical reaction in the simplest way can be seen as ___________ breaking down to form
______________.
A BReaction :
0 Seconds 30 Seconds 60 Seconds 90 Seconds
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 2
CONCEPT: FACTORS INFLUENCING REACTION RATES
VS.
1. Concentration: Molecules must _________________ to react.
• Increasing the number of molecules in a container, increases their _______________ and thereby causes the rate
to increase.
A BReaction : A B+
2. Surface Area: The frequency of collisions increases with ____________________ surface area.
CH3CH2CH2CH3 VS.
H2C
H2C CH2
CH2
3. Temperature: Increasing the temperature increases the reaction rate by increasing the ___________ and
___________ of collisions.
4. Catalyst: A catalyst increases the rate of a reaction by ______________________ the energy of activation.
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 3
CONCEPT: GENERAL RATE
The General Rate of a chemical reaction is the change in some variable over a period of time.
Rate = Δ [A]Δ time
A = ____________ or ____________ .
The use of brackets. [ ], means ____________________ .
EXAMPLE 1: The following equation shows the production of NO and H2O by oxidation of ammonia.
4 NH3 (g) + 5 O2 (g) 4 NO (g) + 6 H2O (l)
a. What is the average rate of each compound in the balanced
equation?
b. What is the rate of NH3 in the reaction between 2 and 6 minutes at 40oC?
c. Determine the instantaneous rate of the following reaction.
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 4
PRACTICE: STOICHIOMETRIC RATES
EXAMPLE: The decomposition of dinitrogen pentoxide is described by the chemical equation
2 N2O5 (g) 4 NO2 (g) + O2 (g)
If the rate of disappearance or decomposition of O2 is equal to 2.20 M/min at a particular moment, what is the rate of appearance or formation of N2O5 at that moment?
PRACTICE: The formation of alumina, Al2O3, can be illustrated by the reaction below:
4 Al (s) + 3 O2 (g) 2 Al2O3 (s)
At 750 K it takes 267 seconds for the initial concentration of Al2O3 to increase from 6.18 x 10-5 M to 5.11 x 10-4 M. What is
the rate of Al?
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 5
CONCEPT: TEMPERATURE AND RATE
Temperature can have a huge effect on the reaction rate. It affects the rate by affecting the rate constant, k.
• Increasing the temperature or ______________ amount of catalyst will ______________ the rate constant, k.
• The ______________ Equation relates both the temperature and the rate constant.
For a reaction to be successful the molecules must collide with sufficient ____________________ and the correct
____________________.
Conversion of the equation into its logarithmic form can help us find Ea when two rate constants or temperatures are given.
ln k2k1=−EaR
1T2−1T1
"
#$
%
&'
A plot-wise approach can also be used to convert the equation in order to find Ea.
ln A
slope = ΔyΔx
= −EaRln k
1T
k =Ae−Ea
RT
A =
Ea =
R =
T =
lnk = − EaR
"
#$
%
&'1T"
#$
%
&'+ lnA
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 6
PRACTICE: TEMPERATURE AND RATE (CALCULATIONS)
EXAMPLE: The reaction 2 HCl (g) H2 (g) + Cl2 (g) has Ea of 1.77 x 104 kJ/mol and a rate constant of 1.32 x 10-1
at 700 K. What is the rate constant at 685 K?
PRACTICE 1: If a first order reaction has a frequency factor of 3.98 x 1013 s-1 and Ea of 160 kJ, then calculate the rate
constant at 25oC.
PRACTICE 2: Generally, the slower the rate of the reaction then the ___________ the energy of activation (Ea) and the higher the temperature, the ____________ the value of rate constant, k.
a) larger, larger b) smaller, smaller c) smaller, larger d) larger, smaller
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 7
CONCEPT: RATE LAW
Although, chemical reactions can be reversible we will only look at the ___________ reaction for chemical reactions.
• By ignoring ___________ reactions then the rate depends only on __________ concentrations and ___________.
4 NO (g) + O2 (g) 2 N2O3 (g)
Rate Law = k [NO]x [O2]y k = ___________________________________
x & y = ___________________________________
Unless the reaction is classified as a ______________ step, a rate-determining step, then x & y must be calculated
experimentally.
EXAMPLE: For the following reaction, use the given rate law to determine the best answer for the reaction with respect to each reactant and the overall order.
H2O2 (aq) + 3 I – (aq) + 2 H+ (aq) I3 – + 2 H2O (l) Rate = k [H2O2]2 [I –]
a) H2O2 is 1st order, I – is 1st order, 2nd order overall.
b) H2O2 is 2nd order, I – is 1st order, 3nd order overall.
c) H2O2 is 0th order, I – is 1st order, H+ is 1st order, 3rd order overall.
d) H2O2 is 2nd order, I – is 1st order, H+ is 0th order, 3rd order overall.
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 8
PRACTICE: REACTION ORDERS
Answer each of the following question based on the following chemical reaction:
3 A (g) + B (g) + 2 C (g) D (g)
Experiment Initial [A] Initial [B] Initial [C] Initial Rate
1 0.0500 M 0.0500 M 0.0100 M 6.25 x 10-3
2 0.1000 M 0.0500 M 0.0100 M 1.25 x 10-2
3 0.1000 M 0.1000 M 0.0100 M 5.00 x 10-2
4 0.0500 M 0.0500 M 0.0200 M 6.25 x 10-3
EXAMPLE 1: Calculate the reaction order for reactant A.
PRACTICE: Calculate the reaction orders for reactants B and C.
