CEREC 4.x Abutment Anatomic Parameters Occlusal Milling ...
8
CEREC 4.x Abutment Anatomic Parameters Updated: 04.26.2018 1 Occlusal Milling Offset - Applies or removes material in the occlusal direction over the entire occlusal surface. This value concerns only the milling result. The effects are not visible in the DESIGN phase or in the milling preview. Change this parameter as compensation if the occlusal surfaces of your restorations are generally too high or too low in practice.
Transcript of CEREC 4.x Abutment Anatomic Parameters Occlusal Milling ...
CEREC 4.x Abutment Anatomic Parameters
Updated: 04.26.2018 1
Occlusal Milling Offset - Applies or removes material in the occlusal direction over the entire occlusal surface. This value concerns only the milling result. The effects are not visible in the DESIGN phase or in the milling preview. Change this parameter as compensation if the occlusal surfaces of your restorations are generally too high or too low in practice.
CEREC 4.x Abutment Anatomic Parameters
Updated: 04.26.2018 2
Proximal Contacts Strength - Sets the thickness of the approximal contacts. The software tries to achieve this stored thickness in the restoration suggestions.
CEREC 4.x Abutment Anatomic Parameters
Updated: 04.26.2018 3
Occlusal Contacts Strength - Sets the thickness of the occlusal contacts. The software tries to achieve this stored thickness in the restoration suggestions.
CEREC 4.x Abutment Anatomic Parameters
Updated: 04.26.2018 4
Dynamic Contacts Strength -Sets the thickness of the occlusal contacts where the cusp tips that interact with the opposing jaw. The software tries to achieve this stored thickness in the restoration suggestions.
CEREC 4.x Abutment Anatomic Parameters
Updated: 04.26.2018 5
Gingival Depth - Determines how far below or above the preparation margin the gingiva lies in reference to the gingival line.
CEREC 4.x Abutment Anatomic Parameters
Updated: 04.26.2018 6
Gingival Placement Pressure - Determines how strongly the initial suggestion for the abutment penetrates the gingiva in order to build up pressure on the gingiva.
CEREC 4.x Abutment Anatomic Parameters
Updated: 04.26.2018 7
Minimal Thickness Radial - Determines the minimum radial wall thickness in the horizontal direction. Can be switched on and off. *Note when this is set to NO the software will automatically use the material manufacturer’s recommended minimal thickness setting.
CEREC 4.x Abutment Anatomic Parameters
Updated: 04.26.2018 8
Minimal Thickness Occlusal - Determines the minimum radial wall thickness in the occlusal direction. Can be switched on and off. *Note when this is set to NO the software will automatically use the material manufacturer’s recommended minimal thickness setting.
NOTE: There are no suggested settings for the Parameters. Users will dial in the Parameter settings for their machines and preferences.
![Internal - Luciano Chinellato · AnyOne® Internal è -P_[\YL 3L]LS 7YVZ[OLZPZ EZ Post Milling Abutment Angled Abutment CCM Abutment Temporary Abutment [Titanium] Temporary Abutment](https://static.fdocuments.us/doc/165x107/5c038f7909d3f2156d8cd7fd/internal-luciano-anyone-internal-e-pyl-3lls-7yvzolzpz-ez-post-milling.jpg)
