Change of Water Tank
description
Transcript of Change of Water Tank
Great Company Great People Fast Execution Profitable Growth
Change of Water Tank
TANK ASSEMBLY,WATER VALVE ASSEMBLY,WATER TANK ASSEMBLY,WATER
NEW(Coil Type)CURRUNT(Blow Molding Type)
• Change of the Water Tank Type
Because of change of water tank type, Water Valve Assembly isn’t used.So, The model applied Tube type Water Tank don’t have Water Valve Assembly.
Appried Plod ID : From 59RE1191(2005-09-09)
Great Company Great People Fast Execution Profitable Growth
Blow Molding Type
Coil Type
Bolw Molding Type
Coil Type
Defect Parts Service Parts
Service Plan
• Service Plan
Blow molding type only must be used in product before the change. New parts must be used in product sets after the change only.Remember that you should not change tank type. It means you mustchange same type water tank.
Coil Type
Great Company Great People Fast Execution Profitable Growth
Change method of Coil type Water Tank
• Change Process
Please see the process explained in the following pages, to change the new type of the water tank.
1) Disconnect power
2) Pry out the dispenser cover with a flat head screwdriver and swing the cover to the right hand.
3) Disconnect the connector from display board and remove the cover.
4) Remove the screws as shown in the picture below.
5) Separate the holder and the tube.
Great Company Great People Fast Execution Profitable Growth
6) Remove the restrainer on the upper right back of refrigerator.
7) Disconnect the connector from display board and remove the cover.
8) Remove the screws as shown in the picture below.
9) Separate the holder and the tube.
Change method of Coil type Water Tank
Great Company Great People Fast Execution Profitable Growth
10) Remove the spring from the tube.
11) After remove the door basket, Remove the two caps with a flat head screwdriver
12) Remove the screws in each hole.
13) Remove the cover, You can see the old water tank.
Change method of Coil type Water Tank
Great Company Great People Fast Execution Profitable Growth
14) ) Pull out the tubes from the door, And remove the old water tank.
15) Stand by the new water tank, And note there are two kinds of the tubes about length.
16) The short tube of a new water tank inserts to the upper hole, And mount the new water tank.
17) The long tube of a new water tank inserts to the lower hole.
Short tube
Long tube
Change method of Coil type Water Tank
Great Company Great People Fast Execution Profitable Growth
18) Push the cover to door, Tighten the two screw in the two holes .
19) Assemble the two caps, Mount the door basket.
20) In the hinge side, Assemble the spring to the tube as shown in picture below .
21) Insert the tube in the hole on the top of the refrigerator.
spring
Hole
Change method of Coil type Water Tank
Great Company Great People Fast Execution Profitable Growth
22) Assemble the cover of the hinge, Tighten the screw.
23) In upper and righ-hand side on the back of refrigerator, Assemble the tube to the connector. (Assemble method refer to label guide)
24) Assemble the cover to the back of the refrigerator, Tighten the screws .
25) In the front of the refrigerator, Assemble the tube to the holder .
Change method of Coil type Water Tank
Great Company Great People Fast Execution Profitable Growth
26) Mount the holder, Tighten the two screws. 27) Connect the connector to the board and re-position the dispenser cover.
Change method of Coil type Water Tank