Ch2 structure

19
Observed Structure of the Atmospheric Boundary Layer Many thanks to: Nolan Atkins, Chris Bretherton, Robin Hogan

Transcript of Ch2 structure

Page 1: Ch2 structure

Observed Structure of the Atmospheric Boundary Layer

Many thanks to: Nolan Atkins, Chris Bretherton, Robin Hogan

Page 2: Ch2 structure

Review of the last lectureIncoming shortwave + Incoming longwave = Reflected shortwave Incoming shortwave + Incoming longwave = Reflected shortwave

+ Emitted longwave + Latent heat flux + Sensible heat flux+ Emitted longwave + Latent heat flux + Sensible heat flux

• Incoming solar radiation = (Solar constant) cos(Solar zenith angle)

• Reflected solar radiation = (Incoming solar radiation) x Albedo

• Longwave I=T4

• Sensible heat flux Qh = Cd Cp V (Tsurface - Tair)

• Latent heat flux Qe = Cd L V (qsurface - qair)

• Bowen ratio B= Qh/Qe = Cp(Tsurface - Tair) / L(qsurface - qair) provides a simple way for estimating Qh and Qe when radiation measurements are available

Page 3: Ch2 structure

Vertical Structure of the Atmosphere

• Definition of the boundary layer: "that part of the troposphere that is directly influenced by the presence of the earth's surface and responds to surface forcings with a time scale of about an hour or less.”

• Scale: variable, typically between 100 m - 3 km deep

Page 4: Ch2 structure

Difference between boundary layer and free atmosphere

The boundary layer is:

• More turbulent• With stronger friction• With more rapid dispersion of pollutants• With non-geostrophic winds while the free

atmosphere is often with geostrophic winds

Page 5: Ch2 structure

Vertical structure of the boundary layer

From bottom up:• Interfacial layer (0-1 cm): molecular transport, no turbulence• Surface layer (0-100 m): strong gradient, very vigorous turbulence• Mixed layer (100 m - 1 km): well-mixed, vigorous turbulence• Entrainment layer: inversion, intermittent turbulence

Page 6: Ch2 structure

Turbulence inside the boundary layer

Definition of Turbulence: The apparent chaotic nature of many flows, which is manifested in the form of irregular, almost random fluctuations in velocity, temperature and scalar concentrations around their mean values in time and space.

Page 7: Ch2 structure

Generation of turbulence in the boundary layer: Hydrodynamic instability

“Hydrodynamically unstable” means that any small perturbation would grow rapidly to large perturbation

• Shear instability: caused by change of mean wind in space (i.e. mechanical forcing)

• Convective instability: caused by change of mean temperature in the vertical direction (i.e. thermal forcing)

Page 8: Ch2 structure

Shear instability

Shear: Change of wind in space

QuickTime™ and aTIFF (Uncompressed) decompressor

are needed to see this picture.

Page 9: Ch2 structure

Example: Kelvin-Helmholtz instabilityShear instability within a fluid or between two fluids with different density

Lab experiment

Real world (K-H clouds)

Page 10: Ch2 structure

Convective instability• Static stability – refers to atmosphere’s susceptibility to being displaced• Stability related to buoyancy function of temperature• The rate of cooling of a parcel relative to its surrounds determines its ‘stability’ of a parcel

• For dry air (with no clouds), an easy way to determine its stability is to look at the vertical profile of virtual potential temperature

v = (1 + 0.61 r ) Where

= T (P0/P)0.286 is the potential temperature

r is the water vapor mixing ratio

Three cases: (1) Stable (sub-adiabatic): v increases w/ height(2) Neutral (adiabatic): v keeps constant w/ height(3) Unstable (super-adiabatic): v decreases w/ height

Stable or sub-adiabatic

Neutral or adiabatic

Unstable or super-adiabatic

Page 11: Ch2 structure

Forcings generating temperature gradience and wind shear, which affect

the boundary layer depth

• Heat flux at the surface and at the top of the boundary layer

• Frictional drag at the surface and at the top of the boundary layer

Page 12: Ch2 structure

Boundary layer depth:Effects of ocean and land

• Over the oceans: varies more slowly in space and time because sea surface temperature varies slowly in space and time

• Over the land: varies more rapidly in space and time because surface conditions vary more rapidly in space (topography, land cover) and time (diurnal variation, seasonal variation)

Page 13: Ch2 structure

Boundary layer depth:Effect of highs and lows

Near a region of high pressure:• Over both land and oceans,

the boundary layer tends to be shallower near the center of high pressure regions. This is due to the associated subsidence and divergence.

• Boundary layer depth increases on the periphery of the high where the subsidence is weaker.

Near a region of low pressure:• The rising motion associated

with the low transports boundary layer air up into the free troposphere.

• Hence, it is often difficult to find the top of the boundary layer in this region. Cloud base is often used at the top of the boundary layer.

Page 14: Ch2 structure

Boundary Layer depth:Effects of diurnal forcing over land

• Daytime convective mixed layer + clouds (sometimes)• Nocturnal stable boundary layer + residual layer

Page 15: Ch2 structure

Convective mixed layer (CML):Growth

The turbulence (largely the convectively driven thermals) mixes (entrains) down potentially warmer, usually drier, less turbulent air down into the mixed layer

Page 16: Ch2 structure

Convective mixed layer (CML):Vertical profiles of state variables

Well-mixed (constant profile)

Super-adiabatic

Nearly adiabatic

Strongly stable lapse rate

Page 17: Ch2 structure

Nocturnal boundary layer over land: Vertical structure

• The residual layer is the left-over of CML, and has all the properties of the recently decayed CML. It has neutral stability.

• The stable boundary layer has stable stability, weaker turbulence, and low-level (nocturnal) jet.

Strongly stable lapse rate

Nearly adiabatic

Weakly stable lapse rate

Page 18: Ch2 structure

Boundary layer over land: Comparison between day and night

Kaimal and Finnigan 1994

• Subtle difference between convective mixed layer and residual layer: Turbulence is more vigorous in the former

Super-adiabatic

Nearly adiabatic

Strongly stable lapse rate

Strongly stable lapse rate

Nearly adiabatic

Weakly stable lapse rate

Page 19: Ch2 structure

Summary• Vertical structure of the atmosphere and

definition of the boundary layer• Vertical structure of the boundary layer • Definition of turbulence and forcings

generating turbulence• Static stability and vertical profile of virtual

potential temperature: 3 cases• Boundary layer over ocean• Boundary layer over land: diurnal variation

Please remember to bring your calculator on Friday