Care and Maintenance Square Bowl Sink SNK1442 · Stainless Steel cleaners Abrasive cream cleaners...
2
Stainless Steel cleaners Abrasive cream cleaners Chlorine or Bleach Acid Alkali Caustic Washing Up Liquid Square Bowl Sink SNK1442 HD815030 Care and Maintenance Do not use abrasive cleaning products as these may scratch the surface of the sink Do not drop heavy objects onto the sink Do not cut on or drag objects across the sink
Transcript of Care and Maintenance Square Bowl Sink SNK1442 · Stainless Steel cleaners Abrasive cream cleaners...
StainlessSteel
cleaners
Abrasivecream
cleaners
Chlorineor
Bleach
AcidAlkali
Caustic
WashingUp Liquid
Square Bowl Sink SNK1442
HD815030
Care and Maintenance
Do not use abrasive cleaning products as these may scratch the surface of the sink
Do not drop heavy objects onto the sink
Do not cut on or drag objects across the sink
1
2
3
4
8
7
5
6
InstallationMeasure and Cut
Fitting
1
2
3
4
5 6
7
Use the measurements below.
Cut inner line.
Fit the top part of the clips and secure so they bite into the underside of the worktop.Check the sink position before fully tight-ening the clips.Note: Secure clips around the bowl follow-ing the numbering order shown.
Using the dimensions shown, cut out the rebate for the overflow pipe from the underside of the worktop.
Apply sealant to the cut edges, then wipe around the cut out surface edge.
WARNING: SHARP EDGES
Back Edge
Fit the seal or for a more flush finish exclude the seal and use silicone.Fit the bowl to the worktop making sure the sealer strip around the edge (if fitted) is correctly positioned. Fit the overflow back box.
5mm
485mm
435mm
R83
x8
220mm 220mm
40mm
Top surface of worktop
15mm
20mm
20mm
Split the two clip sections, then fit the lower part to the fixing plates on the bowl.
Silicone