EXAMPLE 2: Calculate the rate constant and the new rate for the given reaction if the the initial concentrations of [A] =
0.300 M, [B] = 0.150 M and [C] = 0.150 M.
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 9
PRACTICE: RATE CONSTANT & RATE
EXAMPLE 1: A certain chemical reaction has the given rate law:
Rate = k [A]3 [B]2 [C]-1
What are the units of the rate constant for the given reaction?
a) M-2 · s-1 b) M2 · s-1 c) M-4 · s-1 d) M-3 · s-1 e) M3 · s-1
EXAMPLE 2: The reaction of 3 A + B 2 C + D, was found to be: Rate = k [A]2 [B]3. How much would the rate
increase by if A were tripled while B were increased by half?
a) 0.50 b) 30.38 c) 0.75 d) 20.25 e) 1.125
PRACTICE: If the rate law for the following reaction is found to be the following: Rate = [Cl2 ] ⋅[HCCl3] . What are
the units for the rate constant, K?
Cl2 (g) + HCCl3 (g) HCl (g) + CCl4 (g)
a) M3/2
s b) Ms c)
1M ⋅s d)
1M3/2 ⋅s e) M ⋅s
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 10
CONCEPT: REACTION PATHWAYS
A reaction ____________________ is a sequence of single reaction steps that add up to the overall chemical reaction. For example a possible chemical setup for the overall reaction:
A + 2 B E
might involve these steps:
1) A + B C
2) B + C D
3) D E
EXAMPLE 1: The elementary reaction, 2 NOBr (g) 2 NO + Br2, is an example of a _____________ reaction.
a) Unimolecular b) Dimolecular c) Bimolecular d) Tetramolecular
EXAMPLE 2: Answer the following questions to the following reaction:
Br + O2 + O BrO + O2 [FAST]
Br + BrO + O Br2O + O [SLOW]
a. Identify the intermediate(s).
b. Identify the catalyst(s).
c. What is the overall reaction?
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 11
CONCEPT: 1ST, 2ND or 0TH: WHAT’S YOUR ORDER?
If you were super observant you might have noticed that although we were talking about rate, the rate law didn’t include ___________ as a variable.
The good thing is that the _______________ Rate Laws help to answer an important question in kinetics:
• “How long will it take x moles per liters of A to be consumed?”
Rate Laws Zero-Order First-Order Second-Order
Rate Equations
Half-Life
A BReaction :
[A]t = −kt +[A]0 ln[A]t = −kt + ln[A]01[A]t
= kt + 1[A]0
[A]
Time
[A]0
Slope = - k
ln[A
]
Time
ln[A]0
Slope = - k
1/[A
]
Time
1/[A]0
Slope = k
t 12=[A]02k
t 12=ln2k
t 12=
1k[A]0
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 12
PRACTICE: INTEGRATED RATE LAWS (CALCULATIONS)
EXAMPLE 1: The oxidation of ethane follows a first order mechanism, with a very high rate constant of 32 s-1, to form H2O
and CO2 as products. If the initial [C2H6] is 4.12 M, what is the concentration after 1.12 x 10-3 minutes?
EXAMPLE 2: Iodine-123 is used to study thyroid gland function. This radioactive isotope breaks down in a first order process with a half-life of 8.50 hours at 800 K. How long will it take for the concentration of iodine-123 to be 74.1% complete?
PRACTICE 1: At 25oC, 2 NOBr (g) 2 NO (g) + Br2 (g). The rate of the reaction is found to be: rate = k [NOBr]2.
The constant at 25oC is 7.80 x 10-4 M-1 · s-1. If 0.550 moles of HBr (g) is placed in a 5.0 L container, how long will take for
the concentration to reach 0.063 moles of HBr (g)?
PRACTICE 2: In a typical chemical reaction, nitrogen trioxide, NO3, reacts to produce nitrogen dioxide, NO2, and oxygen gas, O. 2 NO3 (g) 2 NO2 (g) + 2 O (g)
A plot of [NO3] vs. time is linear and the slope is equal to 0.183. If the initial concentration of NO3 is 0.930 M, how long will it take for the final concentration to reach 0.400 M?
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 13
PRACTICE: INTEGRATED RATE LAWS (CALCULATIONS 2)
EXAMPLE: Given the following graph for a second order reaction:
a) Calculate the frequency factor.
b) Calculate the energy of activation in (J/mol):
PRACTICE: The three plots were done based on a chemical reaction.
a. What is the rate constant of the reaction if it takes 21.2 minutes for the reaction to be 38.0% complete?
0,0.569
0.0047,00
0.00050.0010.00150.0020.00250.0030.00350.0040.00450.005
0 0.2 0.4 0.6
lnK
1/T(K)
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 14
CONCEPT: HALF–LIFE Half-life is defined as the time it takes for half of the amount of a substance to decay in a certain amount of time.
• However, this is mainly true for a ______ order reaction. Zero-Order First-Order Second-Order
t 12=[A]02k
t 12=ln2k
t 12=
1k[A]0
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 15
CONCEPT: INTEGRATED RATE LAWS Zeroth Order
• The concentration of reactants decreases in a uniform manner over time. • The rate of the reaction remains constant.
First–Order
• The concentration of reactants decreases in a logarithmic manner. More recognizable by a constant half-life. • The rate of the reaction decreases uniformly.
Second-Order
• The largest drop in concentration occurs initially followed by a decreasing loss of reactant. More recognizable by an increasing half-life
• The rate of the reaction decreases substantially before leveling off.
Time Concentration
[Reactants]
TimeRate
Time
[Products]
Time
Rate
Time
Time Concentration
[Reactants]
Time
Rate
Time
[Products]
TimeRate
Time
Time Concentration
[Reactants]
Time
Rate
Time
[Products]
Time
Rate
Time
CHEMISTRY - TRO 4E
CH.14 - CHEMICAL KINETICS
Page 16