Chapter 05- Foundations of Firefighting Tactics and Strategies
-
Upload
snoshoesam -
Category
Education
-
view
7.014 -
download
2
description
Transcript of Chapter 05- Foundations of Firefighting Tactics and Strategies
© 2009 Delmar, Cengage Learning
Foundations of Fire Fighting Tactics and Strategies
Chapter 5
© 2009 Delmar, Cengage Learning
Objectives
• Describe the process of developing the fire fighting strategy and tactics involved in planning, locating, confining, extinguishing, and overhauling fires in buildings and other special fire situations
• Discuss the methods used for the determination of the proper fire operating mode: offensive, transitional, defensive, or non-attack mode
© 2009 Delmar, Cengage Learning
Objectives (cont’d.)
• Define the term size-up and explain the steps and factors involved in making a size-up
• Review the fire strategy and tactics used by firefighters and apply the fire behavior characteristics discussed in the text to the situations reviewed
• Describe difficult fire situations encountered by firefighters and the strategies and tactics they should use to resolve these situations
© 2009 Delmar, Cengage Learning
Introduction
• Learn about:– Structure fires and fire behavior patterns most likely to
be encountered– How to apply fire behavior tactics
• Overall mission for fire incidents has three major components: finding the location of the fire, confining the fire, and extinguishing the fire
• Size-up: method used to identify problem(s) presented by the incident
© 2009 Delmar, Cengage Learning
Development of Strategy and Tactics
• Overall mission for firefighters responding to fire:– Locate the fire– Confine the fire– Extinguish the fire
• Decision-making model: overall strategy on emergency incidents
© 2009 Delmar, Cengage Learning
Development of Strategy and Tactics (cont’d.)
Figure 5-2 The five steps in the decision-making model
© 2009 Delmar, Cengage Learning
Attack Modes
• Offensive mode: make a direct attack on fire for purposes of control and extinguishment
• Transitional mode: shifting from offensive to defensive mode or from defensive to offensive mode
• Defensive mode: conducted on exterior of building to protect adjacent buildings from fire spreading
© 2009 Delmar, Cengage Learning
Attack Modes (cont’d.)
• Non-attack mode (passive approach): under certain circumstances, a fire attack may be too dangerous and incident command will choose to let the fire burn out without an attack– Cannot be made without careful consideration and by
making every effort to include the owner in the decision making process
© 2009 Delmar, Cengage Learning
Size-Up at the Incident Scene
• RECEO-VS– Rescue– Exposures– Confinement– Extinguishment– Overhaul– Ventilation– Salvage
© 2009 Delmar, Cengage Learning
Construction
• Includes building components, materials, and extent of their fire-resistive abilities
• Five NFPA classifications – Type I, II, III, IV, and V
© 2009 Delmar, Cengage Learning
Type I or Fire-resistive Construction
• Columns, beams, floors, walls, and roof made of materials classified as non-combustible
Figure 5-4 Type I orfire-resistive construction
© 2009 Delmar, Cengage Learning
Type II or Non-combustible Construction
• Non-combustible and either protected or unprotected
Figure 5-5(a) Type II or noncombustible construction
© 2009 Delmar, Cengage Learning
Type III or Exterior Protected/Ordinary Construction
• Exterior walls made of masonry materials
• Interior walls and materials permitted to be partially or wholly combustible
Figure 5-6 Type III or ordinary construction
© 2009 Delmar, Cengage Learning
Type IV or Heavy Timber/Mill Construction
• Exterior walls are usually made of masonry and therefore are non-combustible
Figure 5-7 Type IV or heavy timber/mill construction
© 2009 Delmar, Cengage Learning
Type V or Wood Frame Construction
• All major structural components can be made of combustible materials
Figure 5-8 In Type V construction, all major structural components can be made of combustible materials
© 2009 Delmar, Cengage Learning
Occupancy or Use
• The building code that classifies buildings by their use
• Loss of lives in building fires is always a concern where large numbers of people gather
© 2009 Delmar, Cengage Learning
Apparatus and Staffing
• Standard operating procedure (SOP): specific information and instructions on how a task or assignment is to be accomplished
• Need to know manpower resources– Number, type of pumping, and ladder capability
© 2009 Delmar, Cengage Learning
Life Hazard
• Primary search– Aggressive primary search for victims during the first
few moments after arrival
• Personal alert safety system (PASS)– Small, motion sensitive unit attached to and worn with
the SCBA by firefighters when entering an Immediately Dangerous to Life and Health (IDLH) environment
© 2009 Delmar, Cengage Learning
Terrain
• Structure can be built on land with different grade levels
• Careful pre-incident planning can help in reducing the time required to deal with terrain problems
© 2009 Delmar, Cengage Learning
Water Supply
• Can water be delivered in sufficient gallons per minute to suppress the number of BTUs being given off by the fire?
