Ch. 10 – Routing Protocols CCNA 1 version 3.0 Rick Graziani Cabrillo College.
CCNA 3 Ch 9 v.3.1 Study Guide
-
Upload
joseph-jerry -
Category
Documents
-
view
222 -
download
0
Transcript of CCNA 3 Ch 9 v.3.1 Study Guide
-
7/30/2019 CCNA 3 Ch 9 v.3.1 Study Guide
1/3
Name: ________________________________ Date: __________
Northampton Community College
CISC 266 CCNA 3 -Network Design and Analysis
STUDY GUIDE FOR CHAPTER 10 (Online 9)
1. What is trunking?
2. What do trunking protocols allow?
3. VLAN Trunking Protocol (VTP) was created to solve potential operational problems in a VLAN switchedenvironment. Explain the fundamentals of VTP.
4. The role of VTP is to maintain VLAN configuration consistency across the entire network. Explain its benefits.
5. VTP switches operate in one of three modes . Explain these modes.
6. VTP Version 2 supports features not supported in Version 1. What are they?
CCNA 3 Ch 9 v.3.1 Study Guide Page 1 8/2004Kevin Manna
-
7/30/2019 CCNA 3 Ch 9 v.3.1 Study Guide
2/3
7. A switchs default behavior is to propagate broadcast and unknown packets across the network. This behavior
causes a large amount of unnecessary traffic to cross the network. What is VTP pruning?
8. In switched networks, route processors enable communication between VLANs. What do route processors
provide?
9. As the number of VLANs increases in a network, network administrators must determine whether they want to
have an individual router interface for each VLAN. What are possible solutions?
10. What are the Fast Ethernet and Gigabit Ethernet trunking modes, and what do they mean?
CCNA Exam Review Questions
1. What is the primary advantage of using a trunk link?A. It provides more bandwidth for each trunk.
B. It reduces router and switch ports.
C. It allows for a single VLAN on each physical port.
D. It creates less overhead on the router.
2. What protocol is Cisco-proprietary and is designed to carry traffic from multiple VLANs?
A. 802.11A
B. 802.1QC. VNET
D. ISL
3. VTP messages are encapsulated in either Cisco-proprietary Inter-Switch Link (ISL) or what type of frame?
A. IEEE 802.1D protocol frame
B. IEEE 802.1R protocol frame
C. 802.11D protocol frame
D. 802.19 protocol frame
CCNA 3 Ch 9 v.3.1 Study Guide Page 2 8/2004Kevin Manna
-
7/30/2019 CCNA 3 Ch 9 v.3.1 Study Guide
3/3
4. True or false: Two different versions of VTP can run in your management domain, VTP Version 1 and VTP
Version 2. The two versions are interoperable.
A. True
B. False
5. A switchs default behavior is to propagate broadcasts and unknown __________ across the network.
A. FramesB. Packets
C. Tags
D. VLANs
6. In switched networks, __________ is/are used to provide communication between VLANs.
A. Route processors
B. ModulatorsC. VT
D. Subnets
CCNA 3 Ch 9 v.3.1 Study Guide Page 3 8/2004Kevin Manna