Case study for oakham primary school
-
Upload
andy-brown -
Category
Documents
-
view
38 -
download
3
description
Transcript of Case study for oakham primary school
Consultant
■ BSD
Client
■ Lord Combustion Limited
Sector
■ Education
Products
■ DW Flue System
Equipment
■ MHS ADI LT
Application
■ High Efficiency Condensing
0844 809 2509 | airtherm.co.uk | [email protected]
Project Profile
Oakham Primary School, Dudley, West Midlands
Front Entrance
Twin wall flue
Airtherm have recently designed, supplied and installed a complete twin wall stainless steel flue system serving each MHS Adinox ADI LT 200 modulating boiler at Oakham Primary School in Dudley in the West Midlands. The existing cast iron boilers were removed by the contractor during the School summer shut-down, working on a tight program the MHS high efficiency boilers were installed followed by the installation of our flue system. All of the plant was commissioned in time for the return of the pupils to enter a new begging. The flue system installed was designed to completely evacuate the products combustion taking into account for the over-pressure from each appliance. Each primary flue incorporated a volume control damper and draft regulator in the event of unstable operation. The complete system had a 30 fall back to the appliance to allow condense to vacate and drain from the flue. Airtherm Engineering Ltd only uses branded products which are synonymous with the highest quality - and it is this reputation that enables specifiers and contractors to use our versatile product range with total confidence We can provide technical solutions for the specialist areas of high temperature exhaust systems, serving generators & combined heat and powder units, fan assisted, flue dilution and atmospheric applications. MHS ADI LT Boilers
Header System with 30 incline
• Boilers: MHS
• Model: ADI LT 200
• Application: Chimney / Flue system
• Operating mode: Wet
• Pressure: Negative / positive pressure
• Working pressure: 200 Pa (product will operate 1000pa max)
• Inner wall: 316L1.4404/1.457 thickness 0,6 mm
• Outer wall: 304/ 1.4301 thickness 0,5
• Insulation: 30mm thick Rockwool insulation
• Sealant : Tri-lip 'o' type silicone ring
• Fuel type: Gas
• Other Application Dinak Flues can be used:
• Condensing boilers
• Atmospheric gas-fired boilers
• Gas blown boilers
• Industrial ovens, large-scale establishments
• Wood-fired stoves
0844 809 2509 | airtherm.co.uk | [email protected]
Product Solution
Airtherm Masterflue
Contact Details:
Airtherm Engineering Ltd
Ventilation House
Pedmore
Stoubridge
West Midlands
DY9 0DS
Tel: 0844 8092509
Fax: 01562 887312
Primary Flues