CERTIFICATE · described in Annex ZA of the harmonised standard EN 1090-1:2009+A1:2011 under system...
Transcript of CERTIFICATE · described in Annex ZA of the harmonised standard EN 1090-1:2009+A1:2011 under system...
![Page 1: CERTIFICATE · described in Annex ZA of the harmonised standard EN 1090-1:2009+A1:2011 under system 2+ are applied, and that the factory production control fulfills all the prescribed](https://reader030.fdocuments.us/reader030/viewer/2022040501/5e22aedcd47c0b7cd765b015/html5/thumbnails/1.jpg)
CERTIFICATEConformity of the Factory Production Control
0035-CPR-1090-1.01192.TÜVRh.2018.003In compliance with Regulation 305/2011/EU of the
European Parliament and of the Council of 9 March 2011 (the Construction ProductsRegulation or CPR), this certificate applies to the following construction product:
Construction product Structural components and kits for steel structuresto EXC3 according to EN 1090-2
Intended use for load-bearing structures in all types of buildings
CE – marking method ZA.3.2 and ZA.3.4 acc. to EN 1090-1:2009+A1:2011
produced by or for
Manufacturer Siebtechnik GmbHPlatanenallee 4645478 MülheimGERMANY
Manufacturing plantProduction facility of the manufacturer
Siebtechnik GmbHWeseler Str. 12145478 MülheimGERMANY
Confirmation This certificate attests that all provisions concerning theassessment and verification of constancy of performancedescribed in Annex ZA of the harmonised standardEN 1090-1:2009+A1:2011under system 2+ are applied, and that the factoryproduction control fulfills all the prescribed requirementsstated therein.
Date of first issue 10.06.2015
NextSurveillance audit 09.06.2019
Period of validity This certificate will remain valid as long as the test methodsand/or the factory production control requirements includedin the harmonised standard used to assess the performance of thedeclared characteristics do not change, and the product and themanufacturing conditions in the plant are not modified significantly.
Remarks see reverse
Place and date of issue Köln, 03.08.2018S. Kress
Dipl.-Ing. Makowka Head of certification body
![Page 2: CERTIFICATE · described in Annex ZA of the harmonised standard EN 1090-1:2009+A1:2011 under system 2+ are applied, and that the factory production control fulfills all the prescribed](https://reader030.fdocuments.us/reader030/viewer/2022040501/5e22aedcd47c0b7cd765b015/html5/thumbnails/2.jpg)
Certificate number: 0035-CPR-1090-1.01192.TÜVRh.2018.003
Remarks The Notified Body - 0035 TÜV Rheinland Industrie Service GmbH has performedthe initial inspection of the/of manufacturing plant(s) and of the factoryproduction control and performs the continuous surveillance, assessment andapproval of the factory production control.
General provisions
The conditions of the standard EN 1090-1:2009+A1:2011, from section B. 4.1 until including section B. 4.4,must be fulfilled.
The requirements of EN 1090-1:2009 + A1: 2011, section B. 4.3 are observed. These refer to the annualstatements to be submitted in writing of the manufacturer to the Notified Body.
The General Terms and Conditions of the TÜV Rheinland Industrie Service GmbH apply in the currently validversion.