• Learn location of water lines of other jurisdictions or districts
© 2009 Delmar, Cengage Learning
Auxiliary Appliances
• Fire sprinklers have record of over one hundred years of being 90% to 98% effective in controlling fires
• Three types of water sprinkler application systems – Wet pipe– Dry pipe– Deluge
© 2009 Delmar, Cengage Learning
Street Conditions
• Narrow streets, traffic congestion, double-parked cars, and construction work can severely impact fire operations
• Close coordination with public works and traffic departments can reduce such problems
© 2009 Delmar, Cengage Learning
Weather
• Extreme weather conditions can affect operations
• Rehabilitation system:– Hydration– Nourishment– Rest and recovery– Medical evaluation
© 2009 Delmar, Cengage Learning
Exposures
• Using water by running it down side of exposed building, coating it with water
• Water spray can protect against movement of heated air currents and direct flame impingement
• Use large water appliances to reduce or redirect air currents and to cool threatened building surfaces
© 2009 Delmar, Cengage Learning
Area and Height
• Indicates maximum potential fire area• Height of building raises issues of whether the
fire department has necessary ladder lengths to reach upper building areas
• Height may provide exposure hazard to nearby buildings
• Impacts use of master streams
© 2009 Delmar, Cengage Learning
Location and Extent of Fire
• The lower the fire, the more serious the threat of fire is to the building
• Fire below grade such as a basement fire, are hotter, and generally more complex
© 2009 Delmar, Cengage Learning
Time
• May determine life-threatening situation• Time of day impacts time required for a fire
apparatus to arrive– Morning and evening traffic peaks can double the
response time
© 2009 Delmar, Cengage Learning
Special Concerns
• Personnel accountability report (PAR): reports on location/condition of personnel
• Personnel accountability system (PAS): determines entry/exit of personnel
• Rapid intervention team or crew (RIT/RIC): assignment of group for rapid deployment of reports on personnel in trouble/missing
© 2009 Delmar, Cengage Learning
Fire Behavior in Specific Occupancies
• Different procedures need followed for various types of buildings
• Important to understand essential differences of building methods and building types when evaluating how to approach a fire
© 2009 Delmar, Cengage Learning
Building Construction Methods and Occupancy Types
• Platform construction method: floors built separately from outer walls and ceiling and floor area serves as fire block to stop movement of hot fire gases between floors
• Balloon frame method of construction: obsolete construction method where wood studs run from foundation to roof and floors are nailed to studs
© 2009 Delmar, Cengage Learning
Single-Story Family Dwellings of the Past
• 1940s – 1950s– Plastered walls covering wood/wire mesh which was
painted/covered with heavy paper or cloth– Bare wood, rugs, linoleum, wool carpets– Bare wood to upholstered furniture with cotton, wool,
or leather– Rooms poorly insulated with single-paned windows– Fire load was low and the rooms were well ventilated
© 2009 Delmar, Cengage Learning
Today’s Residential Properties
• Better insulation and increase in fire load• More plastics• Interior fire fighting hotter• Decreased time to flashover• Has become much more dangerous in these
occupancies
© 2009 Delmar, Cengage Learning
Multiple-family Dwellings
• Vary from city to city
Figure 5-16 Open atticand truss construction
© 2009 Delmar, Cengage Learning
Mercantile Fires
• Strip malls made as cheaply as possible• Barely meet code requirements• Fire originating in one store of a strip has good
chance of communicating to others – Can extend into cockloft area and once there, will
move horizontally with little or no resistance
• Roof ventilation is important
© 2009 Delmar, Cengage Learning
Hotel Fires
• Not designed with fire safety in mind• Older hotels built with open stairways and rooms
off of corridors with transoms• HVAC units can circulate hot fire gases
throughout the building if unit is not protected with fire dampers
• Not equipped with an eyebrow– Designed to prevent or inhibit fire and smoke from
lapping into the upper floor(s) in a multistory building
© 2009 Delmar, Cengage Learning
Industrial Occupancies
• Vary considerably due to manufacturing processes
• Tenant factory/loft building– Potential for a fast-spreading fire is high
• Newer manufacturing buildings constructed using concrete tilt-up construction– Provide open void spaces where fire gases can
accumulate
© 2009 Delmar, Cengage Learning
Churches
• Similar construction• Large hanging ceilings or cocklofts lead to
church’s destruction• If steeple present, collapse is likely• Life safety record for church fires is good
© 2009 Delmar, Cengage Learning
Schools
• Fire drills usually constructed• Significant improvement in the use of fire-
resistant construction materials in new schools• Some schools use modular classrooms
© 2009 Delmar, Cengage Learning
Basement Fires
• Good location for storage of combustible items• Can become fully developed and present a very
hot, smoky fire situation where visibility is limited• Long hoses may be required• Possibility of gas ignition
© 2009 Delmar, Cengage Learning
Attic Fires
• Burn upward• Respond quickly to proper vertical ventilation• Should be attacked as fast as possible• As little water as possible should be used
© 2009 Delmar, Cengage Learning
Flat Roofs
• Attic space is approximately three feet deep and provides open space between underside of roof and top side of ceiling
• Always work with wind at your back or side from where the wind is blowing: windward side– Keeps smoke and hot gases downwind
© 2009 Delmar, Cengage Learning
Peaked Roofs
• Encourage the use of aerial ladders• Roof ladder also used if aerial not possible• Vent hole cut as close to the ridge as possible
without damaging the underlying rafters– Should be made on leeward side
© 2009 Delmar, Cengage Learning
Carport/Garage
• Carport: freestanding structure open on all sides– Carport itself is not serious fire problem because it is
constructed using a minimum amount of combustible materials
– Flammable liquid fires common
• Garage– One-story: line inside house to prevent extension of
the fire into this area– Two-story: direct attack on garage and line upstairs
© 2009 Delmar, Cengage Learning
Summary
• Understand basic principles of fire fighting and characteristics of fire behavior
• Three efforts:– Locate the fire– Confine the fire– Extinguish the fire
• Determine type of attack necessary