Chapeu instruçoes

1

A

A

B

B

1-1 1-2

1-3

1-4

1-5

1-6

1-7

1

Before starting assembly:Writing the number of each section on its back side before cutting out the sections is highly recommended. (* This way, you can be sure which section is which even after cutting out the sections.)

Indicates where sections should be glued together.

*Hint: Trace along the folds with a ruler and an exhausted pen (no ink) to get a sharper, easier fold.

Assembly Instructions: Six A4 sheets (No.1 to No.6)*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.

View of completed model

Witch's hat and broom (Halloween): Assembly Instructions

http://www.canon.com/c-park/en/

Assembly InstructionsMountain fold(dotted line)Make a mountain fold.

Valley fold(dashed and dotted line)Make a valley fold.

Scissors line(solid line)Cut along the line.

Cut in line(solid line)Cut along the line.

Glue spot(Red dot)Glue parts with the same number together.

Glue spot(Green dot)Glue within the same part.

Glue spot(Blue dot)Glue to the rear of the other part.

Tools and materials

Assembly tip

Caution

Scissors, set square, glue(We recommend stick glue), pencil, usedballpoint pen, toothpicks, tweezers, (useful for handling small parts)

Before gluing, crease the paper along mountain fold and valley fold lines and make sure rounded sections are nice and stiff.

Glue, scissors and other tools may be dangerous to young children so be sure to keep them out of the reach of young children.

Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Takako Takahashi

GlueThe glue spot(colored dot)shows where to apply the glue.

1

2

2

Witch's hat and broom (Halloween): Assembly Instructions Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Takako Takahashi

Glue parts 2-1, 2-2, and 2-3 to the inside of part 1.

After gluing the shaded area on the cross-section diagram, cut along lines in parts 2-1, 2-2, and 2-3.

Glue parts 2-4, 2-5, and 2-6 from above.

3-13-2

3-3

3-4

3 3

1+2

3


Glue to the inside at whatever angle you prefer.

4-1

4-2

4-3

4


Glue any design you prefer to any position on the hat.

The hat is finished!

5-15-25-35-4

5

6-1

6-1

6-2

6-1

6-2

2

1

2

1

5


Glue to the inside, matching the wood grain.



After gluing point 1, roll tightly and glue point 2.

After gluing point 1, roll tightly and glue point 2. Use a round pencil or other cylindrical object to curve this piece.

6-36-3

5

5-5

6-4

7-1

7-2

7-3

7-4

8-1

8-2

9

6-4

2

1

2

1

6




Glue to the inside.

Use any string you like to hang part 7 (the black cat), part 8 (the bat), and part 9 (the snake).

Chapeu instruçoes

Education

Transcript of Chapeu instruçoes